Question about 1999 Chevrolet Silverado 1500

Open Question

98tahoe noise sounds like crunching bearings the noise is loudest @ front output side

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 295 Answers

SOURCE: breaking at slow speed there is a bad bearing o scrunching noise.

Yeah , You are correct. The wheel bearing is very common problem at low speed , like in a parking lot trying to park, I would take to local mechanic to have the vehcile checked out.
The repair is not very hard and no to labor intensive a few hours at most.

Posted on Mar 15, 2009

  • 407 Answers

SOURCE: roaring/whining noise front passengers side/wheel

bad hub bearing

Posted on Apr 29, 2009

  • 10865 Answers

SOURCE: Grinding noise, metal to metal noise in front end

Get your truck up in a rack and take a look at the drive shaft, the differential, the u joints and the ball joints. Regards, joe

Posted on Nov 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Grinding noise in 2001 cavalier 2.2 engine replaced left front hub noise is still there. how difficult to replace left cv joint?


If you still think the noise is coming from the left side CV joint it would be more advisable to replace the entire axle as an assembly. For the time and effort it takes, you can usually get a rebuilt axle assembly for only a few dollars more than the CV joint and the boot required to repair one. You will need a large axle nut socket (usually 30 - 32mm) to remove the axle nut. The lower ball joint and tie rod will need to be separated along with the brake caliper and rotor, from the spindle. I would recheck the grinding noise before doing it. A lot of wheel bearings are mistakenly diagnosed to the wrong side. If the noise is loudest when turning left, most people would assume the left side wheel bearing is at fault. However if the noise is loudest turning left it indicates the right side wheel bearing is most likely at fault. Due to the weight distribution of the front end, turning left the weight all transfers to the right side, loading that bearing. Make sure thats not the case before tackling an axle.

Feb 06, 2011 | 2001 Chevrolet Cavalier

2 Answers

2006 ford explorer has a noise that you would swear it was a L/F wheel brg changed it and noise still the same took the old L/F brg and put it on the R/F still same noise??? any thoughts???


When checking to make sure noise is wheel bearings while driving vehicle at speed the noise is loudest (if possible) turn steering wheel back and forth enough to shift the weight of the vehicle from side to side and if it's a wheel bearing there should be quite a bit of difference in the noise.

If about the same noise check the wear pattern on the tires for flat spots or unusual wear pattern if there is rotate tires. If nothing still found jack up vehicle with all 4 tires of the ground. Use jack stands for this. Get some one in vehicle to run it at speed the noise develops, I use a long screw driver (2 feet long) as a stethoscope to find where noises come from. Try with and without 4 wheel drive if possible. Good luck cause noises can be a real pain in the b____.

Jan 05, 2011 | 2006 Ford Explorer

2 Answers

Front end noise


A suspension part is worn out - lift the front of the car and check the bushings (most likely), the pivots and the ball bearings.

Jan 20, 2010 | 2004 Ford Focus

1 Answer

Transaxle noise at 25mph+ on a 2001 Buick Park Avenue.The noise is similar to a very aggressive treaded tire road noise, loudest at 55mph. Coasting in Neutral at the same speeds has no change in noise....


Try weaving side to side slowly while driving if the noise changes you have a bad wheel bearing. Also you can jack up the front end and check wheel play by placing hands at top and bottom. Hope this helps.

Sep 27, 2009 | 2000 Buick Park Avenue

1 Answer

91 ford explorer making bad noises in the front by the front tire


BY THE SOUNDS OF IT ONE OF YOUR WHEEL BEARINGS HAS GONE BAD. WHAT I WOULD DO IS JACK UP THE FRONT END AND CHECK FOR PLAY IN THE WHEELS MOVE BACK AND FORTH TOP TO BOTTOM SIDE TO SIDE. CHANCES ARE YOU WILL FIND ONE OF THOSE WHEELS HAS ALOT OF PLAY IN IT. IF THAT IS THE CASE YOU WILL WANT TO REPLACE THE INNER AND OUTTER WHEEL BEARING AND THE WHEEL SEAL. TRY THAT GOOD LUCK AND HOPETHIS HELPED.

Jun 21, 2009 | 1991 Ford Explorer

1 Answer

"Humming" or "bearing" type noise in left front at highway speeds


That's a hub bearing. Replace the one that's doing it. I'm assuming this 'roar' is coming from the front, NOT the rear.

Jun 10, 2009 | 2001 Hyundai Elantra

2 Answers

Front end noise on 97 Chrysler Cirrus


its your left wheel bearing, or the cv axle.. good luck keith...

Mar 26, 2009 | 1997 Chrysler Cirrus

3 Answers

1999 Blazer front end noise


If your turning your car to the right when it make the noise or the Left Listen and find out because which ever way the noise is loudest usually meaning that is the side going bad, Thats the rule Usually some cars and trucks have fronts and rear bearings, But I think it is a wheel bearing, Have a mechanic or a friend that may turn some wrench's Check it out for you. Hope that helps you out. :))

Jul 30, 2008 | 2000 Chevrolet Blazer

Not finding what you are looking for?
1999 Chevrolet Silverado 1500 Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...