Question about Jeep Liberty

Open Question

2008 Jeep Liberty Master Power Switch started smoking

Master Power Switch started smoking after getting soaked by rain while door was opened to get inside jeep.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 137 Answers

SOURCE: Inoperable Power Window 2006 Jeep Liberty

the window regulator needs to be replaced

Posted on Jan 19, 2009

Ad
  • 4 Answers

SOURCE: 2000 jeep cherokee sport fuse diagram

unfortinately the fuse box is under the hood and there is no panel inside the 2000 cherokee or diagram, i had to buy an online manual to find out what fuse went where for my jeep but its not with me. You can just pull the fuses out one at a time and look at them - I know its a pain. It might be your window controll switch - mine is bad as well. It is a common problem for these cherokees especially over 100k, they wear out - I initally thought it was my fuse as well because the lights in the window switch didn't light up anymore - but it is my switch.

Posted on Feb 15, 2009

  • 10865 Answers

SOURCE: The rear tailgate door latch on my 2002 Jeep

Hello. I can assist you. Most likely, your door latch is broken and will need to be replaced. Historically these were metal and rusted due to exposure, soooooo now they are plastic and after a few hundred uses, they break. You can purchase the tailgate handle and replace it yourself but my recommendation is to let the shop do it as it can be a little tricky and often the linkage rods also need to be cleaned and lubricated. The total cost of this repair is generally about $75. Thanks for choosing Fixya!

Posted on Nov 13, 2009

wracefans24
  • 1985 Answers

SOURCE: I have a 2008 Jeep Liberty sport it has 39600 back-up lights not

If you have tested fuses and bulbs with test light,and they check out,
the next step is to put you jeep in reverse with the key on,and use your test light to probe the wires before they enter the bulb sockets for power,if you have power replace sockets,if not check to make sure wires are still connected to back up light switch on trans,if you find no problem there,replace the switch

Posted on Dec 04, 2009

Testimonial: "Thank you for the info on my jeep. I brought it to my mechanic and he could not find where the new switch goes.I will bring it to the dealer."

  • 8 Answers

SOURCE: 2008 Jeep Liberty Won't Start and Sentry Key doesn't work.

check battery connections especially the ground

Posted on Feb 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My rear windows on my 2002 jeep liberty don't work


Make sure they are simply not locked out on the switch. The drivers switch is the master switch. Take a close look at the wiring coming threw the doors to the body, in the black rubber boot

Oct 18, 2015 | 2002 Jeep Liberty

1 Answer

My heat in my 2002jeep liberty blows hot when first cuts on after min or two starts blowing cold how can I fix


This is a possible recall of the heating and air vent door inside HVAC SYSTEM..some of the doors will get stuck,open half way ,or break..Also it could be the actuator that opens the vent door..Sometimes the control switch can also be at fault...Be sure and check dealer for recalls on vent doors....The doors take a day to repair pending door location...This is a chrysler jeep problem..I am a Chrysler/Jeep Tech...

Feb 20, 2015 | 2002 Jeep Liberty

1 Answer

No power.


What color is the smoke?
White,blue or grey?
Please post the color of smoke on reply.

========

Use a bottle of yellow HEET dry gas to remove any moisture problem in the fuel.

Clean / replace air filter.

Top off ATF to MAX level.

Use starting fluid to aid starting.

=========

Jan 16, 2014 | 2005 Jeep Liberty

1 Answer

2008 Jeep Liberty


Possible solution - This happened to me and my battery was dead in my key fob and also I needed an ignition switch because a piece on it was broken which therefore wouldn't turn to start the engine.

Apr 26, 2013 | 2008 Jeep Liberty

1 Answer

2008 jeep liberty interior lights wont shut off


try spraying WD-40 into the door latch mechanism, I did the same for my truck, and it worked. hey!!

Sep 09, 2012 | 2008 Jeep Liberty

1 Answer

Whe shutting the drivers door when it is hot outside start the 2008 jeep liberty and wippers turn on the idiot lights flash and stay on the speedomiter and tack do not work unless you open & close the...


seems like an electrical problem open your door and there should be a black plastic cover like a hose kind of between the door and the car try and pull the black part off and inspect your wires for cuts

Aug 02, 2012 | 2008 Jeep Liberty

1 Answer

I want to reset the oil light on my 2008 jeep liberty !


owners manual - page 226 - Turn the ingnition switch to ON (do not start) and fully depress the accelerator pedal slowly 3 times within 10 seconds and then turn the ignition switch to OFF . **

Sep 20, 2010 | 2008 Jeep Liberty

1 Answer

Water on floor board of Jeep Liberty


It is most likely coming from a dried up or improperly installed window seal at the bottom of the windshield (under the wiper trim)

Take the trim off and caulk yourself - or have the entire seal replaced.

Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.

Jun 24, 2009 | 2002 Jeep Liberty

2 Answers

2008 Jeep Liberty-Dead battery issues w/ a new battery


Unit has a draw somewhere that needs to be addressed. I have found the auto starts sometimes can cause this. But if the draw is through the negative side it could be tough. You should take it to the dealer and have them perform a draw test on the entire vehicle.

Mar 03, 2009 | 2008 Jeep Liberty

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...