Question about 1998 Ford Taurus

1 Answer

Dummy Distrebutor Replacement

How to time and install the dummy distributor on a 1998 ford Taurus.

Posted by on


1 Answer

Cam Sensor

Go to You Tube Video

It is on there

Posted on Apr 23, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the "dummy dinger" on a 1998 Buick park avenue?

I have no idea what you mean by dummy dinger.

Jan 08, 2016 | 1998 Buick Park Avenue

1 Answer

How do I set timing on 3.0 L engine?

mark the balancer with a white paint marker on the TDC groove, there is a small plug over on the d/side inner fender has a small "dummy" plug plugged into it remove that from the wiring harness plug, loosen the distributor hold down bolt, connect the timing light by hooking the battery leads up to the battery and the other clamp over the #1 spark plug wire, crank truck up and squeeze the trigger on the timing light while trying to locate your paint mark on the dampener, then rotate the distributor in either direction to line up that mark with the pointer thats on the timing chain cover per mnf specs if I remember its 10 degrees when you get it there plug that "dummy " plug back in truck should idle up, if so tighten down the hold down bolt disconnect timing light and close the hood youre good to go at that point!

Dec 10, 2014 | 1993 Ford Ranger SuperCab

1 Answer

Can i get a dummy puly to put in place of the ac condenser in 2005 ford taurus wagon

i am not sure but i know that you can get a belt that will be shorter so that you don't have to put the belt on the ac condenser

Jan 13, 2011 | Ford Taurus Cars & Trucks

1 Answer

How to replace u-joints on 93 front wheel drive ford taurus?

there is no such thing as a U-joint on this car, dummy.

Dec 07, 2010 | 1993 Ford Taurus

1 Answer

What is the dummy light that shows a round gear with an! that is right under the abs dummy light on a ford taurus 2000

This is a transmission problem light. You need to have your transmission codes checked. They have to do this at a dealership or a transmission shop

Dec 08, 2009 | 2000 Ford Taurus

1 Answer

My Ford Taurus is dying while driving and ideling!

altenator or battery going out, also check all grounds to motor and body!

Jul 05, 2009 | 1994 Ford Taurus

1 Answer

Replacing camshaft synchronizer, or dummy distributor

no you only change the sensor should be located were the distributor would be located good luck Hope this helps

Feb 10, 2009 | 2000 Ford Explorer

Not finding what you are looking for?
1998 Ford Taurus Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides