Question about 1999 Oldsmobile Intrigue

1 Answer

99 intrigue where is the torque conferter sensor is located on

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 253 Answers

The TCC, PWM solinoid is inside the transmission on the drivers side under the side cover. Good Luck

Posted on Jun 22, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Hi. Where is it upstream oxygen sensor blank 1 sensor 1 oldsmobile intrigue 99 3.5

Bank 1 is where the number 1 cylinder is. This is nearest the radiator on a GM. The sensor should be on the exhaust manifold or just after in the exhaust. Sensor 1 is the upstream sensor (nearest the engine, and for keeping the fuel/air mixture right), sensor 2 is called the downstream sensor and is always after the catalytic converter. You may have two sensor 1's,one for each engine bank, and then two sensor 2's-if you have dual exhaust.

Mar 27, 2015 | 1999 Oldsmobile Intrigue

1 Answer

Wer can i find the crank sensors on a 99 olds intrigue 3.5 engine

The crank sensor is located below the front exhaust manifold and above the starter. To access it, you must lift the front of the vehicle, and remove the starter. Once the starter is removed the sensor is visible. Because of the poor location and poor GM engineering these sensors fail. You have excessive heat from the exhaust and oil leaking from the valve covers that short them out. Also once the sensor is replaced, it must undergo a re-learn process. Unfortunately this process can only be performed by a GM dealer via their computer system.....if you need further assistance, feel free to post them on FYa...hopefully this helps!!

May 05, 2010 | 1999 Oldsmobile Intrigue

1 Answer

I need to replace the O2 sensor on my 99 Oldsmobile; where is it and can I do it? 1999 Oldsmobile Intrigue GL

it depends on which o2 sensor is bad. you have 2 on your car ones an upstream o2 sensor which is before catalyic convertor the other is a downstreem o2 which is located after the cat. they both range anywhere from 50.00 to 100.00 a peice. and there is a special tool to buy to change it. this is what it looks like. 945a39f.jpg if you don't mind jacking your car up and placing jack stands under the car to support it. you should be able to replace it. besure to spray it real good with some penatrating oil like wd40 and let it soak for a while before trying to remove it.

Mar 12, 2010 | 1999 Oldsmobile Intrigue

1 Answer

I am replaceing the cat converter and O2 sensors on a 99 olds intregue where is the front O2 sensor located

it has to be in front of the converter, somewhere between the exhaust manifold and the cat

Feb 25, 2010 | 1999 Oldsmobile Intrigue

1 Answer


You don't clean them, you get a new one. Usually if it's the MAF, it'll start and die, start and die. If your's is stalling, it'll be the idle air control valve, or the fuel filter, or the idle control system, or a vacuum leak at the intake or vacuum hoses. Good luck.

May 06, 2009 | 1999 Oldsmobile Intrigue

1 Answer

Cooling fans sensor

On 3.5l, screwed into the rear of the rear cylinder head.

Mar 17, 2009 | 1999 Oldsmobile Intrigue

1 Answer

Trying to find where a new "coolant temp. sensor" goes.

On rear head - its the grey connector barely visible:


Mar 13, 2009 | 1999 Oldsmobile Intrigue

1 Answer

99 oldsmobile intrigue

The ambient temperature sensor going bad causes this exact problem. I've replaced many of them because when they show outside temp as being below 60 degrees, the A/C control module will shut the compressor off.

Aug 07, 2008 | 1999 Oldsmobile Intrigue

Not finding what you are looking for?
1999 Oldsmobile Intrigue Logo

Related Topics:

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts


Level 3 Expert

81423 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides