Question about 1992 Toyota Pickup

1 Answer

Engine swap I have a 1992 toyota pick up ext cap 4x4 wtih 22re engine i want a v-6 is there any v-6 engines i can put in this truck where all i will have to do is a quick swap no fab work or very little??

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 53 Answers

Yes, the web site called northwestoffroad.com order the $5.00 mag. has all u need. also check website LG engineering.com. but what ever u do don't install a 3.0l v6 toyota truck engine has no power. good luck

Posted on Jun 20, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

22re engine


go to www.automecanico.com and translate with your browser this amazing website and fix it.
God bless you

Jul 15, 2013 | 1992 Toyota Pickup

1 Answer

1992 toyota 22re flooding out


Check your choke unloader. This is a vacuum operated device that opens the choke slightly, after the engine has started. When this device fail, you go way too ruch.

Mar 07, 2013 | Cars & Trucks

1 Answer

1992 toyota 22re fluids out and puts out a lot of fume out the exhast


Floods out.Multiple causes.How does it run when warmed up?Still stink?
Check injectors: Run the engine up to 3,000 RPM and turn off the key,while flooring the gas pedal.If engine still runs,the injector(s) are stuck open.
Also check for a vacuum leak-that will cause the engine to run very rich.
Also may be an open circuit in the temp sensor(computer side).The engine may think it's very cold and richen up the mixture.

Mar 07, 2013 | 1992 Toyota Pickup

1 Answer

I have a 1992 toyota pickup ext cab, 4x4 V6 420 000 km. I have swapped the engine out for a 1994 toyota 4runner V6 220 000km, same identical engine. i replaced the timing, intake seals, oil pan seal,...


Try a hot wire to the distributor. If the engine keeps running then the problem may lie with the ignition circuit wiring. It also might be the ceramic resistor.

Mar 16, 2011 | Toyota Pickup Cars & Trucks

5 Answers

Need to change engines


If you have a 22r carbed then all 22r carbed engines from 1981-1995 will interchange. You may need to use sensor out of your old engine however. The 20r,22r,22re,22ret all have the same mounts and tranny bolt patterns. how ever there are lot of differences. you can swap from a 22r to a 22re but you must also swap the entire vehical wiring harness to do it right. if you have a 3.0L i would keep the same engine. some people have swap to the tacoma 3.6L but that is a expensive swap not exsactly bolt on so to say. If you have a 22re then stay with the 1986-1987 22re because the newer 22re use different computers, electronics ,sensors and more.. Same story with the 22ret. I hoped this helped.

Mar 26, 2009 | 1987 Toyota Pickup

3 Answers

92 Toyota pickup


you need to make sure all of the vaccum lines are on and the one behind the throttle body and also ask youself when was the last time the truck had a good tuneup like a fuel filter,spark plugs,wires and a new drive belt and pvc valve

Feb 08, 2009 | 1992 Toyota Pickup

1 Answer

Antifreeze leak


engine coolant sensor, unscrewed it with an open end wrench but make sure engine is cold you will loose antifreeze but its ok you can add back when you replace sensor. have a nice day put 50-50 antifreeze

Dec 18, 2008 | 1992 Toyota Pickup

1 Answer

87 4Runner 22RE problem


Replace the number one injector; it is sticking open.

Oct 07, 2008 | 1985 Toyota Pickup

1 Answer

1992 Isuzu Rodeo Distributor wires 3.1L engine


Hi,
Isuzu seem to have complicated things by changing engines, firing orders and even direction of rotation! As you can see, they've numbered the cylinders the other way than the 3.2L.

The Firing sequence for the 3.1 (traditional distributor) 6 cylinder is as follows -

d6e5b2a.jpg

If you take the distributor cap off, there should be a "No.1" formed on the inside. Stick a lead on this before you put the cap back on and go from there.
As leads are different lengths, you may have to swap a few to find the best fit.

I think 2 of them will look out of place - but that's the way it's designed. Just make use of clips for holding them neatly.

Thanks for using Fixya.









Jul 05, 2008 | 1992 Isuzu Rodeo

Not finding what you are looking for?
1992 Toyota Pickup Logo

Related Topics:

210 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8743 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...