Question about Cars & Trucks

1 Answer

How to adjust fog lights on2008 chevy HHR - Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,679 Answers

Adjuster screws either side of light at the rear unless there solid mounted and then no adjustment is available ,you will know when looking at the back of lights

Posted on May 06, 2014

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
tripletauto
  • 1450 Answers

SOURCE: hhr fog lights

yes it is you will probably have to have the bcm programmed for the foglight option if your gonna install like factory is

Posted on Sep 22, 2008

  • 57 Answers

SOURCE: 07 chevy hhr i need to change my little turn

This is a tough one, but the turn signal bulb (and also the headlight bulb) is accessed by opening up the inside wheel well.

You will need to turn the steering wheel hard in, then turn the car off. There are both screws and push fasteners holding the plastic inside well in place. Loosen as many as needed to bend it out of the way and you can then reach inside and replace the bulbs.

As a recommendation, you might as well replace both sides at the same time. They will both fail at about the same time.

The owners manual actually describes this process, as also gives the information on the replacement bulbs.

Posted on Mar 22, 2010

  • 57 Answers

SOURCE: 09' hhr fog light wiring

You will need to completely wire your own setup. The "stock" fog lights on the HHRs are wired through the Body Control Module computer which can not be reprogrammed without being replaced. Cost of the computer is over $300 and certainly NOT worth it for a set of fog lights. Put in your own switch, wiring, etc. I would highly recommend that you use a relay to power them since the electrical system for the HHR is very sensitive to external additions.

Posted on Jun 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Chevy hhr starter location


Starter located on the engine, from under car look between engine and radiator, where engine connects to transmission, that is the starter. Check links below, press the helpful button
Chevy HHR starter location and removal

Going under the Chevy HHR

How to Test and Troubleshoot Starter Problem

Time to replace starter 07 HHR 2 4L Chevy HHR Network


Dec 03, 2012 | 2006 Chevrolet HHR

1 Answer

07 chevy hhr i need to change my little turn signal light that is right next to my fog light how do i get to it


This is a tough one, but the turn signal bulb (and also the headlight bulb) is accessed by opening up the inside wheel well.

You will need to turn the steering wheel hard in, then turn the car off. There are both screws and push fasteners holding the plastic inside well in place. Loosen as many as needed to bend it out of the way and you can then reach inside and replace the bulbs.

As a recommendation, you might as well replace both sides at the same time. They will both fail at about the same time.

The owners manual actually describes this process, as also gives the information on the replacement bulbs.

Feb 20, 2010 | 2008 Chevrolet Hhr

1 Answer

How do you replace the front turn signal lights for a chevy hhr


how do you change the front turn signal light on chevy hhr 2006

Oct 02, 2009 | 2006 Chevrolet HHR

1 Answer

09' hhr fog light wiring


You will need to completely wire your own setup. The "stock" fog lights on the HHRs are wired through the Body Control Module computer which can not be reprogrammed without being replaced. Cost of the computer is over $300 and certainly NOT worth it for a set of fog lights. Put in your own switch, wiring, etc. I would highly recommend that you use a relay to power them since the electrical system for the HHR is very sensitive to external additions.

Mar 09, 2009 | 2008 Chevrolet Hhr

1 Answer

Installing fog lights oem 09' hhr is wiring there now or do i have to completly wire from scratch?


NO YOU WONT HAVE TO REPLACE ANY WIRE THAY SHOULD JUST UNPLUG THEN PLUG IN THE NEW FOG LIGHTS

Mar 09, 2009 | 2008 Chevrolet Hhr

1 Answer

Problem with 1998 chevy malibu fog lights


hi disconnect your fog light switch if this doesn,t knock them off you need to find the fog lights relay and replace it as the fog light circuit is shorted best of luck yates210456

Oct 07, 2008 | 1998 Chevrolet Malibu

3 Answers

2006 HHR Chevy starting problem


possible low battery......... have it charged or jumpstarted

Oct 02, 2008 | 2006 Chevrolet HHR

2 Answers

Hhr fog lights


yes it is you will probably have to have the bcm programmed for the foglight option if your gonna install like factory is

Sep 22, 2008 | 2007 Chevrolet HHR Special Edition

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...