Question about 1995 Land Rover Discovery

1 Answer

Need to fit a vacuum pump on my 1995 disco as mines leaking oil, bought one from paddocks, are they easy to fit

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 149 Answers

Disconnect the servo hose, remove 6 bolts, pop the pump off with harness bracket making a note of the bracket for refitting.
Clean mating faces of pump & block, loosely assemble pump to block with new gasket and with harness bracket located under head of bolt noted during removal. Evenly tighten the bolts to depress the pump plunder and tighten finally to 25Nm. Reconnect the vaccum hose and secure with clip.

Posted on Feb 25, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1995 GMC Jimmy starts cold but quits as soon as you let off the ignition. Then won't restart.


Sounds like a fuel pressure problem - the fuel pump may not be working on restart, the fuel regulator may be sticking or leaking, etc. Try checking the pressure at the access fitting in the engine compartment (you will need a fuel gauge assembly).

Aug 14, 2014 | 1995 GMC Jimmy

1 Answer

I have a 1997 jeep cherokee. In the morning, it starts just fine but as it gets warmer, it will stall and die and I have to put starter fluiud in the air intake to start up again. I have changed the fuel...


The age of your vehicle guarantee's a vacuum leak. It may sound silly but the truth is rubber grommets and hose's shrink and dry out over time and the harsh environment under the hood makes it worse. Check all vacuum lines and fittings attached to the intake manifold, valve covers(pcv valve), and be sure to check for a vacuum fitting on top of the intake just behind the throttle body. Does it fit tight in the hole? You can seal loose fittings with a high-temp RTV (Red) silicone sealant/adhesive. Several small leaks add up and your engine, heat/AC, will be all to glad to tell you about it.

A vacuum leak will cause exactly what you said your engine does.

Aug 24, 2011 | 1997 Jeep Grand Cherokee

1 Answer

Land Rover disco 2, rear suspension lower


SPRAY REAR AIR BAGS WITH SOAPY WATER AND LOCK FOR BUBBLES. dOES NEW PUMP KICK ON?

Apr 25, 2010 | 2004 Land Rover Discovery

1 Answer

My heater in my chev beretta goes on and off when it wants could there be a easy fix to this


may just be a vacuum leak. best way to find out is start the car and pop the hood, you may hear a hissing sound, this would be a leaking vacuum hose or fitting. If you do not hear hissing, start with the top of the valve cover. There should be a rubber hose that goes to the brake booster, that is a major vacuum hose, start there and trace every vacuum line you see to the end....vacuum lines are mostly small hard plastic hoses, with cheap little rubber fittings, a lot of times these fittings dry rot and leak, causing the heat not to blow, cruise control not to work, bad oil pressure....you get the point, vacuum leaks are a PITA! but very important....my jeep did the same thing. All the sudden it stopped working all together. A vacuum hose had completely come apart. I spliced it together and it works like a dream....

good luck, hope this helps....

Jan 28, 2010 | 1995 Chevrolet Beretta

1 Answer

Iv got a disco 1.And when im towing and need more power, it wont rev above 4000 revs. checeked all the hoses, cleaned the intercooler, replaced fuel/oil fillter, give it oil change.Its got a KnN air...


Hi,
Are you getting a lot of black smoke?
If so your egr is more than likely goosed.
Easy fix in a 300.
Mine suffered from this a few years ago and I blanked off the egr. You can make a blank yourself or buy one with instructions for a few quid of eBay.
Well worth it and you will certainly notice the difference.
hope this helps.
Iain

Oct 11, 2009 | 1995 Land Rover Discovery

1 Answer

Mass air flow sensor on a 1995 dodge stratus is located where?


Try to unplug maf sensor and try to start and run. ECM will go to default values. I vehicle starts and runs with sensor discoed then that is the problem. Make sure all connections for air induction between maf an intake are tight and there are no leaks. Air leaks after maf sensor will cause runability issues.

Mar 29, 2009 | 1995 Dodge Stratus

1 Answer

I have a nasty oil leak in my 95 jeep 4.0 liter engine. It is weeping out of the oil filter mount. How do I take this apart to replace a gasket or oil ring>


easy fix, there is a single round o ring behind the oil filter angle housing. you will need a large allen wrench to fit the single center mounted retainer
allen bolt.
good luck chris

Mar 22, 2009 | 1995 Jeep Cherokee

2 Answers

1995 dodge dakota antifreeze leak


Check out your freeze plugs. They are thin metal cups that press fit into the side of the block. Use a mirror and a light to inspect while the engine is running.

Jan 19, 2009 | 1995 Dodge Dakota

2 Answers

Stalling at idle


Bought a use 03 last week for very cheep because it was idling rough, read in a forum about focus vacuum leaks and to use small burst of starting fluid to find the leak, spray around engine, if you hear the engine level off and run smooth in a particular spot for a few seconds the leak is in that general area, check the hose in that area, i found a large elbow on my pvc valve line was cracked in half, repaired with copper plumbing elbow fitting and silicone. now runs perfect. be very careful with the starting fluid short burst in well ventilated are.

Jul 21, 2008 | 2000 Ford Focus

Not finding what you are looking for?
1995 Land Rover Discovery Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76848 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8582 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...