Question about Chrysler Voyager

1 Answer

Engine management light came on, then went off while it was on it felt like it wasn't change lng gear properly and the miles per gallon has dropped to around 20mpg.

Posted by on

  • scottrob71 Apr 28, 2014

    I would take it into your Chrysler dealer because it being a 2014 everything should be under warranty. They will probably hook it up to the diagnostics computer and pull the error codes from it. that will tell them better what is going on. I would say that being so new anything that goes wrong should be covered under warranty. it sounds like a glitch in the computer that corrected its self but get it checked anyways. An afternoon now could save you thousands down the road. Oh and don't take it to a Ford dealer as the other person said .... it is not a Ford it is a Chrysler so take it to a Dodge/Chrysler dealer. Preferably take it to the dealer where you bought it. Even if you didn't buy it from a dealer it still should/could be under warranty.

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

  • Chrysler Expert
  • 287 Answers

Have it scanned for a fault it may have stored one for the trans.When the light was on that is when a failure was happening,light off may have stored it when it started to work again.

Posted on Apr 23, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
ginko
  • 19396 Answers

SOURCE: i have a kia mentor

First thing to check is the transmission fluid, if the problem does not go replacing the fluid, then on a manual transmission you need to replace the transmission.
On an automatic transmission can be a problem with the control module or with a defective sensor.

Posted on Sep 05, 2008

  • 39 Answers

SOURCE: 1991 cadillac deville .

did this happen overnight

Posted on Sep 22, 2008

  • 1 Answer

SOURCE: Ford Fusion 04 Engine Management Light

I had a 2002 model 1.4 Fiesta, same problem Engine management light or ECA, electronic accelaration Control (EAC), it needs a ford dealer to do a computer diagnostic, most likely that it will need replaced.

Mt friend who is a mechanic for ford said that it was a common factory fault and is very common in 1.4 zetec /duratec petrol models.

I now have a 2007 Fusion and was quick to see if this problem had been sorted on this model, and it has!!

Hope this helps!!

Posted on Dec 16, 2008

jasperoni
  • 203 Answers

SOURCE: Ford focus engine management light flashing

loose gas cap

Posted on Jun 01, 2009

  • 148 Answers

SOURCE: 2005 Dodge Neon SXT error code P0700

you have a output speed sensor going out probley the tranny is in lemp mode and is stuck in 2nd gear

Posted on Jul 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Citroen Relay clutch pedal with no pressure stuck to floor position, any help?


Always have the master and slave replaced at the same time the clutch is replaced. Most clutch kits come with a slave. If you see no oil leaks, replace the master. Sometimes a seal or line blows out. Check for oil leaks inside the cabin also.

Jul 25, 2015 | Citroen Cars & Trucks

1 Answer

Sputtering engine while in passing gear


At 150000 miles the plugs start to fail under hard acceleration the higher compression blows out the spark before it ignites the fuel. Random cylinder misfire causes the check engine light to come on. change the plugs!

Jan 14, 2014 | 2008 Ford F-150

1 Answer

WHILE SHIFTING GEARS INTO 5TH GEAR THE PEDAL WENT TO THE FLOOR AND FELT LIKE THE CABLE MAY HAVE BROKE. THE GEARS WOULDNT SHIFT WHILE THE CAR WAS RUNNING


IF you have a cable actuated clutch then replace the cable complete. The gears will not change because there will be load on the teeth while the engine is running making changing very hard.

Aug 31, 2013 | 1998 Dodge Neon

1 Answer

Just bought a2001 Escape, looked good with 88k mileage, drove it home 100 miles, felt an occassional bucking/missing in the engine while driving, next day the engine light went on with the oil can...


Sounds like a problem with your catalytic converter or possibly just an o2 sensor. If it is a cat problem I would make sure to have them address it b4 your warranty is up as they are typically very expensive!

Jan 15, 2011 | 2001 Ford Escape

1 Answer

I have a 2002 bmw 745 LI and my check engine went


TAKE IT TO A GOOD MECHANIC! PROBABLY A SHIFT MODULE ON YOUR TRANSMISSION. GOOD LUCK!

Jun 08, 2009 | 2002 BMW 7 Series

1 Answer

Car won't go into gear properly


it could be a few things bent shifting fork or first gear is out reverse runs off an idler that is conected to first gear.

Jun 05, 2009 | 1999 Nissan Altima

1 Answer

Nissan 1999 Altima won't go into gear properly


howdy,you need a clutch..thats for sure,101%

Jun 05, 2009 | 1999 Nissan Altima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...