Question about Cars & Trucks
Now try looking at starter &/or solenoid or t/s wiring for short or open in battery cables
Posted on May 06, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: spark plugs
the spark plugs are under the little black cover in the center of the engin you have to remove the air intake to get to them but not too complex
hope this helps
Posted on Sep 22, 2008
SOURCE: 1999 kia sportage timing marks
Crankshaft match marks
Align marks on timing belt pulley and pump body.
Camshaft pulley alignment marks
Posted on Jul 26, 2009
They are under the black plastic cover that is in the middle of your valve cover gasket. Remove the intake hose from the aluminum intake plenum on top of the valve cover and the silencer box against the firewall. Remove all the connectors from the sensors which should be 2 on the plenum and the 2 large vacuum hoses on the plenum. Then remove the 3 12mm bolts from the plenum at the throttle body and remove the plenum. You can reuse the throttle body gasket at the plenum so don't destroy it. All the other bolts are 10mm and use a screwdriver to loosen the clamps on the hose. The sensors have clips that you need to remove with a small screwdriver, then disconnect them. Remove the bolts on the cover and the cover. Then remove the bolts holding the coil packs down. Do one plug at a time. 2 of them are connected to the 2 plug wires and 2 are underneath the 2 coil packs. The connectors on the coil packs are fragile so remove them carefully. Reverse the steps to reinstall the plenum, etc.
Posted on May 20, 2010
You will have to remove the in-take, not that bad of a job, about 8 bolts hold the in-take, remove bolts and throttle body, lift up on in-take to remove spark plugs.
Posted on Aug 17, 2010
Tips for a great answer:
Jun 06, 2015 | 1998 Kia Sportage
Apr 06, 2013 | 1999 Kia Sportage
Mar 12, 2017 | 1999 Kia Sportage
Aug 27, 2011 | 1999 Kia Sportage
Keep a regular schedule for inspecting the spark plugs on your 2002 Kia Sportage. According to the official 2002 Kia Sportage owner's manual, spark plugs and ignition wires should be inspected every two years or 48,000 miles, whichever comes first.
Let your 2002 Kia Sportage sit for a few hours before opening the engine compartment. You want to make sure that the engine is cool before you begin working on it.
Pop open the hood of your Sportage and locate the ignition wires, which will be attached to the top of your engine. The 2002 Kia Sportage has a four-cylinder engine, meaning there are four spark plugs each attached to an ignition wire. The ignition wires run from the engine to the fuse box, which is located in the left side of the engine compartment.
Inspect the ignition wires of your 2002 Kia Sportage. These wires will need to be replaced if they appear worn.
Disconnect the ignition wire to your spark plugs. Grab the rubber boot located near the base of the wire and pull upward instead of yanking on the wire. Remove only one wire at a time, or mark the wires with a colored Sharpie marker before disconnecting all of them. Improperly reconnecting the ignition wires can seriously affect the performance of your Kia Sportage.
Attach the spark plug socket to your socket wrench. Use the socket wrench to remove the spark plug from the top of the engine's cylinder.
Inspect the spark plug. There will be some soot, but if the spark plug is completely covered in soot, it needs to be replaced.
Position your replacement spark plug in place and secure it with the spark plug socket on your socket wrench. Be careful not to overtighten the spark plug after it has been snuggly fitted.
Position the rubber boot of the proper ignition wire in place above the spark plug and insert it with your hands. Close the hood of your 2002 Kia Sportage
Mar 16, 2011 | 2002 Kia Sportage
Sep 06, 2010 | 1999 Kia Sportage
Apr 07, 2009 | 2000 Kia Sportage
Mar 09, 2009 | 1999 Kia Sportage
13 people viewed this question
Usually answered in minutes!