The spark plug and cable 2 month old, it was runing perfect, star and go, no problem. after I spray with engine cleaner and hoses with water the engine hard to star every morning and when the car stop within 1-2 hour also difficult to star the engine,
I replace air flow sensor, and cleaned the air flow system.
Please responce to email
Thank yu for your kind attention and your help on this matter
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
www.answers.com > ... > Categories > Cars & Vehicles > Asian Car i need how much pression (torque) for head daewoo nubira 2001 2.0 ... What is the cylinder head torque specs for a 2001 daewoo nubira 2.0 litre engine and ...
Follow these steps on how to replace thespark plugs.
1.First, you turn off the Sonataengine and allow it to cool. This normally takes about 30 minutes.
2.Raise the hood and locate thespark plug cables along the side of the engine. Spark plug cables are normally1/4 to 1/2 inch thick and plug directly into the engine.
3.Grasp the cable by its boot.This is the thicker piece that covers the spark plug or spark plug well. Turnthe cable back and forth until the lock releases. Pull back on the cable toremove it. Complete the replacement process for each plug before moving on tothe next. Slide the socket, extension and wrench over the spark plug. Turn thewrench to the left to unscrew and remove the plug from the engine. Spark plugsockets have a cushion inside that grab the end of the plug to hold it inplace.
4.Clean the well and boot withthe wire brush. Do not rub hard on the well or boot or it will cause damage.Spray silicon in the boot and on the spark plug threads, so you can easilyremove the spark plug the next time.
5.Insert the socket into the welland gently thread it into the engine. Test the tension with the tester. Thetension a spark plug needs varies by plug manufacturer. Check the package tofind the correct tension. If you need more tension, tighten the spark plug. Forless, loosen or unscrew the plug.
6.Place the cable back onto thespark plug. Repeat Steps 2 through 7 for the other plugs. Work your way downone side of the engine and then down the other as you replace or clean thespark plugs.
This are the things you need for the job, 16mm spark plug socket,Socket wrench with extension, Wire brush, Silicon spray, New spark plug,Tension tester
well then it is time to do a ring job, valve job, or both to keep the oil out of the combustion chamber. might make more sense to just exchange your engine for a rebuilt one. there is no magic fix for this.