Question about Cars & Trucks

Open Question

Adjust headlights 2008 Chevy HHR - Cars & Trucks

Posted by Anonymous on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3230 Answers

SOURCE: Change headlight on 2008 Chevy Malibu

Hi there,

Well first you can please follow the below steps -
1. Make sure the ignition key is in the off position and the headlight switch is off. Release the hood latch.
2. Open the hood and locate the top of the headlight assembly where you intend to change the headlight. If a plastic shroud is present, locate the center bolt and remove it with a ratchet and a socket. Lift the shroud out of the way to access the headlight assembly retaining brackets. Some later models may feature a snap-release shroud requiring no tools to remove.
3. Locate the brackets on the top rear of each side of the headlight assembly. Lift them all the way up to align the hole on the bottom of each bracket to the retaining tabs on the assembly.
4. Pull the assembly forward away from the Malibu, but be careful not to scratch the bumper. There are three guide pins that require unseating. The guide pins are what aim the headlights and it may take some wiggling to get the pins from their seats.
5. Support the assembly with one hand and then reach behind the unit with the other. The low beam bulb is on the outside, the high beam bulb is on the inside. You can also replace the parking light if desired. Locate the wire harness connection. Un-clip the wire harness from the back of the bulb socket. Remove the bulb by turning it counterclockwise 1/3 of a turn to align the release tabs of the ring and the assembly. Wiggle the bulb out of the assembly.
6. Place the latex gloves on your hands before opening the package of the replacement bulb. Oil in our skin can damage the glass bulbs of halogen headlights.
7. Carefully insert the new bulb into the ring and then align the tabs of the ring to the tabs of the headlight assembly. Push inward and then twist clockwise 1/3 of a turn to lock the bulb in place. Reattach the wire harness. Rest the headlight assembly inside its cavity and test the operation of the headlight before securing the headlight assembly in place. Be sure to turn the lights and ignition back off.
8. Align the three guide pins to their seats and push the assembly back into them gently until they snap into place. Replace the retaining brackets by pushing them downward to lock into place. Replace shroud, if applicable. Remove the tools and old bulb and close the hood. Post comments for further help or information......

Good Luck!!

Posted on Mar 27, 2010

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the ambient temperature sensor located ?


images for 2008 Chevrolet HHR LT Where is the .

Outside Temperature Sensor - Chevy HHR Network

www.chevyhhr.net/forums/...hhr-4/outside-temperature-sensor-30594/
Jul 9, 2010 - I had the outside temp sensor go on my 99 Buick. I don't know where it islocated on the HHR, but it was just a plug in sensor. Take out the old, stick in the new.... 2008 HHR LS 2.2 L Auto Built: 12-19-2007. Bought: 4-26-2009 Location of the ambient engine temperature sensor.... Help ...
Mar 26, 2013
Engine Temperature Sensor
Oct 6, 2011
Outside Temp Display
Dec 19, 2008
Outside air temperature problem
Oct 30, 2007
More results from www.chevyhhr.net

Jan 25, 2016 | 2008 Chevrolet Chevrolet HHR LT

1 Answer

Inter fuse box chevy hhr where is cig fuse


[PDF]2008 Chevrolet HHR Owner Manual

https://www.chevrolet.com/.../Chevrolet/.../2008_chevrolet_hhr_lt...Chevrolet1. 2008 Chevrolet HHR Owner Manual M ... box with the word CAUTION is used to tell about things ...... seatback and the interior body, leaving only the loop.
images for Inter fuse box chevy hhr

Oct 19, 2015 | Cars & Trucks

2 Answers

How to remove and replace headlight bulbs in a 2008 chevy.HHR


The trick to replacing all new bulbs on cars now it removing the whole lens. There will be a couple of screws holding it in when looking from above in the engine compartment. Once you loosen the screws it is not as if it comes out easily. It will take a little extra oomph to get it out. once out it goes back in very easily. When the lens is out you can access the bulb very easily.

Jan 22, 2015 | 2008 Chevrolet Hhr

1 Answer

How do you access the headlights on a 2008 chevy hhr I need to change them.


Most Chevy headlights are held in place by three 10 mm bolts...as you remove all 3, you can lift the headlight assembly forward and expose the headlight bulbs...be sure to use bulb lubricant when installing the new bulbs, also wear gloves so you do not touch (harmful hand grease) the new bulb filaments...our normal hand grease can cause shorter bulb life. Hope this helps.

Apr 06, 2012 | 2007 Chevrolet HHR Panel LT New Cars

2 Answers

2008 hhr ls can't get to drivers side headlight bulb to change Please help?


This video will show you how to replace the headlight and also the bulb in the headlight of your HHR">

May 20, 2010 | 2008 Chevrolet Hhr

1 Answer

I own a chevy hhr 2008,this morning im getting


please make sure the vehicle is fully in park, turn the key forward to on and try removing it, while depressing the brake pedal

Jul 18, 2009 | 2008 Chevrolet Hhr

1 Answer

How do i fix 2006 chevy hhr headlight


Access to change the headlamp bulbs is through the wheel well. The recommended method is to remove the front tire and then the plastic inner fender liner. Once removed, you'll have easy (more or less) access to the rear of the headlamp housing.

Jun 24, 2009 | 2008 Chevrolet Hhr

2 Answers

2008 HHr headlights aimed too high.


there should be some screws at the back of the headlights where they go in u would have to adjust those

May 27, 2009 | 2008 Chevrolet Hhr

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...