Question about 1998 Chevrolet Blazer

1 Answer

98 Chevy Blazer wont start after replacing heads

Chevy Blazer wont start after replacing heads. Now no fuel pressure. Need serious trouble shooting. Recently replaced spider fuel system.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 26 Answers

Make sure you have power to the fuel pump. On this model you should hear a quiet high pitched mosquito in your ear sound when you have all the lights on the dash panel just before you turnover the engine. If push comes to shove, take the fuel pump out, keep the power on it and run it through a bucket to see if you can at least pump water through it. Make sure you let it dry out all the way though before placing back in the tank.

Posted on Apr 23, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 chevy blazer wont start got fuel to engine


You can check for spark by stick screwdriver in disconnected spark plug wire and hold close to ground metal, such as valve cover and see if you get a spark. Be careful, these voltages are very high. If you don't have a spark then trouble shooting is narrowed down.

Jan 15, 2013 | 2002 Chevrolet Blazer

1 Answer

96 chevy blazer turns over but wont start


It needs at least 60psi fuel pressue to start. You need to check fuel pressure with a gauge.
If the dist cap or rotor is bad, the spark will not be on the right plug at the right time. Same goes for a faulty distributor or a problem with the timing chain. And the ignition module.
Also check the ecm for trouble codes.

Jun 29, 2012 | 1996 Chevrolet Blazer

5 Answers

2001 blazer will crank fine but wont start unless


what is the fuel pump pressure for a 2001 chevrolet blazer 4.3

Oct 21, 2009 | Chevrolet Blazer Cars & Trucks

1 Answer

I have a 1996 chevy blazer replaced the fuel and


No, the fuel pressure valve may be stuck open so that the fuel pressure is too low when you start up, but the pump keeps up after the engine starts...
The fuel pressure valve is draining the fuel back into the fuel tank when the Blazer is parked.


Sep 28, 2009 | 1996 Chevrolet Blazer

1 Answer

Chevy Blazer won't start; fuel pump needs replacing


Before spending several hundres on a fuel pump, I recommend doing a fuel pressure test. You can get a test gauge pretty cheap at a parts store. If the pump is junk, you raise the truck, lower the fuel tank, unplug the electronics from the pump at the top of the tank, then with a hammer and flat head scrwedrive, gently tap the lock ring in a counter clockwise direction until it pops off. Pull the pump assembly out and install the new one. Reverse directions to install.

Jun 02, 2009 | 2001 Chevrolet Blazer

1 Answer

1999 chevy blazer wont start


THE FUEL PUMP IS BAD.

if your losing fuel pressure after the pump runs the drain back valve in the pump has failed.

and i doubt that you are seeing enough fuel pressure to run a vortec engine.

low fuel pressure equals a non running vortec

Apr 11, 2009 | 1999 Chevrolet Blazer

2 Answers

1998 chevy blazer 4 wheel drive


You need to check the fuel press, the test port in on the rail, also run a code test on the ECM/PCM, this checks for trouble codes and also lets you know the computer is working if it tests ok.

Nov 26, 2008 | 1998 Chevrolet Blazer

3 Answers

2003 Chevy Blazer won't start


have the computer checked out. may need reprogramming and have updates added. also check for loose or corroded connections at the terminals.

Aug 27, 2008 | 2003 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...