New head , page
fsm covers it
alldata.com covers it
as does free fsm
and here.
best.
http://www.fixkick.com/engine/head-pull/head-pull.html
which engine, the 8v and 16v have different theds.
G16a is 8v , G16B is 16valve MPI engine.
hint do not lose the head locking pins, in corners. or the belt
will never ever run true after.
done many
SOURCE: Replace head gastket
try removing the vacuum hose from the fuel pressure regulator turn the key on and if it leaks the regulator is bad
SOURCE: 1992 Toyota Previa van,Oil dripping onto exhaust manifold, replace head gasket? need a free manual!
The toyota previa uses a formed silicone gasket for the valve cover and the cover is held in place by metric shoulder bolts ( 10mm). The valve gasket leaks because you can't get enough preload on the bolts to re-seat the old gasket when it gets old and shrinks. The shoulder bolts only allow you to tighten the gasket enough to seat the shoulder on the bolt. If you continue to torque down the suspected bolts, you will snap the bolt off ( don't ask me how I know this ). You can either 1.)replace the old gasket with a new one or 2.) remove the existing bolts around the leak area and put in new metric bolts that do not have a shoulder. You may want to put in a small sleeve into the existing bolt hole but shorter than the thickness of the valve cover to account for the smaller diameter bolt. You can now torque down the bolt and get enough preload to seal the valve cover without removing the old gasket. Make sure you use a torque wrench ( in-lbs) or be very careful not to snap these small valve cover bolts.
SOURCE: is replacing the head gaskets on a 1992 eldorado a
before ripping off half ur top end make sure its not something else-to answer ur question if ur not afraid to remove distributor/intake manifold /exhaust manifold /wires/vacuum hoses and head no problem ur a shadetree mechanic but be4 u do check ur oil if it looks like chocolate milk and over full and blowing white smoke continuously out exhaust and loosing coolant u have a blown gasket as to over heating look at possibles of water pump- fan- fan clutch-partial clogged radiator- just getting hot doesnt indicate head gasket
SOURCE: I have a 1992 acura legend with a blown head
http://www.kbb.com/KBB/UsedCars/1992_Acura_Legend.aspx
Here is the link to the Kelly Blue Book. Plug in your zip code, mileage, and condition to get the value of the car. After you find out the value, check the price for an engine rebuild or a low mileage replacement engine. You may be better off just trading it.
139 views
Usually answered in minutes!
×