Question about 2005 Dodge Grand Caravan
Posted by Anonymous on
Tips for a great answer:
Oct 06, 2017 | Cars & Trucks
Feb 20, 2017 | Pontiac Cars & Trucks
Dec 10, 2016 | 2006 Hummer H3
Dec 04, 2016 | Cars & Trucks
Nov 14, 2016 | 1994 Lincoln Town Car
Body control module (BCM)
Wiper 1 relay
Wiper 2 relay
Windshield wiper motor
Windshield washer pump
Windshield washer nozzles
Windshield washer solvent container
Windshield wiper arm and blade assemblies
Windshield wiper transmission
WIPER/SW 10A fuse
WIPER 25A fuse
The body control module (BCM) controls the wiper motor based on input from the windshield wiper washer switch. The BCM monitors the wiper washer switch through three separate signal circuits and a ground circuit. The windshield wiper switch high signal circuit is used to determine high speed wiper operation, the windshield wiper switch low signal is used to determine low speed, intermittent, and mist operation through the use of a resistor ladder, and windshield washer switch signal circuit is used to determine washer operation. The windshield wiper motor park operation is controlled by the BCM. The BCM recieves an input from the park switch to determine wiper blade position. When the wiper blades are at the bottom of the windshield glass in park position the wiper park switch will open and the circuit will be pulled up to B+ by the BCM. The park signal will be pulled to ground by the wiper motor park switch while the wiper blades are not in the park position.
The BCM controls the windshield wiper motor through two output controls, controlling two relays which determine the desired wiper speed, high or low
Diagnostic Trouble Codes (DTCs)
The body control module (BCM) monitors the voltage on the windshield wiper switch signal 2 circuit for diagnostic purposes. If the circuit is shorted to voltage while the driver is commanded OFF, the BCM will store DTC B3715. If the circuit is shorted to ground while the driver is commanded ON, the BCM will store DTC B3715. Refer to DTC B3715.
It would be best to have a factory scan tool to diagnose this problem . it would make it easier anyway .
Dec 05, 2015 | Cars & Trucks
can be faulty wiper motor or blown wiper control fuse.
you hear any kind of noise when you starter the wiper function. If yes then
fuse is ok, but issue is wiper motor.
no movement at all and no noise then its blown fuse or shorted/loose wiper
control wiring: -----
complete troubleshooting i suggest you few helpful links with accurate
the link below: -------
1993 Ford F350 wipers not working?
How to Replace a Windshield Wiper Motor
Wipers not working, but hear relay click on Lincoln LS?
Car windshield wiper gets power for movement and stops?
How does cars Windshield Wiper System Works
1997 Honda Protege: Replace Wiper Transmission?
Windshield wiper fluid container leaking?
Where is wiper fuse located on1993 chevrolet suburban
2002 Toyota Sienna: Wipers and Passenger side Power window
Complete wiper components replacing details for Acura Car
These details will help.
Nov 29, 2012 | 2003 Chevrolet Cavalier
Jan 04, 2010 | 1983 Ford Ranger
May 27, 2009 | 1994 Ford Mustang
25 people viewed this question
Usually answered in minutes!