Cars & Trucks Logo

Related Topics:

Naya Zospah Posted on Apr 23, 2014

I have a 2001 dodge ram 1500 and every time I shift into reverse it backfires there any solutions

1 Answer

eli winter

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Night Owl:

An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

Corporal:

An expert that hasĀ over 10 points.

  • Contributor 15 Answers
  • Posted on Apr 23, 2014
eli winter
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Night Owl:

An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

Corporal:

An expert that hasĀ over 10 points.

Joined: Jan 26, 2014
Answers
15
Questions
5
Helped
19565
Points
33

Owner's Manual
Saab 9-3 M2006 http://www.vadengmpp.com/owners-manual/saab/2006-Saab-9-3.pdf

5 Related Answers

Anonymous

  • 512 Answers
  • Posted on Jan 03, 2009

SOURCE: 2001 dodge ram 1500 v8 spark plug wire diagram

the firing order is 1 8 4 3 6 5 7 2 clockwise around the cap

Ad

Anonymous

  • 2559 Answers
  • Posted on Jan 20, 2009

SOURCE: 1999 Dodge Ram 1500 2WD won't shift properly

Sounds like the speed sensor on the rear axle.

Anonymous

  • 1 Answer
  • Posted on Feb 08, 2009

SOURCE: Clicking noise in front end 2001 dodge ram 4x4

I have a 2002 Dodge 1500 Ram 4x4, quad cab and had the same problem. In 2wd the clicking was constant, in 4wd it would go away. Also I had no 4wd while in 4wd, found that out after a snow storm. I took my truck to a buddies garage (a Dodge mechanic), he said this is a common problem. He pulled the drivers side wheel, hub, axle and stub axle. The stub axle splines where it goes into the CV joint and and the internal splines in the CV joint were gone. Almost smooth even. The wheel bearing was completely wore out too. I ended up replacing the hub assembly, both the inner and outer axles. Not a cheap fix either I have about $600 repair bill, but it's back on the road now smooth and quite.

Anonymous

  • 14 Answers
  • Posted on Apr 07, 2009

SOURCE: thermostat in 2001 dodge ram 1500

the thermostat is located where the upper radator hose comes off the engine there are two bolts or nuts remove hose and remove housing you will see the thermostat when you do clean old gasket material off block and reverse removal procedure

marionbagget

  • 718 Answers
  • Posted on May 08, 2009

SOURCE: Where is the reverse light switch on a 1999 Dodge Ram 1500 with automatic transmission located?

Look on the gearshift lever. You will have remove the cover to get to it.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

1994 dodge ram 1500 2wd wont shift out of 1st gear.reverse works

take bottom pan off clean out your pressure sensor .. tends to get mini metl flakes caught up in there wich is also a bad sign that your tranny is going out but this will buy you atleast another 2 to 3 months
0helpful
1answer

97 dodge ram 1500 will not shift and just replaced sylinoid and sensor on transmission..what to do now?

why did you change the solenoid and sensor? has a trans service been done? fluid health and levels good? have you pulled any codes ?
0helpful
2answers

I have an 2001 dodge ram 1500 and when i put it in reverse it dies what could be wrong??

Reverse takes 3 times more power, I am sure the IAC idler air control valve is not working.
0helpful
2answers

2001 dodge ram 1500 v8. my truck won't reverse even if i have the shift on reverse. heeelllppp

is your trans oil level good what color is the oil nice clean red or discolored shift linkage bent do all other gears work 1 2 3 n r p
3helpful
1answer

Reverse light switch on 1995 Dodge Ram 1500

switch is just above trans pan and below shift linkage requires a thin (crome 1" socket) to remove
3helpful
1answer

Thermostat in 2001 dodge ram 1500

the thermostat is located where the upper radator hose comes off the engine there are two bolts or nuts remove hose and remove housing you will see the thermostat when you do clean old gasket material off block and reverse removal procedure
0helpful
2answers

2001 dodge ram 4x4

Synchronizer , damaged reverse gear
Not finding what you are looking for?

140 views

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...