Question about 2002 Mazda Protege

Open Question

Code p0420 in mazda protege 1997 - 2002 Mazda Protege

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 160 Answers

SOURCE: what is code P1195 on 97 mazda protege?

That code is for the EGR boost sensor. It has an open or a short in one of the wires.

Posted on Dec 10, 2008

Ad
motor1258
  • 6674 Answers

SOURCE: DTC P0106 mazda protege. code came on, cleared

Check connections etc at MAP sensor. If all good, replace it. Erase codes & retry. How's vehicle running, idling, any black smoke out tailpipe?

Posted on May 12, 2009

  • 32 Answers

SOURCE: obd2 code p0300 on mazda protege 2002

Just had one of these with a maxima, the code is multiple random misfire, when a misfire occurs, to start is do the basics, replace the plugs, check fuel pressure, clean throttle body, and coolant is topped up. also I have seen if the O2 sensor is not working correctly is can cause a misfire, you will need a scan tool to look at what the O2 sensor is doing, o rby back probing the sensor (don't damage the O2 sensor wires). If it wires replace them as well, if it has coils they usually dont give that code if one fails, it will pinpoint that a certain coil if one fals.

Posted on Oct 02, 2009

ZJLimited
  • 17970 Answers

SOURCE: fuse box diagram for 1997 mazda protege

Idont have register, but you can find 2002-present models (Login required).

Hope helped (remember rated this post) Good luck.

Posted on Feb 20, 2010

  • 59 Answers

SOURCE: code po705 mazda protege lx shaking rough start

The Code you refer to is P0705 Transmission Range Sensor Circuit malfunction (PRNDL Input). It is a possiblility that because this code is present, this sensor is malfunctioning. If it is malfunctioning, that means the engine needs to "guess" the value that this sensor is responsible for. In most cases when this happens, the engine will go for a value that ensures the car runs. The engine will not try to run smooth or efficently, it will only try to run. It is my guess that if you have the sensor checked and replaced, the problem might be fixed. Please let me know if this answers your question and please rate my response. Thank you

Posted on Apr 09, 2010

Testimonial: "that is good. where is the trasmission range sensor circuit located "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I replace the alternator belt on 1997 Mazda Protege?


Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem Mazda Protege 1994 1998 Repair Service Manual PDF

Oct 08, 2014 | 1997 Mazda Protege

1 Answer

P0420 p0171


P0420 (emission) possibe o2 sensor, bad catalitic converter, exhaust leak, cool temp sensor, misfire etc...P0171 = too lean (not get enough fuel) poss cause air flow sensor which is normally on the air intake tube this can also cause the other fault. You first need to check the clamps are tight on the air intake tube yu replaced. then spray aerostart around intake tube & listen for change of revs. also listen for any sucking noise around motor (Vacume leak) if think detected spray aerostart around that area to see if revs change.

Jun 25, 2012 | 2000 Mazda Protege

2 Answers

1997 Mazda protege LX 1.5 automatic transmission


You are going to need a transmission shop. Mazdas do not always throw codes. You have an early OBD transmission, which do not send out many codes.

Aug 02, 2009 | 1997 Mazda Protege

1 Answer

I have a 1997 mazda protege CV Shaft Bad?


jerking may be the engine mount rubbers are broken causing motor to rock forward and back under power and braking

Jun 09, 2009 | 1997 Mazda Protege

1 Answer

How to replace the serpentine belt of protege 5 2002, also need the routing diagram


Posted by Asker under 1997 Mazda Protege for their 2002 Mazda Protege 5.
Both are included Below

Click on the following free direct Link. It has the Belt Diagrams for the 1997 Mazda Protege with either the 1.5L DOHC In-Line 4-Cylinder or 1.8L DOHC In-Line 4-Cylinder Engines; along with various engine options (AC/No AC, etc.). Included are Instrucional Diagrams for loosening (for removal) and tightening (for replacement) using the Adjustment and Locking Bolts/Nuts.
http://www.2carpros.com/car_repair_information/year/1997/make/mazda/model/protege/1997_mazda_protege_drive_belt_routing_diagram.htm

Click on the following free direct Link. It has the Belt Diagrams for your 2002 Mazda Protege 5 2.0L DOHC In-Line 4-Cylinder Engine; along with various engine options (AC/No AC, etc.). Included are Instructional Diagrams for loosening (for removal) and tightening (for replacement) using the Adjustment and Locking Bolts/Nuts.
http://www.2carpros.com/car_repair_information/year/2002/make/mazda/model/protege5/2002_mazda_protege5_drive_belt_routing_diagram.htm

Let me know if this helped, or if you have additional information questions. Feel Free to contact me at FixYa.com!

Apr 13, 2009 | 1997 Mazda Protege

1 Answer

What is code P1195 on 97 mazda protege?


That code is for the EGR boost sensor. It has an open or a short in one of the wires.

Dec 10, 2008 | 1997 Mazda Protege

1 Answer

Readiness monitor codes for a 1997 mazda protege 1.5 dohc


i got a 1997 madza protege 1.5L and i was wondering if i could fit a 2003 madza 3 2.0L engine into it cuz i need more power can someone answer this for me plz asap???

Aug 01, 2008 | 1997 Mazda Protege

Not finding what you are looking for?
2002 Mazda Protege Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...