Question about 1997 Chrysler Sebring

Open Question

1997 sebring jxi bad transmission solenoid

Brought my 1997 sebring jxi which has a 139000 miles on it to a local store because the engine light came on they hooked up to check codes and it said the transmission solenoid went bad. 1 can I still drive it 2 can I fix this myself and 3 how much to replace and install from a shop thanks.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 10 Answers

SOURCE: 1997 Chrysler Sebring jxi

Are you trying to replace one of the turn/hazard signal bulbs? If so, which one. The backside of the bulb will turn about a quarter turn and come out the back side of the housing then you can change the bulb out as usual.

Posted on Sep 05, 2008

Ad
  • 1 Answer

SOURCE: Replacing headlight in 1996 Chrysler Sebring JXI

piece of cake....
take off the two "star" bolts, one toward the center of the engine above the light assembly and the other toward the fender (it is very long). when you remove them both the entier assembly falls off into your hands and makes changing the bulbs much easier.

Posted on Sep 16, 2008

  • 158 Answers

SOURCE: 2000 sebring transmission pan torque spec

10 ft lbs no real patterm needed

Posted on Apr 03, 2009

  • 20 Answers

SOURCE: 98 Sebring JXI turn signals work right/left and

A fast flash at the dash indicates there is a bulb out somewhere.
Have someone check all the bulbs outside while you try the brakes, lights and turn signals.

Posted on Aug 05, 2009

  • 1 Answer

SOURCE: 98 sebring jxi convertible. water pools in my back floor board

Sebring Convertibles have weep holes under the body that get clogged with debris and cause the water to back up into the floor. Take a paper clip and straighten it to clean out the weep holes. The weep holes can be found just under the frame at the doors where there is a seam(about where the jack would go). Along this seam about ervery 12 or 16 inches there will be a small slot for the water to drain.

Posted on Sep 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1997 chrysler sebring jxi no start


Do head lights stay on (bright) while trying to crank starter? If not, starter motor isn't getting enough current, OR engine is locked. Is there current getting through the solenoid to starter motor? Check the ground connection between the engine and chassis as well as battery and chassis.

Jul 02, 2012 | Chrysler Cars & Trucks

2 Answers

How do you reset the service engine soon light on a 97 sebring jxi convertable


You will need to retrieve the trouble code(s) stored in the computer and repair the problem associated with that code.You cab buy a tool for less than 70 dollars that will read and erase the code at a chain parts store.This is not a maintenance light or an oil change indicator.This light is part of the onboard diagnostics.Good luck!

Mar 09, 2011 | 1997 Chrysler Sebring

1 Answer

1999 chrysler sebring convertible jxi code p1495 intermittant shut off while driving. Replaced fuel pump and filter, distributor, spark plugs and wire. Was advised by ZJLimited to remove connector from the...


replacing the fuel pump relay is one thing but what about the (ASD auto-shut down) relay

additionally...
  • what engine size?
  • what transmission?
  • any codes?
  • does the pump run KOEO?
  • Do you have spark?
  • What is the cranking speed?

you may find faster service by subscribing to a "live chat" since there are so many questions and variables in your concern

Jun 03, 2010 | 1999 Chrysler Sebring

1 Answer

I own a Chrysler Sebring JXI 2.o liter 1999 and thermostat is bad


Vickie I strongly suggest you pick up a $20 repair manual at your local parts store. NEVER work on a cooling system when its hot. A cheap tool set from a very large retail store should have the metric tools required for the job. The book will have lots of pics & easy to follow instructions. Don't get frustrated, get informed. I worked professionally on cars for 20 years & I still start alot of jobs just like that

Oct 10, 2009 | 2004 Chevrolet TrailBlazer

2 Answers

My 2002 Chrysler Sebring LX Convertible had the Check Engine light came on and now the transmission won't shift except intermittently. It seems to be in second gear. Most of the time


The check engine light came on probably because it detected an error with your car. In this case, it sounds like the error is with your transmission. Most likely a bad solenoid. Bring the car to a place like Autozone where they will scan your car for free to retrieve the code(s) that will point to where the issue is.

Sep 15, 2009 | 2002 Chrysler Sebring

2 Answers

My 1997 JXI Convertible, 2.5 liter engine, won't start.


I need a bit more info, just what is it doing, or not doing?

Aug 13, 2009 | 1997 Chrysler Sebring

1 Answer

Service engine soon in sebring 1997


You can still drive it with the engine light on. It may not run too well or you may not notice any difference at all. If the light flashes on and off while driving then you shouldn't drive it because damage to the catalytic converter may be a result. I hope this helps.

May 22, 2009 | 1997 Chrysler Sebring

1 Answer

1997 jxi seabring


everything I am reading leads me to believe that the crankshaft positioning sensor makes this happen in a lot of sebrings. It doesn't show up in a computer diagnostic test either. good luck.

Apr 15, 2009 | 1997 Chrysler Sebring

1 Answer

Replacing headlight in 1996 Chrysler Sebring JXI


piece of cake....
take off the two "star" bolts, one toward the center of the engine above the light assembly and the other toward the fender (it is very long). when you remove them both the entier assembly falls off into your hands and makes changing the bulbs much easier.

Aug 25, 2008 | 1996 Chrysler Sebring

Not finding what you are looking for?
1997 Chrysler Sebring Logo

163 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8557 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...