Question about Cars & Trucks

1 Answer

07 honda accord factory fog lights won't work. I've narrowed it down to a fuse. Whenever push the button for the fog lights "bam!", it blows a fuse. I've tried about 5 fuses now and no luck. I've traced the wires and no cuts or abrasions which would allow it to ground out. Please help!

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,287 Answers

Hi Josh,

It sounds like you've got a short in there somewhere, for sure.

Since you've traced back and found nothing - I'd try disconnecting the lamps from the wiring harness and see if it blow again. If it doesn't - then it is a bulb or lamp assembly issue. If it continues to blow the fuse - you're going to need to keep tracing back further.

Posted on May 07, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

tripletauto
  • 1450 Answers

SOURCE: hhr fog lights

yes it is you will probably have to have the bcm programmed for the foglight option if your gonna install like factory is

Posted on Sep 22, 2008

  • 512 Answers

SOURCE: Fog lights

check fuse #7 in the fuse block inside the vehicle and fuse #25 in the fuse block under the hood...more than likely you blew one of these fuses when it sparked. as for the drivers side being inop once you replace the blown fuse if you have a test light check for voltage at the bulb connector...the light assembly itself may be bad

Posted on Sep 28, 2008

emissionwiz
  • 75814 Answers

SOURCE: 1996 honda accord no turn signal

Check the wiring in the front and back to lights for shorts to ground, if nothing is found replace the turn signal switch, be careful to disarm the airbag before doing any work on the column as the steering wheel must be pulled to replace the turn switch.

Posted on Oct 07, 2008

polarcycle
  • 1392 Answers

SOURCE: car brake lights won t turn off when car is shut down 1996 Honda Odyssey

It should be your brake light switch. There is a little plate welded to the arm of the pedal that has a hole with a rubber stopper. The rubber stopper is most likely missing, or damaged. You should be able to take a flashlight and see the plate and the switch. If the hole is plugged up, you will need the brake light switch, if not, replace the plug.

Posted on Jun 02, 2009

  • 1810 Answers

SOURCE: 95 Honda Accord, fuse keeps blowing and no dash lights

sounds like a short
look at wires under dash
then look at te wires coming through the fire wall
check lighter too it might have a coin stuck in it as it will cause a short too

Posted on Jan 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

MY 2006 HONDA ACCORD KEEPS BLOWING THE RADIO FUSE


There's either a short in your radio or something is grounding out the circuit. To narrow down the problem, remove the radio and disconnect the plugs in the back of it. If the fuse blows while it's unplugged, you have a short somewhere else in the wiring. If it doesn't blow the fuse, your radio is the problem.

Feb 05, 2015 | 2006 Honda Accord

1 Answer

Honda Accord keeps blowing fuse and won't start


Recently we had to put a new fuse in the starter ???????????? What fuse ? location , size . A fuse blowing means a electrical short to ground .

May 29, 2017 | 1998 Honda Accord

1 Answer

I have a 2002 honda accord when I push on the brake padel my turn signals or my 4 way flashers won't work. When I put on my lights my turn signals or my 4 way flashers won't work. Could you please...


Hi,
First check the fuse in the fuse box for signal light, replace the fuse with similar value if it is busted. If the fuse is still intact the problem would be the flasher relay( small cylindrical aluminum ) that is already malfunctioning.

Hope that helps you out!

Aug 07, 2011 | 2002 Honda Accord

2 Answers

2005 Honda Accord, all three passenger power windows stopped working. The drivers window works and the window lock is not on. When I try the switch on each of the passenger windows i cvan hear a clicking...


you most likely have a power/ground/switch issue in the drivers door. the power for the other three doors must first travel through the switches in the driver door before it goes to the passengers. hence the reason why when somebody rolls down a passenger window and you push the up button on the driver door the window stops moving. the wires can break inside the rubber boot in the door jam. you can also have an internal problem with the driver door switch unit. you would need a wiring diagram to diagnose this concern.

Mar 23, 2010 | 2005 Honda Accord

1 Answer

Four Wheel drive not working. Blows fuses.


Hi:
Your four wheel drive push button system has only 3 components, so there is a way to narrow down what is blowing the fuse:

the system includes the push button panel and indicator light, the shift control module, and the shift control motor.

The shift control motor is the only part that can draw enough current to blow the fuse. If for some reason the transfer case is jambed up, that could blow the fuse too...So if you are planning on attempting repair yourself:

first, unplug the connector off of the shift control motor, and see if the fuse still blows.. if not, then remove the shift control motor from the side of the transfer case and plug it back in to the harness and see if the fuse blows. If so, then the shift control motor is bad, if the fuse doesnt blow then you need to check out your transfer case.

Dec 08, 2009 | 2000 Chevrolet Blazer

2 Answers

# How to Turn Off the Maintenance Required Light on a Honda Accord (1998, 1999, 2000, 2001) How to Turn Off the Maintenance Required Light on a Honda Accord


Use a narrow object(like tip of a pen) and push the 'red' build-in button around the instrument panel and the button will turn back to green and the maintenance required light will go off.

Jul 07, 2009 | 1997 Honda Accord

2 Answers

1998 Honda Accord


do your car have factory radio if not you got to see the wires

Feb 08, 2009 | 2000 Honda Accord

1 Answer

Alternator fuse blows


Kevin, chances are that when the new alternator was put on. The wires were put too close to something either hot or that it can rub on. If you do not find that this is the problem then return the alternator to the store and have it tested for internal problems. Bad Alternator can do this. Good luck

Jan 03, 2009 | 1996 Honda Accord

2 Answers

Hhr fog lights


yes it is you will probably have to have the bcm programmed for the foglight option if your gonna install like factory is

Sep 22, 2008 | 2007 Chevrolet HHR Special Edition

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...