Question about 1994 Chevrolet S-10

1 Answer

Window doesn't work right

The passanger side nfront window only goes down a little bit then stops working all together. let it rest a while and it does the same thing. I thought it was the motor but I REPLACED THE DOOR AND it does the same thing! help

Posted by on

  • fbdennis Jun 22, 2009

    yes it does the same thing from both controls

  • DannyW1 May 11, 2010

    does it happen from both the passenger control and the drivers side control?

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 84 Answers

This is a very common problem and is caused by a weak motor. The motors get weak from drag in the window channels. Try spraying silicone spray in the channels where the windows slide in front and back. And unless you got a new motor, chances are the used one will do the same thing.

Posted on Jun 22, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rear passanger side window won't go up or down


Window regulator most likely but before changing it out take the door panel off and apply current to the contacts of the actualy regulator. If the window goes up then switch the contacts and now it will go down. If nothing then regulator (window motor) is bad. If it works then your master control switch for all the windows is going bad.

Aug 30, 2012 | Cars & Trucks

1 Answer

Window dont go up all the way


regulator or electric motor probably worn out. could be both. recommend changing both together. take about an hour to replace diy. thanks

Aug 28, 2012 | Chevrolet Impala Cars & Trucks

2 Answers

2000 ford f250 passanger side window wont go up


Check the wires on the driver's door between the door and the post. A break in a wire will affect the passenger side.

Apr 04, 2012 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

The window on the driver side of my can does not go down but the rest of the windows of the car do. can this be a fuse problem? another thing, the window on the front passanger side does go down when the...


The driver side; it could be a dead motor. Do you hear the motor trying to go down? If there's nothing, its probably shot. But it wouldn't hurt to check the fuses to see if one is blown.

The 2nd question I do not understand. You say the window on the passenger side goes down when the button is pressed down. As its supposed to. So I am unsure about what you're asking there.

Aug 26, 2011 | Lexus ES 300 Cars & Trucks

1 Answer

The driver side master control buttons dont work?i cant roll down my window, ajust my mirror or lock / unlock any doors? my passanger side and both back seat passangers door controls work. MY QUESTION IS...


The little metal contacts inside the switch havecorroded. I have torn apart the switches and sanded the contacts severaltimes and they always worked afterward. Just be careful and watch what you are doing. They are a little tricky but if you mess up then the switch at the wrecking yard will cost you all of 5.00 or ten bucks. Do not buy it new. You will loose an arm. I have never messed up though. Ilike saving my money to much. Good Luck, I hope this helped, The Raz

Apr 16, 2010 | 2002 Pontiac Bonneville

1 Answer

2003 Boniville windows stopped working drivers side


should be a place to pop the clips at the bottom of the door mine does that 2 but i can putt them up from the back door if its those windows

Feb 06, 2010 | 2003 Pontiac Bonneville

1 Answer

Passenger window won't move


If it works a bit and stops and then will work a bit again and stop, odds are the motor is going and requires to be replaced.

You can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Pull back the weather seal and you'll be able to swap out the motor which is held on by a few bolts

Sep 04, 2009 | 2001 Dodge Grand Caravan

1 Answer

Help me with my window


The right side is the passengers side does the window go down using the drivers side switch? If it doesn't work from either side switch its probably the power wire going to the down side of the switch. Check for power at the Wire on switch both sides and make sure you have power going to both up and down side, Sometimes the wires get broken in between the door and door jam, By getting pinched, Hope that helps ya out Thanks

Jun 17, 2008 | 2003 Chevrolet Venture Passanger

Not finding what you are looking for?
1994 Chevrolet S-10 Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...