Question about 1998 Chrysler Sebring

2 Answers

Would an O2 sensor make your car stall?

I was just wondering if a bad O2 sensor would make the car stall when you stop at stop lights?

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 29 Answers

Probably not... sounds more like idle air control or EGR valve sticking or maybe as simple as fuel filter

Posted on May 06, 2014

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 16,010 Answers

Not usually, but O2 sensors have about 60 to 70 thousand mile life spans

Posted on May 06, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

After running with bad o2 sencor for 2 days, starts stalling and idling bad why does my car run badly after new extractors and o2 sencor?


Find out why the light is on. Maybe you broke or dislodged a connector when you replaced the sensor.

Jun 02, 2017 | 1991 Toyota Cressida

2 Answers

GMC 2500 Sierra keeps stalling


you check the gas filter when you have a bad one its run to a point the gas cant go throgh its stalls pump stop gas go back and start over again pressure push the dirt again let me no pierre

Aug 01, 2008 | GMC Sierra 2500 Cars & Trucks

1 Answer

2001 Pontiac Grand Am SE O2 Sensor


Its not the O2 sensors, or the coolant sensor or the thermostat. Get the codes read front the computer. Post those codes here before you spend any more money or install the other parts.

Aug 10, 2012 | Pontiac Grand Am Cars & Trucks

1 Answer

Buick Riviera stalling when stopped.


rewplace the O2 sensor have auotzone run dianostic test it is free.

Jan 19, 2012 | 1989 Buick Riviera

2 Answers

Check engine light low voltage o2 sensor 04 chevy ventura


your code must be P0131, a P0131 code refers to the first oxygen sensor on Bank 1. P0131 means the O2 oxygen sensor's voltage remained low for longer than 2 minutes. This is interpreted by the ECM as a low voltage condition and sets the MIL. Bank 1 Sensor 1 is located in front of the catalytic converter.
The solution is you can:
1.Replace faulty sensor.
2.Repair short, open, or high resistance on o2 signal circuit. FB.init("dd7d9e9681341cde77587bc6a2029f6f"); OBD-Codes.com on Facebook

Jul 02, 2011 | 2004 Chevrolet Venture Passanger

2 Answers

Stalling after vehicle is warmed up


throttle position sensor , or mass air flow sensor.

Jul 12, 2010 | 1992 Chevrolet Caprice

1 Answer

I have a problem with my ford idleing, it stalls sometimes at street lights. o2 sensor? where is it, how can i find it?


Depending on the engine in your explorer you may have 2,3 or 4 o2 sensors. these sensors are located screwed into the exhaust system, one before and one after the cat converter, if the truck has two converters then there will be 4 sensors. the problem you listed is that it stalls at idle or stop lights, this sounds alot like a bad idle air control valve which is very common on fords,also try cleaning the throtlebody, use cleaner and a tooth bruch open the throtle plate and clean good, if this doesnt help then i would look at the idle control valve. hope this helps.

Jun 29, 2010 | 2001 Ford Explorer Sport

1 Answer

I got error code for bad o2 sensor. and MAF sensor


you're looking at this the wrong way, i suspect you have an engine problem, do a compression and leak down test, also look for a vacuum leak after the maf sensor

May 28, 2010 | 1998 Ford Escort

2 Answers

2003 dodge ram 5.7L intermittently has a rough idle and an idle rpm of 500 I think the normal is 650. When I put it in gear the idle picks up and smooths out. Sometimes it will do this in gear and stall...


okay, the o2 code can cause problems, theres a problem with one of the o2 sensors, theres 2 or 4 sensors,the repair was not done right or theres another bad o2 sensor, next thing i would check is the idle air control motor,this sounds like it sticks at time or just stops working,start with these things first,

May 19, 2010 | 2004 Dodge Ram 1500

1 Answer

Codes say O2 problems even after both have been changed


The code says there is a problem, it does not say where in the circuit the problem is, it could be the wiring to the sensors, it could be the PCM (powertrain control module) in your case it sounds like an intake manifold vacuum leak.

Oct 23, 2008 | 1995 Dodge Stratus

Not finding what you are looking for?
1998 Chrysler Sebring Logo

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...