Question about 2002 Chevrolet TrailBlazer

2 Answers

I need to remove the driver side door panel to replace the speaker

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

It should have clips that pop on and off and when you get that off there should have plastic under it do not mess it up but you should be able to see the speaker to replace it and dont for get to unhook the power window button

Posted on Jun 21, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 365 Answers

Sorry, I don't have a vehicle listed for you...so, my best advise is to drive over to your local car stereo shop and ask them to remove the door panel (while you watch) . You may have to pay them $20...but chances are if you watch, you'll get far more worth from the experience than the $20 charge.
We were the largest car audio dealer in central florida for many years and I can tell you just swapping out the speakers isn't all that easy (we charged $45 per pair and never made money doing it).
Good Luck

Posted on Jun 21, 2009

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

countrysi248
  • 443 Answers

SOURCE: I need to remove the door panel on my 2004 Avalanche

There are plastic clips that hold the door panel inplace .. First look for any hidden screws near the door handle . there might be a little plastic cover that you need to remove with a small screw driver to find the screws.. look under the handle also to see if there are any hidden screws . next take a flat blade screw driver and start at the bottom corner and try gently prying the door panel off . try to stay close to the plastic clips not to damage them by prying real hard .. once you have snapped them loose all the way around .. lift up on the door panel to remove it from around the window lip and out it should come.. holler if you have any problems.. usually The mirrors on the chevys are up above the panel and there is a triangle plastic cover over it on the inside .. it will pry off also gently and there are 3 nuts there that need to be removed .. use caution these fall behind the door panel ... holler if you need more. Jerry

Posted on Apr 24, 2009

  • 1986 Answers

SOURCE: I need to remove the door panel on my 2004 Avalanche

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them.

Posted on Aug 14, 2009

  • 1986 Answers

SOURCE: I need to know how to remove rear door panel

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. I don't know what speaker you'll actually need.

Posted on Sep 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove the driver side door panel on a 1994 Lincoln Mark VIII


Remove mirror mount cover assembly.
Remove inside door handle cup (22634).
Remove door lock control bezel.
Remove window control bezel.
Remove interior lamp lens.
Remove screw from interior lamp assembly body.
Remove screw from window control bezel opening.
Disconnect mirror, lock switches and memory seat on driver side from bezels and wire harness.
Disconnect window switches from window bezel and wire harness.
Lift front door trim panel (23942) vertically, out of weatherstrip and over lock rod.
Disconnect interior lamp (13776) from wire harness.
Remove front and rear door trim retention hooks into door inner panel.
To install, reverse Removal procedure, paying special attention when inserting inner door trim into weatherstrip. Rock inner door trim into weatherstrip and push downward until lower trim belt character ditch lines up with score mark on inner door panel.

Aug 16, 2014 | 1994 Lincoln Mark VIII

1 Answer

Remove and replace drivers side power window switch


I am assuming its the drivers door window you are speaking of....
The drivers door has the master window switch w/lockout. The entire assembly must be replaced. The individual switches on the drivers door can't be replaced by themselves. Some GM vehicles allow the panel with the switch assembly to be removed without removing the door panel. However, most require the door panel to be removed for access to the window switch assembly. The master door/window switch assembly is not cheap, by the way.
I would check/replace the window relay first. Usually located under the dash, or under one of the seats.
Might just be the window motor on the problem window.

Jul 08, 2013 | 2001 Cadillac Eldorado

2 Answers

Where is the fuse box in 02 ford explorer? Lost the manual


The interior fuse panel is on the left (driver's) end of the dashboard. Open the driver's side door and look at the end of the dash, you will see a removable panel...behind that panel is the fuse panel.

Jan 22, 2010 | 2002 Ford Explorer

1 Answer

Lneed to remove drivers side door panel


You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Jul 16, 2009 | 2001 Jaguar S-Type

1 Answer

How to remove drivers door panel from 1997 Cadillac Deville.


try to look at stress point on door by handle normally two screws and under neath panel to screws also disconnect side panel for side mirror door of using panel popper

May 23, 2009 | 1997 Cadillac DeVille

1 Answer

I can't figure out how to remove the toggle from the door panel for the drivers side door mirror.


You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. Then you'll need to remove the cover just beside the mirror and you should be able to get to the cables

May 20, 2009 | 1996 Pontiac Grand Am

1 Answer

Central locking and windows system not working


The most likely cause is that the door module has failed on the drivers side, alot of the time the module can be brought back to life so to speak by removing the drivers door panel and disconnecting the module and leaving for 5 minutes before reconnecting. The module is basically drivers door switch pack.

Dec 13, 2008 | 1996 Jeep Grand Cherokee

1 Answer

Door handle replacement


OK. The door handle has one screw that holds it in place. after removeing the screw the unit will be lose so to speak. You will also have to remove the window handle as well. The window handle can be removed with a screwdriver and a pair of needle nose pliers. first put the screw driver tto the back side of the window handle. Press gentlly against the door panel so you can see the "C" clip which you will need to remove. After removing the "C" clip and the window handle you are ready to remove the door panel which is just snapped on to the door with several plastic pins which should unsnap easily. It wouldn't hurt to use your srewdriver to aid in unsnaping the pins. once you have the door panel off you should be able to see how the old door handle is connected. good luck

Sep 01, 2008 | 1992 Suzuki Sidekick

Not finding what you are looking for?
2002 Chevrolet TrailBlazer Logo

230 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...