Question about 2007 Volkswagen Jetta 2.5 Sedan

1 Answer

How to replace a headlight bulb for a 2007 jetta? I need to take out the bumper?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 365 Answers

Look in engine bay behind the headlights, there should be a plastic cover with wires running into it, remove the cover which will expose the back of the light and the plastic square plug which is connected to the back of the halogen bulb, pull the square plastic wire block off the back of the bulb, you will see two spring type clips which hold the bulb into the back of the light, you have to press down slightly and pull towards the centre then release it and it will now be loose, do the same to the other spring and remove the bulb, replacement is reverse of the removal process
Hope this helps you

Posted on Jun 22, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

HOW TO REMOVE A HEADLIGHT FROM A 2007 SATURN OUTLOOK XE


Hi Carol , your going to have to remove the headlamp assembly to replace the bulb !


Remove the headlamp assembly. Refer to Headlamp Replacement.



1



Headlamp Bulb Accessory Covers (Qty: 2)



2



Headlamp Bulb Assembly (High Beam)




Caution: Refer to Halogen Bulb Caution in the Preface section.




Tip

Disconnect the electrical connectors and remove the bulbs.



3



Headlamp Bulb Assembly (Low Beam)


Callout

Component Name

Preliminary Procedure

Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement .




Headlamp Assembly Bolt (Qty: 4)

Notice: Refer to Fastener Notice in the Preface section.

Tighten

6 N?·m (53 lb in)







2





Headlamp Fascia Brace Fender Reinforcement Bolt




Tighten

6 N?·m (53 lb in)







3





Headlamp Cam Adjuster




Procedure

Set the headlamp adjusters at the nominal setting of 6 turns off fully seated.







4





Headlamp Cam Locking Nut







5





Headlamp Assembly




Tip

Disconnect the electrical harness as the headlamp assembly is being removed from the vehicle.

Apr 08, 2015 | 2007 Saturn Outlook XE

1 Answer

Replace headlight assembly on 2007 buick lucerne


To change the headlight get under the car and reach up behind the bumper to change the bulb very easy took me 3min

Jul 12, 2011 | 2007 Buick Lucerne CXS Sedan

1 Answer

Just want to know can you replace headlight bulbs and do you have to take bumper off to get headlight out


yes you can replace headlights bulbs and no you don't take the bumper off that would be crazy.
you access the bulbs from inside the engine compartment. and yes it is a little tight.

Apr 02, 2011 | Buick Estate Cars & Trucks

1 Answer

How do you replace the headlight bulb in a 2007 bmw 328i?


You have to remove the bumper first...

Tools Required:
- socket wrench/socket kit
- 8mm socket
- 10mm socket
- flathead screwdriver
- flathead stubby
- torx driver set

Optional Tools:
- car jack
- monkey (to hold your work lights)

Instructions:
- jack up car (optional)
- At least jack up one side of the car

1) Remove 4 screws on top of bumper ( under hood, above kidney grills)
2) Remove 2 screws in each wheel-well, and clip bumper trim away from wheel-well trim
3)Push wheel-well trim away so you can unfasten 2 screws inside that hold top part of bumper to the car on each side
4) Release about 7 Screws on bottom of bumper from underneath
5) Remove bumper by uncliping each side and then pulling bumper forward

Foglights will stay in place. simply disconnect the cable.

After you remove the bumper and unplug the Foglights
1) To remove the lights you also need to remove the bracket that hold the lights
2) Remove the blots on the bracket and top of headlight.

Installation is in the reverse of removal...

Oct 21, 2010 | 2007 BMW 328xi Sports Wagon

3 Answers

How to replace headlight on 2007 gmc acadia


first if you are changing the bulb only and it is a HALOGEN
there is a round acess hole in the inner fender remove it and change the bulb
if you have HID lights or are changing the head light assembly then you have to remove the front bumper facia
hope this helps
hope you have HALOGEN lights

Feb 11, 2010 | 2007 GMC Acadia SLE

1 Answer

Need to change headlight bulb 2007 jetta


HAS THE BACK OF BULB HOLDER HAS A BLACK RING AROUND EDGE?, IF SO TWIST THE RING WHICH SHOULD RELEASE BULB TO PULL OUT

Dec 12, 2009 | 2007 Volkswagen Jetta 2.5 Sedan

1 Answer

How do I change the headlights for the 2009 acadia?


first are they HID
if just HALOGEN LIGHTS BULB
jack the vehicle up and remove the tire on the side you are replacing the light
remove the inner fender
you will see a round plug turn and remove then you will see the bulb
replace the bulb and reassemble

now if they are HID LIGHTS OR YOU ARE REPLACING THE WHOLE HEADLIGHT ASSEMBLEY
then the whole FRONT BUMPER FACIA HAS TO COME OFF
hope this helps let me know

Nov 15, 2009 | 2007 GMC Acadia SLE

1 Answer

Access headlight bulbs for 2007 tahoe


When you open the hood, you will see little plastic tabs that you can pull up. This will release the headlight assembly, and give you access to the bulbs.

Mar 24, 2009 | 2007 Chevrolet Tahoe

2 Answers

Headlight Issue


No, you just might have to take out the battery. I was able to do it without taking the battery out, but only because I was being stubborn. There is one thing I definitely have to say is that you should change both headlights at the same time. My driver side headlight was the first one to go and I didn't listen and just changed that one, days later my passenger side one went out!

Mar 13, 2009 | 2004 Volkswagen Jetta

1 Answer

Headlight out


you must remove the headlight,take off front gril,bumper then you can reach headlight

Jan 31, 2009 | 2006 Volkswagen Jetta

Not finding what you are looking for?
2007 Volkswagen Jetta 2.5 Sedan Logo

4,671 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Marvin
Marvin

Level 3 Expert

81400 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...