Question about 1994 Honda Civic
You most likely have a mitsuba starter this is a common problem with this make of starter replace it and buy one from a local rebuilder not a parts store
Posted on Aug 22, 2009
You seem to have bad short in the system. Get someone familiar with car electronics to look at it. Shorts can be very difficult to find.
Posted on Aug 07, 2009
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I have a 97 honda accord and it is helpful to have the tool to remove the clip. you can pick one up pretty reasonably at the local car store. it's pretty much a flat tool that fits between the handle and the door pane.'
Posted on Mar 15, 2009
Bearings are pressed into the hubs...much easier, faster and economical (if you don't have a press) to replace the complete bearing/hub assembly, no pressing is needed, since bearings are already pressed into the new hubs. Cost..aprox, 60 buxs each.
Here are the steps for the rear replacement...
Loosen the lug nuts on a rear wheel. 2) Chock the wheels and jack the rear of the car on the side with the lug nuts that you just loosened. 3) Remove the wheel by removing the lug nuts. 4) Pry open the dust cap covering the center of the axle/spindle. A small screwdriver tapped into the space between the hub and dust cap will work well for this. 5) With the dust cap now removed, use a thin center punch to straighten the little dent in the rim of the spindle nut so that you will be able to turn it freely in the next step. 6) Use a 32mm socket and a large breaker-bar to loosen the spindle nut. Unscrew the nut all the way and place it in a clean, safe area. 7) You should now be able to slide the hub/bearing assembly from the shaft. 8) Installation is the reverse of removal. Use plenty of high-temperature wheel bearing grease on all surfaces before you mount the replacement hub assembly.
IMPORTANT: Torque the spindle nut to 134 ft/lbs....(per manual specs)
When reinstalling the dust caps, tap them gently into place to avoid denting them...Install wheels, jack her down and pat yourself on the back...job complete.
Good luck..hope this will fixya up...please take time to leave me a fixya rateing...
Posted on May 23, 2009
Tips for a great answer:
Jul 22, 2017 | 1994 Honda Civic
Aug 23, 2011 | 1994 Honda Civic
Feb 25, 2011 | 1994 Honda Civic
Aug 12, 2010 | 1999 Honda Civic
May 30, 2010 | 1989 Honda Civic
May 02, 2010 | 1994 Honda Civic
Feb 17, 2010 | 1994 Honda Civic
Jan 25, 2010 | 1998 Honda Civic
Jun 21, 2009 | 1994 Honda Civic
225 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: