Question about 1993 Chevrolet S-10 Blazer

1 Answer

1993 chevrolet blazer fullsize 4l60e trans problem

My trans wont shift into third, it goes through first and second fine but then just over revs instead of hitting third, so i thought it was the shift solenoid,. so i replaced the 1-2 and 2-3 shift solenoids, replaced the filter and gasket, refilled with fluid , and on the test there was no change. fluid was topped off the night it went, when the pan was dropped the fluid looked ok, i figure a mix of somewhat burnt fluid and clean fluid, and there was very very minimal fine shavings in the bottom of the pan. please help, thank you.

Posted by on

  • kenthedental Jun 22, 2009

    very minimal, like no more than the amount of a single ash of a cigarette, i had to search to find them. it may have been dirt tho, i did not feel the texture of them because they were so small.

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 208 Answers

First of all shavings are a bad sign likely internal damage has occured

Posted on Jun 22, 2009

  • jrnbudd Jun 22, 2009

    if the apply piston seal were comprimized the third gerar would not apply and engadge

  • jrnbudd Jun 22, 2009

    if you do figure it out it would be a wise desision to place a magnet in the tranny pan to collect shavings so they don't circulate through the tranny good luck solving your problem

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1993 Chevy Blazer 5.7L. The transmission will not shift to overdrive. It acts like it wants to sometimes.


trans likely needs rebuilding. 3/4 clutch pack fails often in these due to a variety of reasons. 4L60E trans

Aug 11, 2010 | Chevrolet Blazer Cars & Trucks

1 Answer

1993 4l60e - Shifts hard on the 1-2 shift, works fine otherwise.


Did you change the transmission filter and gasket as well as the transmission oil before running your truck.

Sep 28, 2009 | 1994 Chevrolet C1500

1 Answer

94 blazer s10 4l60e and the 94 fullsize blazer 4l60e are they the same transmission could i use a s10 tranny for my fullsize blazer ?? i know the bolt for the plate are 3 on each side for mine and the s10...


Installing the full-size Blazer trans into the S-10 would be safer. As long as they came off of the same size engine then yes, they will interchange. But.... the trans off of the S-10 is not built as strong as the trans for the full-sized Blazer, clutch capacity is less, band servo may have smaller apply area, and torque convertor stall speed may different enough to set a "code". Towing capability would be compromised. I have no idea what you meant by the "bolt for the plate".

Jul 08, 2009 | 1994 Chevrolet Camaro

1 Answer

4L60E won't shift to 3rd on 1993 Chevy Blazer 1500


Sounds like you have a bad shift solenoid. Not sure if the Chevys are a solenoid pack, or seperate, but it will need to be replaced.

Jun 02, 2009 | 1993 Chevrolet K1500

1 Answer

4L60E won't shift to 3rd on 1993 Chevy Blazer


Hello;
It sounds as though your trans is going out. How is reverse? If reverse is real strong then you may just have a solenoid going out. Drop the pan and change the oil and filter if you are comfortable doing that. Inspect the pan for metal shavings and contaminents. Otherwise it would need to go to a shop for repair.
Thanks;
Rich
RPM Northwest

Jun 01, 2009 | 1993 Chevrolet S-10 Blazer

1 Answer

Transmission wont shift into 3 and od


Sounds as if 3rd gear is our of the transmission or it could be the shift selenoid.

Feb 09, 2009 | 2003 Chevrolet Silverado 1500

2 Answers

K-5 blazer trany will not come out of first gear what is the porb


i used to have an 85 k-5 and it did that mine was the fuel filter but it could be the transmission filter our moudule the fuel filter is the cheepest and easiest thing to try first. good luck hope this fixes your prob.

Dec 18, 2008 | 2000 Chevrolet Blazer

1 Answer

I have a 1993 Fullsize blazer and i have lost the overdrive a


THIS MOD HAS NO MODULATOR IT IS SHIFTED BY ELECTRIC SOLENOIDS INSIDE TRANS MOUNTED TO VALVE BODY CONTROLLED BY DOES THE SPEEDOMETER WORK ASK FOR A REASON SOME MODELS SHIFTED BY BUFFER CONTROL UNDER DASH WHICH SENT VOLTAGE TO PCM TO SHIFT WORTH A LOOK INTO

Nov 27, 2008 | 1993 Chevrolet K1500

Not finding what you are looking for?
1993 Chevrolet S-10 Blazer Logo

338 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...