Question about 2002 Mercury Sable

1 Answer

Just purchased a 2002 Mercury Sable LS. It did not come with a manual or any information on the 5 digit entry code to open the drivers door without a key. How can I find the code?

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 21 Answers

Contact your local dealer and give them the vin

Posted on Jun 20, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where do u find the code for Keyless entry for 2004 Mercury Sable Ls

open the trunk and look on the trunk lid supports for the code from the factory 5 digit

May 06, 2015 | Mercury Cars & Trucks

1 Answer

I dont have the code to open the door without my key on my 2004 lincoln vs

With your owners manual,in the grey folder,is a white card with the factory,door entry code,and instructions to put your own code, in the keyless entry keypad

May 11, 2010 | 2002 Lincoln LS

1 Answer

Codes for keyless entry on a 2001 merc sable

the numbers are on the keyless module in the trunk, it is a paper tag

Jun 01, 2009 | 2001 Mercury Sable

1 Answer

Purchased a used 2006 Mercury Grand Marquis, did not have an original owners manual with factory code card in pack ( ordered an owners manual on line ) my question is how do I program the driver door...

Ok there are 2 ways to retrieve the key-less entry code. First and easiest way is to carry it to a shop that has a scan tool that can read pid data from the driver's door module .They can pull up that pid and display your code right on the screen.
The second and hardest method is to remove the driver's door panel to access the driver's door module and there will be a tag on it with the 5 digit code.
Yes you can program your own code into it however you must have the original code .Input the original code then hit the number 2 button then put in your own 5 digit code.This code will remain until you disconnect the battery or battery goes dead then it reverts back to the original.
You can also go to this website and download your owners manual for free. Just pick owner guide in the left task bar and input your vehicle information.

Mar 09, 2009 | 2006 Mercury Grand Marquis

1 Answer

2002 Sable LS 43,000 miles. Check Engine light on again!

without a fault code its impossible to diagnose. try pep boys or aamco or auto zone they will pull the code for you, usually for free. The code will relate to a sensor or area to be fixed. This will save you money and needless parts . post the code or codes so we can help

Feb 17, 2009 | 2002 Mercury Sable

2 Answers

5 digit code to unlock my 1997 Mercury Sable

Look for a sticker on your trunk hinge but dont worry if its not there. I think that some Ford products had it in the dash compartment. Dont worry we will stay after it till we get it. Check out this site.

Oct 23, 2008 | 1997 Mercury Sable

1 Answer

2003 Mercury Sable, Driver's side remote keyless entry keypad not functioning

Doubt its a fuse. Most likely the key pad has failed and needs to be replaced. On the bright side this is a good problem to have and you have a very reliable car.

Oct 09, 2008 | 2003 Mercury Sable

3 Answers

Entry code om drivers door

The keyless entry module is located in the rear of the vehicle on the driver's side. You will need to partially remove the left rear panel in the cargo area. You will then see the keyless entry module bolted behind a metal reinforcement bar. There is a sticker on the module that has the 5 digit entry code.

May 26, 2008 | 2001 Mercury Mountaineer

Not finding what you are looking for?
2002 Mercury Sable Logo

Related Topics:

287 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts


Level 3 Expert

76109 Answers


Level 3 Expert

5520 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides