Question about Cars & Trucks

1 Answer

1998 dodge ram 3500 van changed plugs now fuel pump wont kick on is there something i might have done

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Check fuses to see if possibly fuel pump fuse blown could be bad relay maybe wiring plug seperated

Posted on Jun 25, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

mechanicm639
  • 253 Answers

SOURCE: 1999 dodge ram 3500 cummings turbo diesel will not start.

Diesel engines fire on compression alone (usually 400psi).The Truck may have air trapped in the fuel system.When you perform any fuel system repair on a diesel it is going to take alot of cranking to get the air out. You can take the breather loose and shoot a VERY small amount of starter fluid in the intake and it should start. Do not use starting fluid much as it can damage the engine. Good Luck.

Posted on May 06, 2009

galdieri46
  • 7 Answers

SOURCE: 1998 Dodge Durango Turns over but wont start

could be Fuel Injectors, are bad ?
all you need is # 1 Fuel Injector, to go out that will not get Fire, and Fuel Mixture to Spark Plug.

Posted on Jun 03, 2009

  • 636 Answers

SOURCE: 2001Dodge ram van 3500 will not start

have you looked to see if the fuel pump is running?

Posted on Sep 07, 2009

bschilz
  • 2049 Answers

SOURCE: how to change fuel pump on dodge ram 1500 1998

You have to drop the gas tank just 2 bolts holding the bands. The fuel pump and gas gauge are a single unit which pops right in. Not a bad job at all, just be sure to use some kind of jack on the tank.
NAPA sells the pump/guage unit for about $240.00

Posted on Oct 25, 2009

  • 98 Answers

SOURCE: 1998 dodge ram 5.2. Code 1682 fuel pump relay

its in the power distribution box under the hood. It is relay #3

Posted on Nov 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Drove van,parked, then it would crank but not start? I check the power to fuel pump, none. no power to injectors either I've change relays, sensors and power control module and still nothing, please h


Check your owners manual for a fuel shut off button/reset, normally found somewhere in the back interior of the van near the gas tank fill. If you still don't get power, try checking your fuses, make sure you check for two fuse panels....one maybe under the hood and one under the dash. Check them using a lighted probe on both sides of the fuse. Also Google 1994 dodge ram 3500 wiring diagram, much found when I did it! I hope this helps!

Sep 07, 2014 | 1994 Dodge Ram 3500

1 Answer

Installed new fuel pump on 1997 dodge ram van still not working why?


always check your fuel filter first they usually go before the pump does

Dec 08, 2012 | 1997 Dodge Ram

1 Answer

1998 Dodge Caravan. engine dies and wont start. fuel pump was changed twice but i get a few miles & dies again & wont start. im thinkin fuel filter is plugged....


It might be your fuel filter. Also, Dodge and Chrysler is bad for fuel pump failures. A clogged fuel filter can cause this. Also, you might not be getting enough fuel pressure. There should be a test port on the van, where you can test the gas pressure. You also have a fuel pump relay or switch. This could be bad as well. Hope this helps you.

Jan 08, 2011 | 1998 Dodge Caravan

1 Answer

P1281 on a 2000 dodge 3500 van I have replaced the fuel pump crank sensor plugs wires cap rotor running out of $$$$ fast


My resources say P1281 is engine is cold too long. That would lead me to possibilty of faulty thermostat, or something else in cooling system. What exactly are you getting for symptoms? No start, poor starting, poor running, ?

Nov 28, 2009 | 2000 Dodge Ram 3500

2 Answers

Change the iac on a dodge ram b3500 van and still have the p0505


the idle air control is on the back of the throttle body. it has a plug going to it and is held to the throttle body with 2 screws

Oct 08, 2009 | 2000 Dodge Ram 3500

2 Answers

2001Dodge ram van 3500 will not start


have you looked to see if the fuel pump is running?

Sep 07, 2009 | 1999 Dodge Ram

1 Answer

Check engine light is on my 1998 ram van 3500


Bring it to a parts store, most will scan for engine trouble codes for free. They will plug a hand held scan tool into the vans diagnostic port (under the dash) and 'read' codes stored in the van's computer. They can tell you what the codes mean, and suggest how to fix it. If you have any further questions at that time, post them here with the code #'s. Good luck. Curt

Apr 28, 2009 | 1998 Dodge Ram 3500 2WD

3 Answers

1998 dodge ram 318 motor wont start


have you checked the crankshaft sensor?

Jan 04, 2009 | 1998 Dodge Ram 1500 4WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...