Question about 2000 Toyota Camry

1 Answer

Engine won't start,checked for engine fire,plenty spark on all cylinders,checked fuel output at canister and plenty of fuel

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 45 Answers

Injectors, and how many pounds of pessure did the fuelpump hav when cranking engine?

Posted on Jun 21, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Motor turns over but won't start plugs r dry when I take one out is that spark or gas problem


Possible that gas is not getting into the cylinders. Spray some starting fluid down or into the intake. If it rumbles to life for a second, if it even fires a bit, you know that it is not a spark problem, cause yes it's got plenty of spark-good ignition-, so it must been not getting gas. Or if no effect from the starting fluid-careful, it's highly volatile- then it could be a spark problem.
If it fires, you would start diagnosing the fuel circuits that apply. The fuel pump puts gas up to the engine, to the injectors and under high pressure so the injector will spray gas into the cylinder. It's that simple. You just have to trust the manufacturer did a good job on the mile or so of wiring it all together so the computer can make the engine run. Any time you have a problem, check for trouble codes.

You should hear the fuel pump in the gas tank turn on for 2 seconds, to put pressure in the fuel lines and up to the engine, when the key is turned to ON. Make sure you can hear it. You may need to stand near the rear of the car to listen for it while someone turns the key to on. If you don't hear it, and the car won't start, you would need to check the fuel pump.

Aug 13, 2014 | Cars & Trucks

1 Answer

91 Buick Skylark ran when parked but now won't


Is the check engine light on when the engine is running ?
Someone will need to check for spark on all cylinders and fuel pressure.
You might try spraying carb cleaner or starting fluid into the throttle body to boost fuel supply and see if it helps. If it does that would tell you its a fuel problem.

Feb 06, 2013 | Cars & Trucks

2 Answers

2001 yukon shut off while driving won't start


it sounds like your alternator is going out

Jan 14, 2013 | GMC Yukon XL Cars & Trucks

1 Answer

Engine won't start


If you have spark at the right time, compression, and fuel, you should have combustion.
Was it running before you had the work done ?
Is it possible the distributor timing is off ?
You know for sure the plugs are firing, not just the coil ? And the accel pump in the carb is spraying gas ? And the choke is closed ?
A major vac leak like the PCV valve hose or intake gasket could keep it from starting.

Jul 06, 2012 | Dodge Cars & Trucks

3 Answers

1988 toyota camry 2.0 turns over but won't start. Car has been driving like a champ and one morning wouldn't start. Turns over fine but won't fire. Tested for spark by removing spark plugs...


Fuel pressure at idle is normally 30-35psi. Start by taking the gas cap off, and putting it back on. That will De-pressurize the fuel system. Also, make sure you have gas in the car. I have seen gauges on these cars read wrong. I hope this helps.

Oct 05, 2011 | 1988 Toyota Camry

1 Answer

MY 535I JUST WON' START I CHECKED THE FUEL LINE AND THERE IS PLENTY OF FUEL COULD NOT GET A SPARK AT PLUGS


Possible bad coil pack, since the plugs are not firing work you way back to the coil pack which is the 50k-70k volttage box that send the sparks through your wires to your plugs.

Jan 27, 2010 | BMW 535 Cars & Trucks

1 Answer

2001 ford escort. engine turns over but will not start. pulled the plugs and motor gets good compression,replace plugs and wires,still nothing, then i put new timing belt-still nothing, checked fuel filter...


The engine needs three things to run, fuel, air and a spark at the right moment. Check the static timing of the motor, if those marks line up. You did not say you were getting any spark at the plugs. If you have spark, then try a little starting fuild into the intake while turning it over. If you have fuel delivery to the cylinders, the spark is coming at the right moment then it should be running. Any error codes set?

Aug 26, 2009 | 2001 Ford Escort ZX2

Not finding what you are looking for?
2000 Toyota Camry Logo

Related Topics:

94 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...