Question about Mitsubishi Lancer

Open Question

Horn was jamed - Lancer Mitsubishi Cars & Trucks

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Were is horn relay for sc1 1.9 4 cyl. saturn 1999


The horn system consists of a single horn, a horn relay located in the underhood fuse block, and driver controlled horn switch in the steering wheel. The horn system is designed to provide the driver with an audible warning to signal pedestrians, other drivers, etc.
Operation
Voltage is supplied to the horn relay coil and contacts at all times through a 10 amp HORN fuse, located in the underhood fuse block. When the driver pushes the horn pad, driver air bag module, the circuit completes and energizes the horn relay coil. This causes the horn relay contact to close. When the contact closes, current travels to the horn and the horn emits an audible warning.

Nov 18, 2016 | Saturn Cars & Trucks

2 Answers

Removed the only wire connected to horn it now is only held and connected to frame by a single bolt. Afraid to wire in air horn because horn still sounds even though it has no wire connected to it.


Hi Christian:
Many vehicles have 2 horns so that the sound is more pleasant. If there is no wire connected to a horn, it can not (in my experience) make any sound. May I suggest that you have someone assist you by tapping the horn button while you locate the horn that is sounding.

Sep 16, 2015 | 2000 Isuzu VehiCROSS

1 Answer

For 2004 ford truck f150 extended cab, I found the horn fuse, where is the horn relay?


disconnect the horn or horns, operate the horn and see if the fuse still blows. if the fuse still blows then there is most likely a short in the wiring. relays rarely cause shorts. if the fuse doesnt blow with the horn disconnected, reconnect the horn and operate the horn again, if the fuse blows you have a shorted horn.

Jul 14, 2012 | 2004 Ford F150

1 Answer

Horn does not work, horn buttons are good, horn contact in steering cololm is good, battery level is good, can't find a fuse in fuse box for horn.


if you take a test light and test all the fuses in the fuse box and if they are good then when pushing on the horn button you can usually hear the horn relay working(click).if it does then you need to check the horn itself.take a wire and run it from the battery positive cable and connect it to were the horn wire connects to the horn,it should blow(make sure of a good connection),if it does then it could be a dirty connection at the horn.if it doesn`t blow then the horn needs replacing.you can also use the test light and test for power at the horn wire at the horn itself to see if the horn is being feed power from the horn button to the horn.

Jul 25, 2011 | Pontiac Firebird Cars & Trucks

2 Answers

The horn doesn't work. where is it located?


The horn is located at the front of the vehicle near the radiator. Before you even look at the horn, check the fuse - the horn has its own fuse. Then check the horn relay and then the horn. Lastly, if the horn still does not work check the horn switch/button

May 17, 2011 | 1997 Saturn SL

1 Answer

How can I disable my honda accord's horn cable?


just pull the horn fuse out of the fuse panel. That would be safer, and easier. Hope this helps, James Booth

May 17, 2011 | 2000 Honda Accord

2 Answers

Where is the horn relay?


The dealer can hook up his diagnostic tool and retrieve the fault code. -------------- SECTION 413-06: Horn 2003 Expedition/Navigator Workshop Manual DESCRIPTION AND OPERATION Horn Horn components include the following items:
  • clockspring
  • horn relay
  • horns
  • steering wheel pad horn switch
Horn switches The horn switch is incorporated into the driver side air bag module in the steering wheel. The switch is powered through the clockspring and grounded through the steering column. For removal and installation of the horn switch, refer to Section 501-20B .
Horn relay The horn relay is incorperated into the central junction box (CJB). The central junction box is located behind the passenger lower kick panel.
------------------------------------------------------------
Symptom Chart
Symptom Chart Condition Possible Sources Action
  • The horn does not sound
  • Central junction box (CJB).
  • CJB fuse 26 (20A).
  • Circuitry.
  • Horn switch.
  • Horn.
  • Clockspring.
  • Powertrain control module (PCM).
  • Go To Pinpoint Test A .
  • The horn sounds continuously
  • Central junction box (CJB).
  • Circuitry.
  • Horn switch.
  • Horn.
  • Vehicle security module.
  • Tire pressure monitor (TPM) module.
  • Clockspring
  • Go To Pinpoint Test B .

Dec 16, 2009 | 2003 Ford Expedition

1 Answer

Location of horn on 1997 dodge caravan


the horn is in the fender on the drive side '' and in some molds right in frount of the radater look thourgh your frount grel and you should find it thanks''' my name is james you can e-mail me at '' jay_win2002@yahoo.com.

Jan 30, 2009 | 1997 Dodge Caravan

1 Answer

Horn Wiring 2000 Mercury Mountaineer


no/ you have 2 horns your right about that but its one wire connector for each horn usually one horn on the right and the other on the left/ the horns should be slide in connector and if he cut them for one doesnt seem right/ I bet that was the problem he tried using the same wire from the original horns when he kind of grounded the horn so it would not work / but there is only one wire per horn/ Please rate my response/ Thank you very much

Jan 17, 2009 | 2000 Mercury Mountaineer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...