Question about 1996 Ford Windstar

1 Answer

Problem with my,96 windstar it's always blowing heat even when a/c is on.a/c has full charge no leak, i've check blend acculeter,fuess,thermo/switch.any advise any one.thanks...

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 216 Answers

Had you hear the a/c compressor kick on?

Posted on Jun 22, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Heater doesn't get hot on 96 chevy truck. Blows good, just cold. Replaced thermostat, flushed radiator. Any ideas?


Air Temperature Control Blend Door Failure No Heat or no AC (dependes on where door sticks)

In all modern cars there is a tiny DC electric motor driven gear drive that moves a plastic door that blends heated and cooled air from the AC and the heater core, this is called (interestedly enough) the air temperature control blend door actuator. The motor that moves this door fails because the door starts sticking from warping, most common complaint is no heat but it can be no AC as well. To replace these parts (blend door and blend door actuator) you must remove the entire dash from the car. Always have this problem confirmed by a dealer or qualified repair shop as it is a very expensive repair.

Other causes of no heat in the cabin are engine thermostats that are stuck open (engine runs cold) or air bubbles in the cooling system.

Dec 06, 2012 | Cars & Trucks

1 Answer

The blower on my 98 windstar blows hot air when in a/c mode and never gets cold. Tried charging it but It was already full.


the most common cause would be a slow leak in the system, and Freon might have been lost, causing warm air to blow Simply recharging an A/C system never fixes anything,so it needs to be checked for leaks

Jul 14, 2010 | 1998 Ford Windstar

2 Answers

1999 ford windstar no heat blows only cold already replaced blend door. It was making the knocking noise when the a/c was on.


fill up the rad with coolant then check heat again or you might need a new radiator..check for leaks.
Fill reservoir up, look for any puddles.
maybe the heater core might be shot as well.

Sep 30, 2009 | 1999 Ford Windstar

2 Answers

More Air Conditioning issues!!


have 2001 ford windstar front ac blows hot but rear blows cold any idea what problem is and how to fix it?

May 27, 2009 | 2001 Ford Windstar

2 Answers

Problem: Ford Windstar SE, 3.8L V6, 1999, front seat heat/defrost is alway cold with engine warm and heater turned on. Symptoms: 1) When (engine is warm and) front seat heat temp slider is moved from...


I would think the door you hear flapping is the door that controls the airflow across the heater coil - and the fan keeps blowing the door closed, preventing the airflow from going across the heating coil. I don't know whether this vehicle is vacum controlled or cable controlled - so either it's a disconnected cable, or a leaking vacum line.

Mar 10, 2009 | 1997 Ford Windstar

3 Answers

No Heat! 1999 chevy blzr lt 4.3 radiator full, blower works,


Your '99 Blazer does not have a water valve. Just a temp. blend door. In other words, hot water should be flowing through the core at all times. Like the other techs said, make sure you are getting the whole system full of coolant. You might even try disconnecting one hose, and pouring water into the heater core itself. On most of these year models, if you listen, you can hear the rush of water through the core when you lightly rev the eng. I have replaced 3 heater cores just last year on '96-'99 Blazers. They clog easily. YOu can blow or flow water through them, but if they don't flow freely, I mean without any restriction whatsoever, they will not get as hot as you want. The thing is tiny!

Here's an easy test: Run engine until temp gauge reaches normal: around 180-200 degrees. Reach back to the firewall and grab both heater core hoses. Are they both about the same temp. and HOT? THey should be. If one is much warmer than the other. You are clogged enough to suffer in the winter. And from what you said: "Brrrrrr" You are getting poor performance out of your heater.

BE sure to check that the blend door is working. Is it cool when you set temp to cool? Blazers go through way more heater cores than they do blend doors, so I'm betting your core is either empty, or clogged. TaterTodd

Jan 25, 2009 | 1999 Chevrolet Blazer

1 Answer

Heater does not blow hot air on full heat setting


the problem is caused by the motor that operates the air temp blend door motor in the heating ducts, it blends air between AC and heater core tro give desired outlet temp.

Dec 12, 2008 | 2000 Chevrolet Silverado 1500

5 Answers

1999 Ford Windstar 3.8 no heat


If you have a knock or clicking noise behind the radio, it is the blend motor. The blend door is spring loaded and the gears in the blend motor are "stripped". The door is spring loaded so that the door is closed to the heater core. About 2 hours to replace and a lot of bending and stretching. You don't have to remove the dash, but all of the trim, radio, and controls will need to come out.

Nov 12, 2008 | 1999 Ford Windstar

Not finding what you are looking for?
1996 Ford Windstar Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...