Question about 1999 Lincoln Continental

1 Answer

Rear pass window does not close solonoid clicks no load on lights

Window will not close

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 63 Answers

Then power is not reaching the motor ie bad connection past relay or the motor is toast, worn so badly theirs no connection through brushes. Some times just dirty or carbon build up. Low voltage is usually the culprit, running accessories like these without the engine running or with a weak battery can result in excessive heat and arcing can occur causing carbon deposits making contact impossible. Sometime slamming the door will instigate contact and it will run for a bit but the damage is done and repairs from cleaning to replacing are in order.

Posted on Jun 20, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

96 ford ranger starter solonoid clicks but will not engage fly wheel. replaced starter solonoid on fender well.now clicks more than once but will not do anything else.


You will need a helper for this.turn on head lights then try to start if lights go dim or out clean all battery connections even if they're tight use a wire brush to clean corrosion to bare metal then retry

Mar 14, 2017 | Ford Ranger Cars & Trucks

1 Answer

Rear heater and rear window break light not working


Is this a hatchback? check the wiring, where it goes from the tailgate to the vehicle body, passed experience, continual opening and closing the tailgate causes the wiring to flex and break. The wiring is usually in a rubber sleeve.

Dec 27, 2013 | 2003 Hyundai Tiburon

1 Answer

Driver's rear window froze in down position, & Passenger's rear window froze in the closed position after spilling a Super Grande Diet Fountain Drink! I removed, cleaned, and reinstalled the switches, &,...


I fix things like that alot. Usually the wires passing through the hinge have been folded back and forth too many times and one or more wires broke. You can close the window using a 12 volt battery alligator clipped to the motor if needed. Reverse the polarity to open the window.

Nov 04, 2013 | 2003 BMW 325

1 Answer

2001 Pontiac Montana rear power windows opened and now they are both not closeing. There is no fuse and I can't close my windows. Please help me.


Power for the rear quarter windows passes through the 10A PWR QTR VENT fuse in the fuse block. 12V is applied to the rearquarter window switch which controls the open and close operation of the windows. If the fuse checks OK, the window actuators and motors are all that's left

Sep 16, 2012 | Cars & Trucks

2 Answers

Battery seems fine good lights on dash when turned on but will not turn engine over it won`t even try


There are several possibilities for you to investigate. When the key is in the start position do you should hear a click from the starter solonoid? If so then you know that power is getting to the starter solonoid which eliminates a bad ignition switch. In that case you may have a bad starter. If you hear no click then you must get a test light and use it to see if power is getting to the starter solonoid. Ground the light and place the tip on the energizer wire to the solonoid. When an assistant turns the key to the start position the test light should light. This tells you power is where it should be and the solonoid is not working. If there is no power there then you must suspect a bad ignition switch or a bad wire in between the switch and the starter. Hope this helps.

Dec 28, 2010 | 2001 Volkswagen Golf

1 Answer

My power window to my toyota tundra (2002)passenger window does not move up/down. Press switch, and no sound, no movement. what can I do to restore power?


try using the window switch on the pass side and drivers side. is the master turned on to allow the pass switch on? try closing the pass door while holding the switch in the DOWN position, sometimes this will jar the window loose. If you watch the dome light real closely while pushing the window switch down, it should dim slightly, it it does dim, then the switch is working.

Oct 09, 2009 | 2002 Toyota Tundra

2 Answers

Put in a new starter and all you get is a clicking sound and wont start why wont it start what did i do wrong


Providing the battery is fully charged, and the cables are tight and clean, you may have the wires on wrong. They may be grounding against the block, or on backwards. If that all checks out, maybe you got a dud starter.

Aug 12, 2009 | 1996 Dodge Neon

Not finding what you are looking for?
1999 Lincoln Continental Logo

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

Marvin
Marvin

Level 3 Expert

81423 Answers

gerry bissi

Level 3 Expert

4376 Answers

fordexpert

Level 3 Expert

5687 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...