Question about 2007 Jeep Patriot Sport

1 Answer

Head lights and signal and wipers stopped working

My headlights, signals and wipers stopped working

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 3 Answers

First, Check the fuses

Posted on Apr 22, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: Electrical - Clock/Radio, Signal lights, power seats interior lights

The Vehicle information center has two fused inputs. Fuses are #20 and #6, located on the kick area for the accompanying occupant.

Posted on Aug 11, 2008

sparky1500
  • 1066 Answers

SOURCE: head lights not working

check your relays, they are like big fuses in your engine compartment, if your low beam and high beam relays are the same model, switch them and see if this enables low beams and disables the high beams. if it not the relays, or fuses, then it is probably your wiring harness, an expensive repair.

Posted on Nov 28, 2008

  • 88 Answers

SOURCE: 98 jeep wrangler headlights wont turn on

I would check your headlight relay switch that is located in your steering colum

Posted on May 19, 2009

  • 206 Answers

SOURCE: '87 Cherokee no horn, turn signals, brake lights, wipers, blower

Pull the fuses and check the socket for power on the things that don't work. If there is no power at the fuse box there is a good change the stater igintion switch is toast. it is located on top of the steering colunm under the dash.usally less then 20 bucks All that you mentioned get power from this switch that goes to the fuse panel when you turn the key on

Posted on Aug 01, 2009

pippall
  • 1486 Answers

SOURCE: Jeep Wrangler 2006-Front turn signal/yellow light doesn't work.

Check the ground wires at the lights are clean and tight.Its a ground problem you have.

Posted on Aug 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why don't the headlights, turn signals, and wipers work?


Check fuses. Replace the turn signal switch for the head lights. If the wiper fuse is good, Replace the turn signal switch first, then go after the wiper motor. Both run threw the turn signal switch.

Apr 03, 2015 | 1998 Volkswagen Beetle

1 Answer

1994 GMC 2500 pickup with wiper/turn signal/headlight problem.


sounds like you have rats in your dash,or someone has been doing some rewiring,there has to be wires shorted together wired together

Jan 10, 2013 | 1994 GMC Jimmy

1 Answer

Headlights and turn signals do not work. Wipers stay on.


I'm going to say you blew a major fuse or fuseable link wire you have not found yet.
The wipers need power from a battery source to stop, the headlights probably are on a battery circuit too. The turn signals would go thru the key switch but the hazard flashers would be also be direct battery.
You may need a wiring diagram (book) to find all of the fuses and circuits.

Jul 01, 2012 | Nissan Pickup Cars & Trucks

1 Answer

Fuses panel described in English


Hope this helps your out. I know the diagram and locator is a bit blurry but hopefully it gets what you need.
Drivers kick panel:
Front wiper 20A - Front wiper system Cigar 15A- Cigarette lighter Audio 10A- Audio, remote control mirror Air Bag 10A -Air bag diagnostics Stop lights- 15A -Rear brake light, high mounted stop light ECU B+ 10A - Shift lock actuator, transaxle controle module, radio, engine control module Room 10A - Interior light, clock, ignition key reminder, rear cargo area light switch ABS 10A- Anti lock brake system control unit ECU IG1 10A - Transaxle control module, shift lock actuator, ABS control unit, DRL unit Meter 10A - Instrument panel, back-up switch, electronics time control module, inhibit switch Turn signal 10A- Hazard switch ,front and rear turn lights, turn indicator IGN1 20A - Ignition switch ABS 30A- ABS pump motor TNS 30A- Tail light, license plate light COOL/FAN 30A- Cooling fan Cond/Fan 20A- A/C condenser fan Starter 15A- Start signal , Fuel pump Blower 25A- Blower Motor SR/ACC 10A - Ignition switch Hazard 15A - Hazard and turn signal light D/Lock 25A- Door locks ABS 30A - Anti lock brake system control P/W RH 20A- Power window motor right hand P/W LH 20A- Power window motor left hand IGN2 25A- Ignition Switch
Engine compartment :
Head 25A- headlights IG 2 30A- Ignition switch IG coil 15A -Ignition coil, condenser,generator IC regulator, diagnostic connector. O2 down 10A- Rear O2 sensor O2 up 10A- Front O2 sensor Fuel pump 10A -Fuel pump unit Injector 10A -Fuel injector ,camshaft positioning sensor, purge solenoid valve, EVAP, IAC actuator, Mass Airflow sensor, EGR stepper motor. fuel pump relay coil, vehicle speed sensor. A/Con 10A - A/C compressor controls, cooling fan BTN 30A- Brake light , high mounted stop light. Tail light LH 10A- License plate light, tail light , rear combo light, instrument panel illumination Tail light RH 10A-License plate light, tail light , rear combo light, instrument panel illumination Head low 15A- Headlight Head Hi 15A-Headlight Horn 15A- Horn jlmacman.png jlmacman_0.png

Inside kick panel jlmacman_1.png

Mar 07, 2011 | 1995 Kia Sephia

1 Answer

I have a 1983 Chevy S10 pickup. With headlights off all gauges work normal. When you pull the headlight switch on all the panel lights except the windshield wiper switch locator light never turn on and all...


take a look at the dash ground wire located next to the right of ebrake release handle. if the bole holding the ground wire is loose, which was quite common it will cause all kinds of feed back problems, like described in the comments section to your question.

Dec 11, 2010 | 1983 Chevrolet S-10

1 Answer

1997 dodge caravan se 6cyl 3.3


I think you need to replace the Body Control Module (BCM), My newly replaced BCM (used) fixed my wiper problem but created a new problem which the left turn signal is not working now. Time to sell the van.

Jun 18, 2009 | 1997 Dodge Caravan

1 Answer

Driver's headlight is dim; wipers only work if headlight is off


Sounds like the jolt from the barrier has caused a bad ground to occur. Look for a bad ground wire around the left headlamp in or around the headlight bucket.
Tighten or replace the bad ground wire. A poor contact will cause the headlight to light dimly.

Mar 03, 2009 | 2008 Ford Focus SE Sedan

Not finding what you are looking for?
2007 Jeep Patriot Sport Logo

112 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...