Question about 2001 Chevrolet Blazer

2 Answers

No power in 1st or 5th; spits, pops and sputters

2nd, 3rd and 4th gear are perfect. My brother has a 2000 Chevy Blazer 4.3. He has replaced the fuel pump, fuel filter, cap, rotor, wires, plugs, air cleaner. Still no change.

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 2 Answers

Catallitic converter pluged

Posted on Jan 21, 2014

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 109 Answers

Possible EGR Valve sticking open cause unmetered air leak

Posted on Jun 23, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 98 Chevy blazor 4.3 4x4 it has no power and sputters change fuel filter,mass air sensor,o2 sensor,plugs,wires,cap,rotor,module on desributer check fuel pump psi at 55 to 57 the only code random...


Pull the distributor. Check the gear on the bottom of it. Replace a bunch of them for wear. Causes no power and bad timing. Depending on wear. Replace the gear or the distributor.

Nov 08, 2014 | 1998 Chevrolet Blazer

1 Answer

I have a 90 ford ranger 2.9l. It seems to be


check fuel pressure on fuel pump might be getting weak

Oct 05, 2014 | Cars & Trucks

1 Answer

My 2000 chevy blazer will file but wont start sometimes


not knowing the condition of you suv, replace fuel & air filters, very important, replace distributor cap & rotor, spark plugs & plug wires. that should do it, good luck

Mar 10, 2013 | 2000 Chevrolet Blazer

1 Answer

My 01 4.3 vortec blazer starts stumbling when at red lights and stop signs any suggestions


Could be the EGR valve or the idle adjust valve. Check Engine light on? Any codes?

Oct 14, 2012 | 2001 Chevrolet Chevrolet Blazer

2 Answers

98 chevy blazer misfires when cold


what about the temperature sensor which is the one according to message given to ECU get the correct quantity of fuel ?

Aug 17, 2012 | 1998 Chevrolet Blazer

1 Answer

Ai have a 88 chevy s-10 blazer it stall when i drive a block like it starts to cut out does it need a fuel filter, if so is it under the truck or does it need spark plugs only or does air filter only...


I suggest a full tune up.

1. Air filter.
2. Fuel filter, carbureted engine filter is located inside the line fitting where it attaches to the carburetor. Fuel injected engine filter is located in-line under the truck near the tank.
3. Oil and filter.
4. Spark plugs and wires.
5. Distributor cap and rotor if applicable.
6. PCV valve.

Mar 17, 2011 | 1988 Chevrolet Blazer

1 Answer

I have a 2000 s-10 blazer 2wd vortec 6 it has been a great truck .Lately it has balked on the road,when in out of gear it will not rev over 2500 rpm,when driving its slow to pick up ,sometimes...


Check fuel pressure wit a guage at schrader valve on fuel rail with key on and engine not running. The pressure needs to be 55 to 61 PSI. If it is less than 55 PSI, replace the fuel pump in gas tank and fuel filter. If it is more than 61 PSI, replace fuel pressure regulator.

Feb 21, 2010 | 2000 Chevrolet Blazer

1 Answer

90 mk2 mr2, recent engine fitted from rev 3 37,000 miles. was going up hill, normal speed and it became reallt sluggish on me, had to down shift to 4th and it died in 4th and 3rd then 2nd, replaced plugs,...


fuel pump? fuel filter? clogged cat? clogged injectors? dirty cap?  dead rotor?  is spark wiring correct? timing right? no idea.  good luck.

May 18, 2009 | 1991 Toyota MR2

1 Answer

I have a 2000 Chevy Blazer I have replaced


maf sensor, tps sensor,or timing gear

Apr 16, 2009 | 2000 Chevrolet Blazer

2 Answers

Jeep wrangler stalls out


check maf and tps sensor

Feb 18, 2009 | 1988 Jeep Wrangler

Not finding what you are looking for?
2001 Chevrolet Blazer Logo

238 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

82322 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22382 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...