Question about 2007 Ford F-350 Super Duty

1 Answer

Ford codes reset

The truck engine light has come on a few times lately and the cleaning cycle for the filter has run quite often,on the latest drive up hill towing a fifth wheeler the cleaning started and then the engine light came on and then the pull over safely light came on and engine stopped. The mechanic tried resetting the codes but the unit still wont start. the codes was over heat in exhaust,please need help we are in New Zealand.

Posted by Anonymous on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Ford Master
  • 78,267 Answers

Sorry this will not get cured over the internet, you need a Ford dealer and good Power Stroke diesel technician.

Posted on Jul 13, 2017


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 2920 Answers

SOURCE: 1993 Ford Tuarus Gl

have the catalytic converter checked

Posted on Sep 02, 2008

  • 78267 Answers

SOURCE: 2000 Ford Expedition wont start

On the engine there is a tube that supplies fuel to the fuel injectors, on that tube there is a valve, like a metal tire valve, this is the fuel pressure test port, you will need a special guage to check the pressure that screws onto that valve, Kragen and other parts stores sell this test kit, it is very inexpensive, about $20.00, but cheaper than having a shop do it for you, if you do the test and you have no pressure while cranking the engine then your fuel pump is bad, the pump is in the gas tank, a big job and dangerous due to chance of fire if you are not cautious.

Posted on Oct 14, 2008

  • 1 Answer

SOURCE: Whole truck sputters shakes when going up a hill

on our 1997 it was a misfire and one of the ignition coils needed replaced.

Posted on Jan 17, 2009

  • 409 Answers

SOURCE: 89 F150 wont run someone please help this is my daily driver, nee

You either have a bad MAP sensor or a bad fuel pressure regulator.

Posted on Feb 15, 2009

  • 1 Answer

SOURCE: 95 ford explorer over drive light flashig shifting

First of all get your tranmission fluid and filter changed not flushed, second of all their is a wire underneath that plugs into the tranny that is held on by a bolt clip, if this wires rubs through and grounds out which it usually does it will take out your over drive and the light will flash, your top speed will be 45 MPH.

Posted on Sep 20, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2005 Ford Freester engine running but will not drive code P1000

P1000 fault code is a misnomer because it is not really a fault code. When this code is flashed in your dash panel, it just shows that the reset cycle of your engine computer is not completed yet. Normally, if you are resetting the code, you would disconnect the battery (-) terminal for 1 minute and reconnect. However, on some engines like Ford, the previous code is not totally erased yet so that this P1000 code will show up.

Nov 08, 2016 | Ford Cars & Trucks

2 Answers

Check Engine Light appeared; diagnostics resulted in PO455 code

If you Googled the code, you would find you
have an Evap System Gross Leak

If the gas cap was just loose the light will go out

The evap monitor only runs every few days,so
you may have to wait & see

I think you need to smoke the system & find the
route cause,vent solenoid,pressure solenoid,etc

Apr 05, 2013 | 2006 Ford F-150

2 Answers

A/c blows warm check engine light flashes 98 mercury

Going to have to start by checking for fault codes.

Oct 10, 2017 | 1998 Mercury Grand Marquis

1 Answer

1999 Ford Contour engine light is on. Engine light came on for second time today. Reset this a few months ago and it seemed to be fine until today. The car seems to run fine at this time. Both times...

A possible culprit could be your O2 sensor (Oxygen sensor in the exhaust manifod or piping). These are usually good for about 80K to 100K miles. When they fail or start to deviate too far from their baseline readings they can cause the check engine light to come on. Driving on the highway at higher speeds would result in higher exhaust temperatures than typically are encountered during in- town driving so this could explain why it only occurs on at higher speeds (which equal higher engine loads of course). You could buy an engine code checker or take it to a shop and have them read the error codes for you to narrow it down and/or confirm my O2 sensor idea.

Nov 03, 2011 | 1999 Ford Contour

2 Answers

I need to get it inspected and everytime i go they say the computer isnt reset from where the engine light was on and i unhookeed the battery. also when i push the gas petal to accelerate from a stop. it...

A vacuum leak will do all that for you, aamco trans will check that light on code in the computer for free.You would be smart to find someone to check your computer for all codes because it will tell you without wasting money on bad advise.

Sep 29, 2010 | 2001 Dodge Caravan

1 Answer

Check engine light came on,had it scanned for trouble code ,code said bad camshaft sensor replaced it light still on what else could it be

you say the light is still on. is the code still present? does it still run the same? how long has it been since replacing the sensor? it might take a few drive cycles for it to clear. sometimes codes just have to be cleared manually using a scan tool. you can try disconnecting the battery negative terminal for 5-10 minutes, but this action may require time for the computer to relearn engine fuel/air parameters which could effect drivability for a short time. but will not cause any harm. you may notice low idle and the like, but no lasting effects. but i would continue to drive it with the light on for 1-2 weeks before i would decide what action to take next. as long as it's running ok, wait and see.

Mar 06, 2010 | 1995 Ford Windstar

1 Answer

2004 ford f350diesle hard starting depress throtle nothing there

Dear dsmalley427,
I think it sounds like a fuel injection problem. You get fuel for a while until the injector backs up and then all of a sudden NO FUEL. The engine quits and the pressure drops and flow returns enough for you to restart. If I were you I would get to a good mechanic and check the fuel injectors.
OR--try adding a fuel additive that would clean the injectors.--Signed jwr

May 10, 2009 | 2004 Ford F350

1 Answer

1999windstar missing prob

check the pcv valve vacum lines for a leak a vacum leak will set 171 174 codes. lift the hood with engine running and listen for a air leak , check all vacum lines if no vacum leaks can be found then clean the mass air flow sensor by spraying carb cleaner directly on it for about 5 seconds. in other words take the air filter cover up and spray down the tube that leads to engine. shine a light down hose first and see if u can see the mass air flow sensor so u can get a direct hit

Jan 13, 2009 | 1999 Ford Windstar

1 Answer

Engine lights permanently on.

Go to your local auto parts store. They will read the code - for free (but they are not allowed to clear the code) and determine what is wrong. Once repaired, you can have the code reread and they should allow you to clear it.

Jan 03, 2009 | 2000 Ford Focus

Not finding what you are looking for?
2007 Ford F-350 Super Duty Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5655 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides