Question about 2001 Oldsmobile Intrigue

Open Question

Where is the pcs sensor on an olds intrigue 2001

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: where are spark plugs located for a 2001 olds intrigue

they are under the big silver plastic cover on each side of engine

Posted on Jul 26, 2009

  • 1168 Answers

SOURCE: Trying to replace the crankshaft position sensor

Hello suewagner.
The crank sensor is mounted above the starter motor on the firewall side of the engine. The sensor picks up the signal direct off of the crankshaft through a machined hole in the engine block.
I have removed them without dropping the starter but learned that in most cases it is easier to drop the starter down to access it.
Here is a diagram for you.

96819d7.gif

There you are, hope this helps you.
Take care,
KL

Posted on Apr 11, 2010

emissionwiz
  • 75797 Answers

SOURCE: crankshaft sensor location on 2001 oldsmobile

. Its above the starter going into the side of the block. (front side of the engine) Disconnect the battery. Remove the starter. Remove the wIre CONNECTOR plug to the sensor. The sensor has 1 bolt holding it in. Remove the bolt, you may have to wiggle the sensor at the base a bit as you pull it out. Replace, and make sure it is pushed in all of the way. Replace the bolt, wire plug, starter, reconnect the battery.

Posted on Jun 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Trying to find p0131 which is on a 2001 oldsmobile intrigue transmission help me locate?


p0131 refers to low voltage reading on the o2 sensor. Should be the bank 1 which is the o2 sensor closest to engine. Inspect wires and/or replace sensor.

Mar 16, 2011 | 2001 Oldsmobile Intrigue

2 Answers

I have a 2000 Olds intrigue, and am getting error codes P0410 and P0327. What are they telling me and how should I repair them?


P0410 is a code for the EGR Valve. This can be checked by pulling vacuum on the hose attached to it while the engine is running. If the engine struggles when you do, it is working fine. P0327 is a fault on the Knock sensor. More precisely, a low voltage on the Knock Sensor. This is more than likely a severed wire or faulty sensor. I would recommend taking care of the EGR code and see if that cures both issues.

Sep 28, 2010 | 2001 Oldsmobile Intrigue

2 Answers

Where is the crank shft sensor located on a engine 3.5 2001 oldsmobile intrigue


the crank sensor is located just above and behind the starter motor. accesable after removing the starter.

Jul 10, 2010 | 2001 Oldsmobile Intrigue

2 Answers

Ignition problem on 2000 olds intrigue


Are you seeing a check engine light ?

If, so the problem might be with crankshaft position sensor. You may have to get it replaced for $50-60

Jun 02, 2010 | 2000 Oldsmobile Intrigue

1 Answer

Trying to replace the crankshaft position sensor on a 2001 olds intrigue and cannot locate it. Where is it?


Hello suewagner.
The crank sensor is mounted above the starter motor on the firewall side of the engine. The sensor picks up the signal direct off of the crankshaft through a machined hole in the engine block.
I have removed them without dropping the starter but learned that in most cases it is easier to drop the starter down to access it.
Here is a diagram for you.

96819d7.gif

There you are, hope this helps you.
Take care,
KL

Apr 11, 2010 | 2001 Oldsmobile Intrigue

1 Answer

2001 Oldsmobile Intrigue


Knuckle replacement may have damaged wheel speed sensor or wiring.

Mar 01, 2010 | 2001 Oldsmobile Intrigue

1 Answer

My 2001 Olds Intrigue had white smoke coming from tailpipe. When bad fuel injector installed, gasoline poured out the tailpipe and stopped when injector blocked off. Now it "misses" and will not run unless...


these cars have what they call dis system. connected to the computer is an e.s.t. sensor, this controls the injectors an spark going to the plugs. the e.s.t reads a magnetic signal from the camshaft. A bad e.s.t. sensor can cause tons of problems. they are a lot cheaper to replace than injectors.

Jul 13, 2009 | 2001 Oldsmobile Intrigue

1 Answer

Where are spark plugs located for a 2001 olds intrigue


they are under the big silver plastic cover on each side of engine

May 17, 2009 | 2001 Oldsmobile Intrigue

1 Answer

2001 olds intrigue


in each wheel you have a traction control sensor that feeds info to the computer. You may have pinched one of the wires. I also had the same thing happen and found that was the answer.

Oct 05, 2008 | 2000 Oldsmobile Intrigue

Not finding what you are looking for?
2001 Oldsmobile Intrigue Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...