Question about 1990 GMC Sierra

1 Answer

Need to remove starter from 1990 GMC Sierra C1500

That about summarizes it. It won't start unless I jiggle the positive starter cable.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 34 Answers

Check cable at both ends make sure its tight.move it @ starter see if post on solenoid is loose.remove battery negative before taking out starter

Posted on Jun 20, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1996 GMC Sierra C1500. I'm totaly new to


A bad fuel pump will not keep the engine from turning over. I would first test your battery and make sure your connections are clean. If that check out I would check your starter and starter relay.

May 10, 2011 | 1996 GMC Sierra

2 Answers

My 1990 gmc sierria lost all electrical power, I was fine tuning the timing and took it for a ride and she totally shut down will not turn over, battery is at 13 amps?


can you jump starter at the starter. I'm sure it is a neg or positive cable that has lost contact. check ground cable,clean and tighten, check positive connection at starter and at terminal on battery

Feb 02, 2011 | 1990 GMC Sierra

1 Answer

1994 GMC C1500 4.3 truck 2WD automatic , turn key won't start, no click noise (silent), lots of battery power, replaced starter 1 week ago.


do your headlights come on bright.if not check your battery cables or all your fuses.if so could be fuse or starter sol.has burned out.

Nov 26, 2010 | 1994 GMC Sierra

1 Answer

My transmission felt like it was slipping, then my truck, a 1995 GMC Sierra C1500,lost all power and dies, would not restart, all dash lights came on and sounded like flashers were on also with the key OUT...


if there is any corrosion between your battery cables and terminals you need to clean them real well i have a 1995 chevrolet silverado and i just delt with a similar starting problem there should be 2 cables attached to the positive (+) side pull the 2 cables apart and clean in between them real well the next cheapest thing woul be the starter the ignition switch is exspensive

Jun 29, 2010 | 1995 GMC Sierra C1500

1 Answer

How to replace starter 2002 GMC Sierra 2500 Duramax HD


Enjoy this...jack up truck, remove tire, remove plastic cowling and expose front right wheel well.you may want to wash this side of engine at this point. Remove battery cables, remove the 13 mm nut and 8mm nuts on the solenoid. take a 15mm socket and remove the upper aand lower holding bolts. Use an extra long extension for the lower bolt. Ratchet out in front of the A-arm. Dislocate the starter from the fly wheel side of starter. wiggle,jiggle and point the starter gear at a 45 down and PULL starter out and down.

Mar 26, 2010 | 2002 GMC Sierra 2500HD

1 Answer

How do you install an alternator 95 gmc sierra 1500


1] disconnect the positive battery cable. 2] remove the serpentine belt.  you need a socket wrench to remove the tension from the idler arm pulley. 3]disconnect the battery wire from the alternator, and unclip the other smaller wire from the other side of the alternator. 4] remove the bolts that hold the alternator to the engine. 5]install the new one in the reverse order hope this helps

Jun 04, 2009 | 1995 GMC Sierra C1500

1 Answer

1990 gmc sierra 4x4 starts fine 3 times then won't turn over,wait an hour or two then turns over and starts.lights and gauges activate fine when attempting to start and can hear the relays(drl and...


does the starter make a "clicking noise" when it wont turn over? check your battery cables at the battery and at the starter solenoid....if it not a connection , then it sounds like a bad starter relay/solenoid

Feb 22, 2009 | 1990 GMC Sierra

1 Answer

Replace starter on 1992 GMC Sierra pickup truck


First thing unhook positive battery cable, unhook main cable on starter selanoid and small wire on selanoid (there may be 2 small wires) There may be a bracket on front of starter that has to be removed, and then the 2 main bolts that hold it to engine block and it should come out.

Feb 14, 2009 | 1992 GMC Sierra

1 Answer

1990 gmc sierra


check the postive cable going to starter .check mounting clips on cable for wear into cable.the next thing i check the starter if you take it off autozone will check it free

Oct 22, 2008 | 1990 GMC Sierra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

253 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...