I have a code po340 i replaced the camshaft sensor still have the code what could it be

P0340 Ford - Camshaft Position Sensor Circuit Bank 1 Sensor

Read more: http://engine-codes.com/p0340_ford.html#ixzz393ZCFfRt
Site gives possible causes and procedure to replace sensor if needed.

Trevor: Alittle known fact is that most Chrysler cars do not need a full OBD code reader! By performing the "Key-Dance" you can show the codes on the odometer without any reader! Look for info on how to read the codes with the ignition key.

On your problem, you need to check the wiring and connectors, and also check the proper cams and belt timing, as it is difficult but sometimes an out of timing (one tooth only) misalignment can make the car not to start.
Amclaussen.

Camshaft positioning sensor needs to be replaced. im not sure if there is more than one on the vehicle but that can be quickly diagnosed at a repair shop.

replace the camshaft position sensor or pick-up coil. it goes by two name depending on the car so if they say it doesnt have on ask for the other

po340 is a camshaft position sensor code depending on what engine is in your vehicle sensors are located in different places you'll probably need a service manuel

CODE PO340 IS NO CAMSHAFT POSITION SENSOR CIRCUIT FAILURE.

po401 is egr flow insufficiant ( the egr needs removed and cleaned also clean where it mounts to engine. po340 is camshaft position sensor A- bank 1 curcuit malfunction. it is a bad camshaft sensor.

PO340 IS NO CAMSHAFT POSITION SENSOR CIRCUIT FAILURE.YOUR CAR IS GOING TO HAVE BE REPROGRAMMED BEFORE PCM WILL RECOGNIZE THE NEW CAMSHAFT SENSOR.

P0340 is a Crankshaft Position Sensor error. It determines firing order and is most likely the cause of your problem. It's mounted near the oil filter on the engine block. Below is a picture of how it appears in your car. Best of luck.
Greg

Hi,
This indicates that a problem was detected in the camshaft position sensor circuit. Since it says circuit, that means the problem could lie in any part of the circuit - the sensor itself, the wiring, or the PCM. Don't just replace the CPS (camshaft position sensor) and think that will definitely fix it.

With a P0340 OBD-II trouble code, diagnosis can be tricky at times. Here are some things to try:

• Visually inspect all the wiring and connectors in the circuit
• Check for continuity in the circuit wiring
• Check the operation (voltage) of the camshaft position sensor
• Replace the camshaft position sensor as required
• Check the crankshaft position circuit as well
• Replace circuit wiring and/or connectors as required
• Diagnose/replace the PCM as required

Thanks.