Question about 1990 Toyota Celica

2 Answers

How do you change a rear signal bulb in a 1990 toyota celica?

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

Hi ders a plastic cap on the top of your rear light when u open the boot door,take out the screw under it and pop the cover off the orange piece on the side n unscrew the bolt..carefuly...it should just pop off then

Posted on Jul 22, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Open the boot and as you look directly down from above you'll see a little black plastic piece which pops out revealing one screw, undo that and the orange louvered plastic light cover clips out revealing the rest of the screws you need to undo. There's then just 2 little rods that clip the light housing into position. Firmly tug the housing to remove then from the back, turn the corresponding light backing anti clockwise to unlock it. Remove old bulb by firmly but gently pushing it in and turn it to the left. Now just insert new globe and work your way backwards thru the same process to put it back together ;)

Posted on Aug 24, 2015

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i change the cabin air filter on my 1990 toyota celica?


This vehicle is not equipped with a cabin air filter

Oct 18, 2015 | 1990 Toyota Celica

1 Answer

I have a 1990 toyota celica when its cold the idle goes from bout 1000 to 2000 back and forth check engine light is on what cold its be or where should i start


Faulty engine temperature sensor ?? On a cold start the temperature sensor should detect a cold engine and give a signal to the ecu to increase fuel ratio until the engine has warmed up. sounds like faulty sensor to me.

Mar 02, 2015 | 1990 Toyota Celica

1 Answer

Need a serpentine belt digram for a celica gt4 1990


Click on the following direct, Free Link. It has the Drive Belt Diagrams for your 1990 Toyota Celica depending on your Engine Options. It has several other Diagrams that will be very helpful for you.

Let me know if this helped....

http://www.2carpros.com/car_repair_information/year/1990/make/toyota/model/celica/1990_toyota_celica_drive_belt_routing_diagram.htm

Apr 13, 2010 | 1990 Toyota Celica

1 Answer

Can't remove dash from 1990 toyota celica to replace dash bulbs


hi i had d same problem with my gt4,i lightly wedged a piece of hard plastic between any gap n popped open the clips,be careful tho

Jun 24, 2009 | 1990 Toyota Celica

2 Answers

''how do you change an ignition switch on a 1990 toyota celica


I don't want to be a smartA...but you don't. This job is reserved for a good mechanic.
Sorry!

Jun 23, 2009 | 1990 Toyota Celica

1 Answer

How do you change the headlight bulb (low beam) on the passenger side of a 2000 toyota celica?


You should be able to access the buld holder from the rear of the headlight. It's a nylon bulb holder with a lock thing on it. You squeeze the lock part and turn it counterclock wise, and it should come out. Remove the old bulb and install the new one being careful not to touch the glass of the new bulb with bare fingers. The finger print you will leave can cause the bulb to prematurely die on you.

Jun 15, 2009 | 2000 Toyota Celica

2 Answers

Replace a tail light bulb


If there is no "access panel" at the rear panel, look to see if there are any exterior screws around the lamp housing. If not, you have to remove the interior trim panel(s) from inside the car. Under there, you will find 3-4 8 or 10 millimeter nuts. Remove them, and pull the whole housing out.

Sep 25, 2008 | 1990 Toyota Celica

1 Answer

Rear turn signal light bulb replacement


Yes, and easy access from the trunk. You will be able to remove the bolts from inside and the light assembly will be able to be pulled from the externior to replace all of them. It is not a real quick process, so when one goes out, I usually replace all of them.

Jul 23, 2008 | 1992 Toyota Celica

Not finding what you are looking for?
1990 Toyota Celica Logo

Related Topics:

130 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...