Check reverse light circuit, possible switch on transmission or burned-out bulbs. Is there power to the bulb socket when the key is on and trans in reverse? Use a test light to check for power at the connector.
If you need further help, I’m available over the phone at https://www.6ya.com/expert/michael_2496c4f07ad24453
SOURCE: rear brake lights wont work on our 2005 chevy aveo ????
It sounds like you should check for power at brake pedal switch. Hook up a test light to the switch and press the brake pedal. If the light does not go on and you have power in the wires to the switch then the switch should be replaced.
I hope this helps you out
SOURCE: where is the reverse light switch and how do you
It's made into the neutral safety switch. the switch is bolted to the side of the transmission.
SOURCE: Reverse and interior lights out, chevy express van
Fuse block under the hood. Driver's side, under the brake master cylinder. Number 18. TCB#2. Replace the fuse.
There is an under-engineered ground in the reverse circuit. If you back up with the dome lights on, it could blow that fuse. There should be some extra fuses under the cover of the fuse block.
SOURCE: Just need to know what
Hold light means that your aveo is in manual transmission. It will not shift the trans. you need to manually shift. This is to give you added control in slippery conditions
SOURCE: 2008 chevy aveo brake lights won't turn off
CHECK FOR YOUR BRAKE LIGHT SWITCH IT IS LOCATED BEHIND THE BRAKE PEDAL UNDER THE DASH. FOR A TEST DISCONNECT IT AND SEE.
1,571 views
Usually answered in minutes!
×