Question about Honda Accord

3 Answers

Honda accord 2001 standard four door lx model Issue number one turn signal and four way flashers do not work when pressed in fuses and relay are fine no problems. Issue number two when the four way switch is pressed in , when the key is removed the engine is still running . Issue number three no key in ignition and the four way switch is pressed in u can operate the power windows

Posted by on

  • 1 more comment 
  • williemccull Jun 21, 2009

    the switch is in top condition when pressed in it does not operate the four ways

    but if i put the left and right signal the bulbs will be lit but no flashing occurs

  • williemccull Jun 21, 2009

    honda accord 2001 standard four door lx model Issue number one turn signal and four way flashers do not work when pressed in fuses and relay are fine no problems. Issue number two when the four way switch is pressed in , when the key is removed the engine is still running . Issue number three no key in ignition and the four way switch is pressed in u can operate the power windowsComment posted on Jun 21, 2009
    the switch is in top condition when pressed in it does not operate the four ways
    but if i put the left and right signal the bulbs will be lit but no flashing occurs

  • williemccull Jun 23, 2009

    4way switch tested good on another car , when 4way is pressed in with no key in ignition the dash lights up and the power windows will operate . if the 4way is pressed on before the ignition key is put in the engine will turn over but not start .I was wondering if there is a defective module in the system , does any of these circuits share a module if so where is it located , am i on the right track with my thoughts Willie

×

Ad

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,952 Answers

The power windows are connected to the driver door multiplex control unit and this unit seems to be the cause of the problem.

Try resetting to see if it works.

RESETTING THE POWER WINDOW
1. Turn the ignition switch ON (II).
2. Move the driver's window all the way down by using the driver's window DOWN switch.
3. Open the driver's door.

NOTE: steps 4 - 7 must be done within 5 seconds of each other.

4. Turn the ignition switch OFF.
5. Push and hold the driver's window DOWN switch.
6. Turn the ignition switch ON (II).
7. Release the driver's window DOWN switch.
8. Repeat steps 4 - 7 three more times.
9. Wait 1 second.
10. Confirm that AUTO UP and AUTO DOWN do not work. If AUTO UP and DOWN work, go back to step 1.
11. Move the driver's window all the way down by holding the driver's window DOWN switch to the AUTO DOWN position.
12. Pull up and hold the driver's window UP switch to the AUTO UP position until the window reaches the fully closed position, then continue to hold the switch for 1 second.
13. Confirm that the power window master switch is reset by using the driver's window AUTO UP and DOWN function.

If the window still does not work in AUTO, repeat the procedure several times, paying close attention to the 5 second time limit between steps. If it still does not work, go to B-CAN System Diagnosis Test Mode A.
It reset, but the windows still just click. (unless I lock them, then no sound at all)...side note, when pressing the window switch on the actual door with the window there is no click noise, there is no noise either way.(locked or unlocked) Thanks for any help! Testing of the circuits would involve use of test lamps, DVOM and removal of switches , panels etc. If the above items are available andyour are comfortable with wire circuit testing, we are set to go.

From the symptoms described, it could be power is not getting to the other windows from the driver door.


Posted on Jun 23, 2009

  • 2 more comments 
  • mohammed marika thambi
    mohammed marika thambi Jun 23, 2009

    have the circuit diagram here. Go thhrough them
    to get an understanding of the system and check the fuses and wire
    socket connectors, especially between doors, and see if you have ant new discovery
    . Any other questions, just reply to question and I will get back to you.


















    car repair manual
    for your Honda Accord Repair Question.




  • mohammed marika thambi
    mohammed marika thambi Jun 23, 2009
  • mohammed marika thambi
    mohammed marika thambi Jun 23, 2009




    You should check each fuse
    with a test light or multimeter. Sometimes the fuse schematics does not
    list every circuit that is on that particular fuse so it is always best
    to check all of the fuse.





    . if you have wires cut up under your dash in a
    yellow plug . srs wires are always in yellow and if they are cut they
    will show those codes.if your air bags have been replaced that is a
    pretty good indication that the car was in an accident .take the car to
    a good reputable body shop and have them look at it.if you have a honda
    dealership with a body ship that is prefered

    Same issue here, except the aftermarket radio was in place long ago and lights were working fine until recently.





    Looked around the web, and people have suggested:





    1) checking for dead fuses (I can only find the ones under the hood, and I've replaced them all).





    2) electrical shorts (none that I could find).





    3) replacing/rehook the radio (completely replaced with original factory deck but still no go).





    4) tearing out the dashboard... (I'll hold off on this one until necessary).





    Any pros know what else we're missing?


    The power antena signal (12vdc + ) came from the
    radio, every time the radio its turn it on sends power to it, check
    that wire, the dash board lights are in series with the radio light
    (every time you dim the dashboard lights the radio light should dim
    also) this two things has to be a problem from the radio, but the
    running lights its another issue, could be a loose wire or disconnected
    harness on the back, the rear hit could loose a connector
    and the vibration do the rest.




  • mohammed marika thambi
    mohammed marika thambi Jun 23, 2009

    Electrical problems are
    really difficult to trace. In your case, we would wait
    for the running lights to fail and then do a 12-volt
    power check to the wiring circuit for the running
    lights.

    Check the
    wiring around the coil packs for damage and scan the
    computer for fault codes.


    ignition module is
    failing and may need to be replaced.


×

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Honda Master
  • 81,400 Answers

Your 4 way flasher switch is defective, replace it.

Posted on Jun 21, 2009

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,847 Answers

Many faults within the indicator systems on all cars comes down to "hazard" switch problems. If the switch gets dirty inside from ash or the like the switch can fail to re-connect properly when the hazards are turned off
Sometimes rapid on and off movement several times clears the fault but not necessarily a permanant fix
Try it first to prove it and if OK for a few days then replace the hazard switch

Thanks
kevin

Posted on Jun 21, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My turnsignals dont work on my 1987 honda accord flashers do work


flashers and turn signals have separate flasher and separate fuse.

Mar 14, 2016 | Honda Cars & Trucks

1 Answer

All my lights work.fine on my car. But signal lights won't work in.the front of back. How do I fix them. For a 95 Honda accord lx


Please check on the main fuse box for the fuse to the turn signal as this can be the fault. If not check the voltage on the flasher unit to confirm if the unit is faulty.

Mar 14, 2012 | 1995 Honda Accord

1 Answer

I have a 2002 honda accord when I push on the brake padel my turn signals or my 4 way flashers won't work. When I put on my lights my turn signals or my 4 way flashers won't work. Could you please...


Hi,
First check the fuse in the fuse box for signal light, replace the fuse with similar value if it is busted. If the fuse is still intact the problem would be the flasher relay( small cylindrical aluminum ) that is already malfunctioning.

Hope that helps you out!

Aug 07, 2011 | 2002 Honda Accord

2 Answers

97 honda accord turn signal problem


Flasher unit is bad. Replace flasher

Dec 28, 2008 | 1997 Honda Accord

2 Answers

Location of flasher for turn signal


  1. Access the COMBINATION Turn Signal and Hazard INDICATOR FLASHER on the Left-Hand (drivers) side of the instrument panel in the fuse junction panel.
  1. Remove turn signal flasher/hazard indicator flasher by pulling indicator flasher straight out.
  1. To install, align the terminals of the flasher and press into place.
How about a picture--

388df46.gif

Oct 03, 2008 | 1996 Ford Thunderbird LX

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...