Question about 2007 Chrysler Pacifica FWD New Cars

Open Question

Replacing motor mounts 2007 Chrysler Pacifica 4.0

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

csmock132
  • 4669 Answers

SOURCE: replace the engine motor mounts and the transmission mount. Would like to know how to do it. Thanks.

Check the frame mounts too. You will have to loosen the bolts and jack the motor up with a jack and a woodblock.

Posted on May 04, 2009

rteemon
  • 578 Answers

SOURCE: 2007 Chrysler Pacifica Touring Edition 4.0L. Trunk

have your deaker check trunk model and motor

Posted on Jul 01, 2009

jturcotte
  • 7710 Answers

SOURCE: where can I find a

3.5L engine?

8fe7d61.gifd8f14c0.gifac805da.gif

Posted on Oct 01, 2010

chargerhp
  • 813 Answers

SOURCE: i need to replace a heater blower motor on a 2004

  1. Disconnect and isolate the negative battery cable.
  2. Remove the passenger side cowl trim panel. See: Body and Frame\Interior Moulding / Trim\Trim Panel\Service and Repair\Cowl Trim
  3. Pull back the carpet to access the front upper screw that secures the air inlet housing.
  4. Remove the recirculation door actuator.
  5. Remove the recirculation door actuator wire lead from the routing clip located on the lower air inlet housing and position the wire lead aside.
  6. Disconnect the blower motor wire lead connector from the blower motor resistor or power module, depending on application.

118348823 Lower Air Inlet Housing

  1. Remove the one screw (from the top) that secures the lower air inlet housing to the upper air inlet housing.
  2. Remove the four screws (from the bottom) that secure the lower air inlet housing to the upper air inlet housing and remove the lower HVAC housing.

118348824 Blower Motor Wire Lead Grommet

  1. Push the rubber blower motor wire lead grommet through the opening in the lower air inlet housing.
  2. Feed the blower motor wire lead through the opening in the lower air inlet housing and remove the lower air inlet housing from the vehicle.
  3. Position the recirculation-air door as necessary to access and remove the three screws that secure the blower motor to the lower half of the HVAC housing.
  4. Gently flex the recirculation air door far down enough to remove the blower motor and wheel from the HVAC housing.

118348825 Blower Motor Mounting Tabs

  1. Remove the blower motor and wheel from the HVAC housing. Note the position of the blower motor mounting tabs.
INSTALLATION

  1. Position the blower motor and wheel to the lower half of the HVAC housing. Align the blower motor mounting tabs to the correct location on the HVAC housing.
  2. Gently flex the recirculation-air door far down enough to install the blower motor and
11_29_2011_6_18_00_pm.gif11_29_2011_6_18_20_pm.gif11_29_2011_6_18_40_pm.gif

Posted on Nov 29, 2011

chargerhp
  • 813 Answers

SOURCE: change front motor mount 2005 chrysler pacifica

There is not a mount on the front

Posted on Dec 21, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 chrysler pacifica 4.0 awd when maintaining 35mph rpm will flucuate.


Start with cleaning the throttle body and idle air control motor. Check and replace air filter if needed.

Dec 26, 2016 | 2007 Chrysler Pacifica

2 Answers

Why does my 07 Chrysler Pacifica feel like its going to vibrate off the road with acceleration at 40 - 60 Mph?


2007 Chrysler Pacifica Problems, Defects & Complaints

www.carcomplaints.com/Chrysler/Pacifica/2007/
5 days ago - The 2007 Chrysler Pacifica has 97 problems & defects reported by Pacifica owners. The worst complaints are engine, transmission, and ...‎Engine - ‎TSBs 13 - ‎Crash Tests 2 - ‎Defect Investigations 2

Aug 03, 2015 | 2007 Chrysler Pacifica Touring

1 Answer

Front motor mount needs replacement


front motor mount is the mount at the front of the engine not the front of the car

Jul 12, 2015 | 2005 Chrysler Pacifica AWD

1 Answer

Which cylinder is number 4 on a 2007 chrysler pacifica 4.0


cylinder # 4 is the middle of the forward facing head(radiator side)also known as bank 2 which is cylinders 2,4,6 the back head (bank 1) is cylinders 1,3,5

Mar 19, 2015 | 2007 Chrysler Pacifica

1 Answer

Where are the spark plugs located on a 2007 chrysler pacifica?


Usually just above the pistons in the engine located under the hood.

Apr 28, 2013 | 2007 Chrysler Pacifica FWD New Cars

1 Answer

2007 chrysler pacifica cruise control not working


2007 Chrysler Pacifica 4 0 engine cruise not working

Jan 07, 2011 | Chrysler Pacifica Cars & Trucks

Not finding what you are looking for?
2007 Chrysler Pacifica FWD New Cars Logo

Related Topics:

159 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...