Question about 2004 Hyundai XG350

Open Question

2004 hyundia xg350 p1707

What is this code ?

Posted by Anonymous on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 5370 Answers

SOURCE: Put key in ignition of

Spray wd-40 near the key and ignition hole. Spray this liquid in bit more quantity.Let it remain there for 10 minutes then try to wiggle the key and turn the key in ignition.If its still not turning out.Again spray wd-40 and see after 10 minutes then again check.If still its not turning out.Move the steering wheel as much as you can,towards left and towards right then try turning the key in ignition to start. Turn the wheel slightly either left or right until the key turns.If the steering wheel is hard to move towards left or right dont force.---------But if nothing is helping then the problem is Ignition cylinder.Its got locked and blocked internally.It has to be replaced.If you want to same key then you will have to get this key programmed by the car dealer .Other wise you will have to buy another keys for this ignition cylinder.-------- In some cases the key sensor in the ignition cylinder gets faulty .removing the key sensor mechanism from the lock cylinder. It is under a small metal cover, under a 2 wire connector on the lock cylinder. The mechanism under the cover looks just like a lock tumbler from a keyed lock and a small spring. The mechanism is supposed to be pushed up by the key and press a small button switch on the connector which tells the car that the key is in the ignition which enables the dinger when you open the door and the key is still in the ignition, however, the darn thing gets stuck and locks up the cylinder solid! If you can turn the key the fix is pretty simple. Remove the cowl, put the key in, turn to accessory, press the little button on the left, pull out the cylinder, pull of the connector, yank out the little metal cover and remove the spring and metal piece. The only caveat is that the bell will not ding when you leave the key in. You COULD tape the little button down and it will always ding if you want to.---------- But if the ignition cylinder is faulty then it has to be replaced.----------- This will help.Thanks.Helpmech.

Posted on Feb 02, 2011

  • 205 Answers

SOURCE: have a 2004 hyundia xg350.hooked

Cylinder #6 is on the left bank of the engine at the rear. The front would be where the belts are.

zeppelinx12.jpg

Posted on Feb 21, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

04 Hyundai XG350 said codes say catalytic converter bank 2 he's getting other codes makes him think it's the throttle body should I be worried my cars been there for 10 hours and still doesn't know.


I would worry if this mechanic know what her or she is doing. I don't have much training in automotive repair but I can usually decipher what codes mean. I think this mechanic is either not know what doing or ripping you off.

Feb 24, 2017 | 2004 Hyundai XG350

1 Answer

My xg350 hynudai 2004 wont accept gas


What fault codes show up on a scan?

Jan 23, 2017 | 2004 Hyundai XG350

1 Answer

2004 Hyundai xg350. Wipers quit working. What steps do i take to see if its a motor or fuse etc.?


Search Results

    02 XG350 air, sunroof, seat warmers, and intermittent wipers quit ...

    www.hyundai-forums.com/.../149142-02-xg350-air-sunroof-seat-warme...

    Sep 27, 2012 - 9 posts - ‎5 authors
    An automotive shop pulled up the car and said their was a fuse box with a lot of relays in it on the passenger compartment .... 2004 XG350L .... Same thing happened to me, 2002 XG350, sunroof, blower, vanity light all out.

    Hyundai XG350 wipers not working Questions & Answers ...

    www.fixya.com > ... > wipers not working > Cars & Trucks > Hyundai
    Hyundai XG350 cars & trucks wipers not working questions and answers. Ask your Hyundai wipers not working related question. ... 2004 Hyundai XG350.

    Hyundai wipers not working Questions & Answers - Fixya

Dec 03, 2015 | Hyundai Cars & Trucks

1 Answer

2002 XG 350. License plate bulb out. How do I pull bulb, wiring is too tight. Thanks Joe B


2002 HYUNDIA XL 350, LIC. PLATE BLUBS CAN NOT GET ASSEMBLY DOWN TO REPLACE BLUBS, DUE TO THE FACT THE WIRES ARE TOO SHORT TO PULL UNIT DOWN. ANYH IDEAS?

Oct 30, 2009 | 2002 Hyundai XG350

2 Answers

What type transmission fluid should be used in an 04 GX350 Hyundia?


GENUINE HYUNDAI transaxle oil, GENUINE DIAMOND ATF SP-III or SK ATF 3 for automatic trans

Dec 05, 2008 | 2004 Hyundai XG350

Not finding what you are looking for?
2004 Hyundai XG350 Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...