Question about 1994 Chevrolet S-10 Blazer

2 Answers

I have a 1994 2wd blazer 4.3 vortec .it has poor idle,poor acceloration,have rebuilt fuel injetion and tested fuel pressure 65psi ,set timing. could ECM be reading wrong?or possible bad tps?

Posted by on

  • fly_flybirdi Jun 29, 2009

    corrected idle. but no power improvement.

×

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 57 Answers

I would install a new tps throttle postion sensor and then dive it 2 miles at 50 miles an hour to calibrate itself

Posted on Jun 22, 2009

  • nuttbysteve Jun 29, 2009

    i would check the exhaust temperature all a long the exhaust pipe with a non contact thermeter could be a plugged converter or even muffler

×

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Im going through the samething with my 94 s10 4.3 vortec my check engine light comes on and has been reading that its "tps circuit low voltage" which indicates a bad wire or ground somewhere becuase I repkaced my tps and the problem still persisted check the wires or they told my to look into a new "map" sensor

Posted on Jul 21, 2012

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Have a GMC 99 Sonoma p/2Wheel Dr have gas supply issue has gas to motor pressure looks good but won t start,will run if spray starter fl in carb then dies ???


Just for the record, thats the throttle body.
Have you checked to see if the injector is opening ?
If it is a vortec engine, is fuel pressure at least 65psi ?

Apr 09, 2015 | GMC Cars & Trucks

1 Answer

My 2002 Chevy blazer 4+4 is useing way more gas then ever why what is the problem injeters fuel filter


Check, replcae air filter, fuel filter. Any restrictions on intake would cause poor consumption. Also exhaust restrictions, and or leaks. Once all that been taken care of, can move onto more complicated items.

Aug 12, 2014 | 2002 Chevrolet Blazer

1 Answer

Need fuel pressure and flow rate for 2001 Focus ZR3 2.0 twin cam


the 8 digit of the VIN is engine code
VIN A KOEO 37-42PSI IDLE 5PSI DROP
VIN 3 KOEO 38-42PSI IDLE 5PSI DROP
VIN 3 NO RETURN LINE KOEO35-65PSI IDLE 35-65PSI
VIN P NO RETURN LINE KOEO35=65PSI IDLE 35-65PSI

Mar 28, 2014 | Cars & Trucks

1 Answer

93 s10 blazer with 4.3 liter vortec won't stay


You first need to run a fault code test on this engine, to do that go here.

Oct 10, 2012 | Cars & Trucks

1 Answer

My 1995 Chevy Blazer will stall out only after it get warm. I recently replaced the fuel pump due to a cracked fuel line. I replaced the fuel filter as well. What else could be causing it to stall out?


Could be a vac leak or a problem with the EGR valve among other things. Fuel pressure regulator comes to mind too.
If you did not use a GM pump I would recheck your fuel pressure.
If you have the vortec engine it takes at least 65psi of fuel pressure to make it run.

Sep 29, 2012 | 1995 Chevrolet S-10 CA Edition

2 Answers

My 94 GMC Jimmy 4x4 vortec, is hard to start, cuts off when i make stops, have to put it in neutral when i am at lights and still have to give it gas then. already changed the distributor cap and rotor...


I recently had similar symptoms from my Kia Rio, hard to start, bad idle in gear, etc.
Ended up being the idle air control valve, you can try cleaning yours with carb cleaner and see if there's any difference.
A clogged fuel filter can produce the same symptoms too, that might be the easiest thing to start with, then it's just a process of elimination from there.

Sep 02, 2011 | 1994 GMC Jimmy

4 Answers

2004 Chevy Blazer. Poor acceleration, limited rpm. Code p0101


Check your catalytic converter, good chance that it has broken apart and is blocking exhaust flow. Common Chevy 4.3L Issue.

Mar 16, 2010 | 2004 Chevrolet Blazer

3 Answers

96s10 starting problems replaced throdle position sensor,fuelpump relay,no start shot of starting fluid fires right up and runs


Check the fuel pressure at the shredder valve. You should have 60psi to 65psi with the fuel pump primed and engine not running. Once the engine has been started, there should be a 5psi drop. Make sure the fuel filter has been replaced and that the fuel pump is making at least 60psi. Anything less or more then 65psi will not activate the fuel injectors, the other thing to is that the spider injection system on the vortec are know to go bad and you may have to replace the system. Good luck and keep me posted, be glad to help you get your S-10 running 100% again. 

Aug 23, 2009 | Chevrolet S 10 Cars & Trucks

1 Answer

Stumbles on acceleration


Faulty idle air control valve. Fuel filter clogged. Damaged or wet ignition system wires. Faulty idle control system. Low fuel pressure. Ignition timing or timing chain.

Jun 02, 2009 | 1989 Chevrolet S-10 Blazer

1 Answer

I HAVE ENOUGH FUEL PRESSURE TO RUN WELL, BUT NOT ENOUGH TO START


Then your best bet is to change the fuel pump. It must be too weak. You could have the pressure tested first, if you want to be sure. It has to be either that or a faulty idle control sensor.

May 19, 2009 | 1999 Chevrolet Blazer

Not finding what you are looking for?
1994 Chevrolet S-10 Blazer Logo

438 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...