SOURCE: 2005 SATURN VUE ABS, AWD, R/FRONT BEARING REPLACEMENT
just did one today. removed housing from car, and used a press . be careful of aluminum housing. also used penatrating spray. clean oxidation from inside bearing hole,then lubricating, helped in installation
SOURCE: abs light on after replacing hub bearing
Sounds like the ABS sensor has failed, or is unplugged. If someone did the work for you, take it back. Otherwise check the sensor on the right front. Replace as necessary. Also ask the Q at MyFordFreestyle.com
SOURCE: Replacing passenger side front wheel bearing on
use a hammer to tap on the head of the shaft to push it back out, put a small block of wood on it before hitting it so you dont mushroom the end or distort the threads.
Good luck!!
SOURCE: TORQUE SETTING ON FRONT WHEEL BEARING NUT ON 2006
Hello, here is the torque spec for front hub bearing
Strut to Steering Knuckle Bolt and Nut
180 N·m
133 lb ft
Tie Rod Retention Nut
50 N·m
37 lb ft
Wheel Bearing/Hub Mounting Bolt
130 N·m
96 lb ft
Wheel Drive Shaft Spindle Nut
205 N·m
157 lb ft
SOURCE: I have replaced the front passenger side wheel hub
it is most likely a bad wheel bearing, but it maybe the other side, some times the noise will carry threw the front end and make you think is the other side, we have a rule in my shop we never replace one wheel bearing we alwise replace both bearing on the end we are working on if the customer does not want that then we send them to another shop, the reason we do this is for just the thing you have going on it just saves allot of problems, and we never use cheep hubs, never use auto-zone or advanced or O'rileys, we had to warranty 12 hubs from auto zone in one year, i have never had to warranty a napa hub in 25 years, it just does not pay to save a few dollars. and all though it most likely is a wheel bearing there is a small chance it might be a carrier bearing in the front differential it would also go away when going around a corner but if you remove the wheel bearing and turn them by hand you can feal if the bearing has a bad spot. if the bearings feal good then pull the front differential.....GOOD LUCK
578 views
Usually answered in minutes!
×