Question about 2004 Toyota Sienna

Open Question

My vsc off light is on i might have hit the button ls430

My vsc off light is on i might have hit the button by mistake how do i turn it back on ls430 2002

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
axebro112
  • 56 Answers

SOURCE: VSC light is on as is trac off and mengine warning light

the trac button is to the lower right of the steering wheel.

do you know where the power door disable buttons are (these are towards the left of the steering wheel). the trac is on the opposite side. 6e3e0f0.jpg

Posted on Mar 19, 2009

Ad
  • 272 Answers

SOURCE: LS430 check VSC light on after check engine light on

My car (06 GS430) began giving me more frequent "Check VSC" warnings. (Code P0455 in my case. Really glad I bought that OBDII tool--resetting the codes is a snap!)

I knew that a loose gas cap could cause this, so normally I just give it a twist and it tightens. Now I found that no matter how many "clicks" I tightened the gas cap, it would not cinch down snug. The lightest turn the opposite way would open it.

I was all set to head over to CarQuest for a replacement filler cap. But I thought I'd inspect mine first just to see why it stopped holding. Upon inspection, I saw that what holds the cap in place is compression of the rubber O-ring at the back of the cap, which compresses against the filler neck. That apparently was no longer happening.

I carefully removed the O-ring from the cap--using screwdrivers to lift it over the edge of the groove it sits in. Like removing a bike tire from the rim--work your way around. Then I cut a strip of electrical tape about 10" long, and 1/4" wide. I wound this into the curved groove where the O-ring normally sits, just to build up a little thickness. Put the O-ring back in place. Done.

Now the cap tightens like it's supposed to, and thus far, it has stopped the VSC error codes. Don't know if it will fix your issue or not, Good luck.

Posted on May 09, 2009

  • 236 Answers

SOURCE: My 2001 Lexus LS430 was misfiring, riding rough,VSC light is on

go to auto zone, advanced autoparts, or a certified mechanic and ask if they can reset the codes, it should be free

Posted on Jun 17, 2009

  • 154 Answers

SOURCE: 2002 toyota 4runner with the engine,vsc off,vsc trac lights on

NEED TO HAVE COMPUTER CHECK FIND WHAT CODE MADE THE ENGINE KLIGHT COME ON.. AND HAVE IT FIXED,, VSC LIGHTS COME ON BECAUSE THE COMPUTER DEACTIVATES THE VSC AS A SAFETY FEATURE WHEN CK ENGINE LIGHT IS ON

Posted on Aug 08, 2009

  • 1 Answer

SOURCE: trac off, trac vsc and check engine engine lights

Battery was diconnected for 1 minute and then reconnected. All lights are off.

Posted on Mar 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is the lexus LS430 warning light ASC


The Most common cause is a loose gas tank cap. It has to be tightened until it clicks. Other, more serious faults can cause this indication, but the loose cap issue is widespread. Hopefully, that's all it is in your case!

More Info Please visit this link:-- Best Manuals

Jul 16, 2014 | Lexus LS 400 Cars & Trucks

2 Answers

I have lexus ls430 2001 i hav prob with check vsc it show in dashbord i don't know wht's problem exactly . when i start the car rpm is down & there is shaking in engin ,also the a/c not cold...


Check your gas cap, it may not be sealing properly that's why your getting the VSC light on the dashboard. Eventualy the light will go out after you fix. Good luck.

Jun 06, 2011 | 2001 Lexus LS 430

2 Answers

My rx300 has been repaired and the track_off light and the vsc light stays on do i need to take it back to the mechanic


If there is not a button on the dash that you can push to turn the traction control and vsc back on then you will have to take it back to your mechanic to find out why those lights are still on.

Jan 26, 2011 | 2002 Lexus RX 300

2 Answers

Lexus ls430 check VSC


2002 Lexus ls430 check VSC message

Dec 01, 2010 | 2004 Lexus LS 430

2 Answers

2001 lexus ls430: warning light is on with message "vsc off". When I press vsc button on dash, nothing changes. Would like to know the likely problem and solution. Thank you. Dennis


yaw sensor is out of calibration, most likely from hoisting vehicle in air. sensor needs to be calibrated before light will go out. jump pin 3 and 5 of dlc under driver side dash. connect jumper wire with ignition off, turn ignition on, vsc light should flash, let it flash for awhile (10 sec). turn ignition off and disconnect jumper wire.(do this with vehicle station on ground).

Sep 03, 2010 | Lexus LS 430 Cars & Trucks

3 Answers

What does VSC stand for when light comes on?


If you are talking about the "VSC Off" light, it means that the button to disengage your cars Vehicle Stability/Skid Control" system is engaged. Press the VSC button, the system should reengage, and the light should turn off.
If you are talking about the other VSC light, it means that your car has been forced to take evasive action to avoid a dangerous situation. For example, if you are driving on an icy road, and take a turn too tight, the vehicle may be forced to apply pressure to one of the brakes to prevent the car from loosing control. In this situation the VSC indicator light will light up to alert you that the action was taken, and remind you to possibly slow down.

Oct 19, 2009 | 2001 Lexus RX 300

1 Answer

My 2001 Lexus LS430 was misfiring, riding rough,VSC light is on


go to auto zone, advanced autoparts, or a certified mechanic and ask if they can reset the codes, it should be free

Jun 17, 2009 | 2001 Lexus LS 430

1 Answer

How do I turn the vsc back on?


As long as the "VSC OFF" is not illuminated, the VSC is ON.

Jun 09, 2009 | 2006 Toyota Sequoia

3 Answers

LS430 check VSC light on after check engine light on


My car (06 GS430) began giving me more frequent "Check VSC" warnings. (Code P0455 in my case. Really glad I bought that OBDII tool--resetting the codes is a snap!)

I knew that a loose gas cap could cause this, so normally I just give it a twist and it tightens. Now I found that no matter how many "clicks" I tightened the gas cap, it would not cinch down snug. The lightest turn the opposite way would open it.

I was all set to head over to CarQuest for a replacement filler cap. But I thought I'd inspect mine first just to see why it stopped holding. Upon inspection, I saw that what holds the cap in place is compression of the rubber O-ring at the back of the cap, which compresses against the filler neck. That apparently was no longer happening.

I carefully removed the O-ring from the cap--using screwdrivers to lift it over the edge of the groove it sits in. Like removing a bike tire from the rim--work your way around. Then I cut a strip of electrical tape about 10" long, and 1/4" wide. I wound this into the curved groove where the O-ring normally sits, just to build up a little thickness. Put the O-ring back in place. Done.

Now the cap tightens like it's supposed to, and thus far, it has stopped the VSC error codes. Don't know if it will fix your issue or not, Good luck.

May 09, 2009 | 2004 Lexus LS 430

1 Answer

VSC light is on as is trac off and mengine warning light


the trac button is to the lower right of the steering wheel.

do you know where the power door disable buttons are (these are towards the left of the steering wheel). the trac is on the opposite side. 6e3e0f0.jpg

Mar 19, 2009 | 2004 Toyota Sienna

Not finding what you are looking for?
2004 Toyota Sienna Logo

Related Topics:

86 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8725 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...