Question about Mitsubishi Outlander

1 Answer

My shogun ignition won't turn out do you think it is a wiring fault

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mitsubishi Master
  • 2,200 Answers

Could be a wiring fault - yes. But if you mean that the ignition light won't go out after removing the key I would say its most likely the ignition switch itself.

Posted on Jun 21, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 dodgeram 1500 won,t start won,t turn over


check for power from the ignition in the start position to the starter relay/ solenoid terminal.

Jan 28, 2014 | 1997 Chrysler Town & Country

1 Answer

Mitsubishi shogun fault codes


by using a code readercb3e7a5a-8ef5-43b9-8741-1d56de4d180c.jpg

Dec 17, 2013 | Cars & Trucks

1 Answer

I replaced the ignition lock cylinder in my 92 cabriolet and I turned the key and it started first swing, then I was putting the steering wheel covers back on and it just turned off... When I try to turn...


If it's an automatic check fuse #15 wether it's a stick or automatic you should have power at the red & black wire coming out of your ignition switch when you turn key to start postion and power at the red wire going into switch at all times. if no power coming oit on the red/black wire you need an ignition switch. if there is power coming out of switch try putting car in nuetral (for auto trans). if still nothing you'll need to check for power at small wire going to starter when key is turned to start. if has power then need starter if no power you'll need to check starter interlock relay.

Dec 31, 2012 | Cars & Trucks

1 Answer

Shogun elegance ask light comes on and the car goes in to limp mode


Hello

The engine and the automatic transmission (transmission control is only for automatics, engine is still computer controlled no matter the transmission type) in this vehicle are computer controlled and in most cases when a fault occurs a fault code is stored in the memory of the computer control module. There are exception to this, such as the Mass Airflow Meter and fuel pressure problems. What must be done is to have all the basic testing done such as a scan of the system for fault codes as well as a check with a live data scanner tool for engine functions that are not within range of normal, a trained technician is required to know what is correct and what isn't, then based on careful diagnostics done from a factory repair manual the correct part is replaced or the wiring repaired or the computer replaced (known as the PCM), which is very rarely the problem. Other basic checks must be done as well such as mechanical problems with the engine as well as engine state of tune and mileage on the engine. The transmission can have mechanical issues as well such as no gear engagement at all or a failed pump or other pressure related problems.



Oct 02, 2012 | Mitsubishi Cars & Trucks

1 Answer

Shogun intermitant cruise control


follow the next steps:
1) test switch for faulty
2) test the servo, for faulty
3) poor ground connection
4)poor control circuit connection, test and tight
5)faulty relay or replace
6) faulty speed sensor, replace and test see the diagrma
God bless you
7_25_2012_7_53_58_pm.gif7_25_2012_7_54_47_pm.gif7_25_2012_7_56_03_pm.jpg7_25_2012_7_56_26_pm.jpg

Jul 25, 2012 | Cars & Trucks

1 Answer

02 subaru outback won't start. when I turn the key everything turns on like normal but when I get to the point where the starter should engage it just clicks one time. Shop says starter is good. It...


HMMMM thinking aloud here ,_-_--hmmm right have you run a hot wire from + on battery to the small terminal on the starter if so and it cranks then its either starter relay or the ignition switch ,but if starter turns ok with the hot wire then before you go any further try the spare key if still no joy with spare key then its electrical fault if it starts with teh spare key then your other key has lost its chip or been close to a mobile phone or TV screen and blanked the magnetic bar code .

Nov 02, 2011 | Cars & Trucks

1 Answer

When I turn the key, it starts good--has a new battery- however, once in a while I turn the key and there seems to be no connection between the battery and the starter, no click, nothing. . The I try...


This sounds more like an ignition issue and not a starter or battery issue. When you turn the key if no power is being sent to the major components then that is a fault either in the wiring to the ignition system or the ignition system itself is bad and you need to replace the ignition

Jun 15, 2011 | 2005 Chevrolet Impala

1 Answer

Code P0351


  • Hi
  • means ignition coil fault
  • possibly replace spark plugs and wires
  • possibly replace coil if needed
  • if it's a DIY , do one plug and wire at a time so you won't lose order

Jun 03, 2011 | 2003 Chrysler PT Cruiser

1 Answer

Montero/Shogun 1998


order and buy the book at sprints auto
the wiring diagram will tel you all you need

Nov 24, 2009 | Cars & Trucks

1 Answer

Eating alternators mitsubishi shogun 1994 2.5td gls


is your a 12v or 24v some imports are 24v and engine parts are different thanks brian

Mar 07, 2009 | 1988 Mitsubishi Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

191 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8755 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...