Question about 1999 Jeep Wrangler

2 Answers

My 2003 jeep wrangler AC/heat fan doesn't blow any air out.

Before the blower quit working, only the highest setting blew out air. Now nothing is blowing out at all. After research, this problem seems to be the blower motor or resistor, although I am not sure which one. Is this expensive? Sounds like a lot of jeeps have this problem.

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 986 Answers

You can test both of them once you have it apart. I have given you instruction below. Please follow them as injury could result.


REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

CAUTION: Stay clear of the blower motor and resistor block (Hot). Do not operate the blower motor with the resistor block removed.

Disconnect and isolate the battery negative cable.
Remove the glove box from the instrument panel (Refer to 23 - BODY/INSTRUMENT PANEL/GLOVE BOX - REMOVAL).
Pull out the lock on the blower motor resistor wire harness connector to unlock the connector latch (Blower Motor Resistor Block- Typical).
Depress the latch on the blower motor resistor wire harness connector and disconnect the connector from the resistor.
Remove the two screws that secure the blower motor resistor block to the HVAC housing.
Remove the resistor block from the HVAC housing.

Posted on Jun 20, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Resistor $ 47.0 and blow motor $ 160.00 plus labor if u can not do it yourself.

Posted on Sep 26, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

The ac quit working...no fan, no air. The 30amp


check the ac blower transistor under passenger side of dash behind the blower motor. on my 2003 compressor would not cut on , front blower only operated on high an blew hot air, rear blew on all speed but only hot air. $58.00 at dealer plus tax. 15 minute fix. there is a video on youtube that documents the process. just fixed today

Jul 05, 2010 | 2006 Honda Odyssey

1 Answer

'00 Jeep Wrangler with no heat and AC not blowing


Ok, if you are trying to use your AC and its not turning on, odds are your refrigerant levels are low, the system will not turn on when low fluid levels are present so the system doesnt burn up the compressor.

If your blower motor is not operating, you may have a fuse blown that needs to be replaced, or the control chip that plugs into the blower motor (for fan speed settings) has burned up (easy fix).

If your climate control is not throwing out heat when you change the settings to hot, you have a leaky vaccume line and the vaccume pressure is not strong enough to open or close (depending on setting) your blender box. Although typically when a vaccume line springs a leak you will have issues with your selector switch as well (defrost, vent, floor)

Also pay attention to your temp gauge to make sure the thermostat is operating properly, and the engine is not over heating ro getting excessivly hot! If it is, then you need to replace the thermostat ($8 part)
and go from there. Also you should check your heater core, if it gets clogged or has restricted coolant flow, your system wont have the heat it normally did (if any) when it worked properly.

This is just a quick summery of the area's you should be looking into for the problems you are having! thanks for using Fixya.com and good luck, I hope I have helped make resolving your problem alittle easier

Jan 08, 2010 | 2000 Jeep Wrangler

2 Answers

Fan blows fine 3 quarter ways turned up but on jeep wrangler


Sounds like you need a new blower motor,sounds like it has bad bushings which are almost impossible to find,

Dec 05, 2009 | 1998 Jeep Wrangler

1 Answer

Blower quit working


check fuse first, every jeep ive had had the same problem ,its the fan speed resistor,most are located on the heater core /fan housing.NAPA 25.00 PLUS SHIPPING.

Dec 13, 2008 | 2006 Jeep Wrangler

3 Answers

05 jeep wrangler no air/heat when blower is on low


sound like you have a bad blower resister some have a module next to the fan on the passenger side by your feet there is a resister that is inserted in to the blower box or black box that is a module that is inserted that neads to be changed

Nov 21, 2008 | 2005 Jeep Wrangler

1 Answer

Jeep Wrangler 03 A/C stopped working abruptly


This may be the AC compressor cycling switch is defective. It is located in the larger of the 2 AC lines coming from the compressor, it has a wire connector to it with 2-3 wires. To verify this is the issue jumper the connector with a small piece of wire and see if the compressor runs.

Nov 20, 2008 | 2003 Jeep Wrangler

Not finding what you are looking for?
1999 Jeep Wrangler Logo

1,245 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...