Question about Cars & Trucks

1 Answer

What thing not lined up right ? - Cars & Trucks

Posted by on

1 Answer

What thing ?

Posted on Apr 23, 2014

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do you change a feul line

Hello. The best thing to do is go to you mechanic and have them change it. Better be safe then sorry, the mechanics have the right tools to use for the fuel lines. Good Luck.

Jun 17, 2014 | 2004 Chevrolet Cavalier

1 Answer

How do i replace the fuel lines on a 2001 yukon xl

most parts stores dont sell metal fuel lines that long.. you can use metal brake lines though(same thing) these are different diameters so you need to take samples in to insure the right sizes are given to you..make sure to get longer than you measure by at least one foot measure carefully..

Jan 01, 2014 | 2001 GMC Yukon XL

1 Answer

No fluid to right front brake 1998 toyota sienna

Remove the line from the caliper and have someone press the brake pedal lightly. (Be carefull not to let any fluid get on vehicle paint it will damage it.) If fluid comes out then the caliper is frozen and a new will be needed. If u do not get any fluid then the brake line is probably collapsed inside. You may get some fluid to drain with the line loose and no pressure applied to pedal. Then when you depress the pedal the fluid stops. If this occurs the line is collapsed inside and blocking flow when placed under pressure. In that case a new line will be needed. The only other thing I can think of at the moment would be a pinched metal line somewhere on the vehicle, however, that is unlikely.

Mar 31, 2013 | 1998 Toyota Sienna

2 Answers

When pushing the brake the truck steering wheel turn to the right

get the brakes checked , one side may not be working, also check steering arms ball joints and wheel bearings

Dec 18, 2010 | 1991 Dodge Ram 150

1 Answer

Replacing water pump

The water pump to the 5SFE 2.2L 4cylinder in your car is on the engine's left side (looking at it from right in front. To find it is simple. Just look for the coolant lines leading from the radiator. One to your right that's easy to see and touch, if you look down, to your bottom left, there's another big line and if you follow that one, you'll see it leads right to the water pump's inlet.
buy a repair manual,because you have to take a few things off to replace the water pump including the timing belt,which should also be replaced.gmjim

May 28, 2010 | 1991 Toyota Camry

1 Answer

Set timing mazda mpv 1993 3litre 6v

It will be the same as most other motors. Disconnect the belt from the harmonic balancer and turn it til you see a mark (it will be a divit or lines) and line it up with the ones that are right above it. When you do this it will be 50/50 shot that the number one piston is top dead center. There should be the number of the pistons on the intake. Or you can call auto parts store and get the firing order. One more thing that you need to check is that the rotor under the distributor is pointing at the plug wire that goes to the number one piston. Those three things all lined up will do it.

Apr 20, 2010 | 1993 Mazda MPV

1 Answer

Timing belt broke, need to know how to line up belt on gears on a 2000 mercury villager 3.3 v-6?

look closely at cam, there will be a small triangle some where on the gear, then there will be a notch somewhere on the casing, line those two points up and on the crank same thing exept instead of a notch on the casing there will be a mark on the motor, just remember the crank turns twice to each cam spin so it can be tricking getting things just right

Mar 19, 2010 | 2000 Mercury Villager

1 Answer

Need to know where the brake lines are and what they look like

Open the engine compartment. To the right is a big black drum with a thing extending out with steel lines coming off. This is the master cylinder and the lines coming out are the brake lines. They branch off to each wheel.

At the front wheels the steel lines couple with rubber ones that attach to the calipers and allow the wheels to turn.

At the rear if you have caliper and four wheel **** brakes there will be another set of rubber lines, but if you have drums, the steel lines fit into the wheel cylinders.

Hope this helps.

Aug 21, 2009 | 1997 Chevrolet Astro

1 Answer

Fuel Line Leak

Easiest way is just wrap a rag around or sometimes there is a bleeder like a tire has on the fuel rail. Now the only things that can be leaking is the Fuel Rail or The Injectors Orings or the Fuel Supply Line.
Hope this helps

Jul 20, 2009 | 1994 Oldsmobile 88

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides