Question about 1998 Isuzu Amigo

1 Answer

While driving my 1998 isuzu amigo 2.2 liter all my guages failed to the left and car keep running is that an alternator issue or a battery issue?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 24 Answers

It is neither an alternator or battery issue. Check for a blown 'dash" fuse. If not that then check for a loose connector on the back of the dash.

Posted on May 06, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 1998 amigo timing 2.2 liter

The timing marks on the cam shaft sprockets are easily to see when you get the timing cover off. When the two cam shafts are lined up (pretty much at the top), then the crank should be almost down at the bottom.
Get yourself a good shop repair manual - I got mine from E-Bay for less than $15.00 (used).
Also, if your going to change the timing belt, have the water pump replaces at the same time.

Posted on Dec 28, 2008

tepfy
  • 319 Answers

SOURCE: My 1998 Isuzu Rodeo won't idle it just dies. if i keep it revved it will run fine.

replace your idle air intake sensor.

tepfy

Posted on May 03, 2009

  • 52 Answers

SOURCE: Adding freon to 98 Isuzu Amigo

You need to add the freon on the low side which is usually indicated by a blue cap. The red cap is the high side port. Never add freon using the high side port. Typically if you are buying a guage set from your local auto parts store, it will only attach to the low side service port because they are diffent types of connections. Another easy way to tell is to turn your AC on and feel the lines that the ports are attached to. The low side should be cold/cool and the high side will be hot.

Posted on Jun 28, 2009

  • 1 Answer

SOURCE: how to replace starter on 1998 isuzu amigo 2wd

lardon01952 What a FRICKIN Idiotic Answer...

Your answer to the question of Life??!!
Let me guess.
How to *LIVE*:-

Breath IN
Breath OUT.
Eat, ****, Sleep, bathe every once in a while.
Repeat.

Posted on Apr 02, 2010

lacroixx1
  • 101 Answers

SOURCE: 1998 isuzu amigo 2.2l 5 spd 4 cyl .\r\ni need to

900 rpm

Posted on Jun 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

98 isuzu amigo 2.2L 5sp 2wd new NGK plugs & wires, fuel assembly, rail test, code -cam pos sensor?? still bucks, lurches, can't get 2 4,000 rpm 2 reset pcm, WTF?? 120,000 odo. Help us pls sir.


2.2L gas 2.2-liter petrol (X22SE)
or 2.2L
2.2L (X22se/D) Engine???
there are 3 engines

i cant guess engines yet, "Carnac the mag." is off line.
all i can tell from above is engine misfires.
when did it last run ok,, last week , last year, or found car in a barn.
history matters.
why not connect any $10 to $100 scan tool and scan it
running,,, it will infact ,tell you things, errors,called, DTC errors.
and is key to any diagnose of any modern engine in USA>.
even in canada the tool works starting in 1998.

is cam belt fresh? and timed correctly?
AMIGO, 2.2L (1 of 3)

first learn what under the hood.

please post what 2.2L is there. and fuel type.
gas, diesel ,petrol, ect

Mar 15, 2016 | 1998 Isuzu Amigo

1 Answer

Coolant temp sensor location on 1998 Isuzu Amigo 2.2L 4X4.


Go in on utube and ask the question Where is the 1998 Isuzu amigo coolant temp sensor located good luck

Oct 22, 2014 | 1998 Isuzu Amigo

1 Answer

1998 Isuzu amigo p1627 code


fuel sending unit is malfunctioning. check wire conectors and grounds from gas tank. if they are fine then you need a new sending unit. you may notice the fuel guage doesn't work properly

Mar 14, 2013 | Isuzu Cars & Trucks

1 Answer

Headlights and heater cant be on at same time.


have your battery and alternator checked at parts store sounds like low voltage be sure battery terminals are clean and tight

Feb 26, 2011 | 1998 Isuzu Amigo

1 Answer

How to change the alternator on a 1991 amigo


Here are some steps that you need to do.
  • Disconnect battery ground cable at battery.
  • Remove drive belt.
  • Disconnect alternator electrical connector.
  • Disconnect battery positive cable nut on alternator.
  • Remove alternator
  • Put the new alternator
  • Connect the positive cable nut and electrical connector
  • Connect the battery ground cable
  • Start the car then check if its giving enough charge to your battery

Jan 02, 2011 | 1991 Isuzu Amigo

1 Answer

How do I operate the four wheel drive on my 1998 isuzu amigo


There should be a push button on the dash panel, just left of the steering column

Nov 29, 2010 | 1998 Isuzu Amigo

1 Answer

2000 V-6 Isuzu Amigo recent new battery recent new alternator new fan belt new pulley great for 6mos, now doesn't start...no lights, nothing


have your battery tested and charged/replaced as neccessary. test your charging system for 13.5- 14.7 volts. i know they are fairly new but electrical componenets can fail in half a second. dont rely on them being new. check them anyways.

Dec 28, 2009 | 2000 Isuzu Amigo

2 Answers

How to replace starter on 1998 isuzu amigo 2wd 4cyl


Removal
1. Battery ground cable.
2. Remove harness connectors
3. Remove bolts from starter.
Installation
1. Install starter assembly.
2. Install mounting bolts and tighten bolts to specified
torque
Torque: 25 N·m (18 lb ft)
3. Connect harness.
4. Reconnect the battery ground cable

Jul 02, 2009 | 1998 Isuzu Amigo

1 Answer

Isuzu Amigo 1998 charge light has come on., is it a belt or alternator?


you can check and see the belt if its on or off.If its still on and tight Check out altinator.

Jun 11, 2009 | 1999 Isuzu Amigo

2 Answers

Shifting to four wheel drive.


If the Amigo is like other fwd setups,you should be able to pull the floor shifter back one notch for fwd in the standard(or high)driving range.I don't know if you can shift "on the fly" with the Amigo,so I would shift it to 4x4 while stopped in nuetral. When you pull the shifter to the left(towards the driver)and all the way back,that should be 4x4 in the low range(for speeds under 20 mph only). I would not recomend that you drive you vehicle on the highway in low range....The button on the dash may actually be a light to let you know when you are using the fwd. Make sure you kick it back to 2wd when you return on dry pavement.Any Isuzu dealers' service department can also help you on the matter. Good Luck!

Dec 19, 2008 | 1989 Isuzu Amigo

Not finding what you are looking for?
1998 Isuzu Amigo Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...