Question about Cars & Trucks

1 Answer

I have no mid idle on js130 - Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 76,673 Answers

What is a JS130.

Posted on May 06, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you change high idle on a 1998 2.2 Chevy s10


You can't change it, it is controlled by the ECM via the Idle Air Control valve. Its a small solenoid type part that is screwed into the throttle body about mid way. It opens/closes by command to allow more or less air into the system to raise and lower the idle. If its stuck open, you will idle too high, closed is too low. I have replaced a lot of these over the years, carbon builds on them, they get hot/cold a lot, and they do fail. If you need to replace it, you likely will just install it, plug it up, then drive at 35mph or more for a few minutes to allow it to calibrate itself. Good Luck !

Jan 03, 2017 | 1998 Chevrolet S-10 Pickup

1 Answer

Rough Idling on stand still?


Most Likely you have a vacuum leak. (hole or broken Hose). For a 2011 it is probably to early for the Valve cover gaskets to be leaking, but that is a possible cause. The older the car the more likely this is the case. Can also be caused by using less than premium fuel. Don't skimp and use mid grade and definitely NOT regular. Also could be the idle control valve.

Jun 01, 2015 | 2011 BMW 3 Series 328i

2 Answers

My buick is idling high what should i do


If the idle speed is VERY high (over 1000 rpm), check for broken vacuum hoses first, then check the EGR. Sometimes the EGR sensor assembly plastic becomes brittle and breaks, leaving a wide open hole into the intake.
Sadly, a common problem with these mid-90s Buicks is a cracked intake manifold. Did the car overheat recently? If so, have the intake manifold checked for a crack.

Apr 12, 2014 | 1994 Buick Century

2 Answers

Car runs great except it has a rattle in the mid range ?


this may be detonation from incorrect air/fuel /timing combination. IT is generally lean mixture and mostly can be heard on acceleration. Run fault codes to find faulty sensor that is affecting the correct air fuel mixture.

Mar 20, 2014 | 1999 Saturn SL

2 Answers

Its idling rough


Hi.

Check idle air control system (valve, hoses and wires). Check air intake and check the sensors installed in the air intake. Check vacuum for leaks.

Those listed are the most common faults causing fast idle in this type of engine.

Regards.

Ginko

Dec 15, 2011 | 2002 Mitsubishi Lancer

1 Answer

Spark knocks when taking off from idling/starts to miss after sitting at idle


The 2 most common causes of spark knock are #1 ignition timing too high, and #2 Low octane fuel. Check your ignition timing, and try a mid grade 89 octane or 91 octane fuel, or you could use an octane booster in your fuel. Good Luck! I hope you find this to be very helpful!

Feb 10, 2010 | 1999 Ford Econoline

2 Answers

Rough idle loss of power in mid to high rpm


Changed fuel filter lately? Fuel pressure tested? When was last tune-up? Check for plugged exhaust too. (catalytic converter)

Jun 19, 2009 | 1991 Chevrolet S-10

2 Answers

My 2000 crown vics engine runs rough in park at mid throttle,and drives like i am on a bumpy road at mid throttle,replaced shocks, tires, balancing,alignment. please help


I suggest you look at or have the engine looked at, for air intake obstructions, engine mount problems, or possiblt drive shaft/u-joint problems. Those are my best guesses for your problem description. Good luck!

Sep 14, 2008 | 2005 Ford Crown Victoria

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...