Question about Subaru Forester

1 Answer

1999 subaru foresterwinperworkswashers do not front and back

Posted by Anonymous on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Subaru Expert
  • 322 Answers

OK, there's at least a fuse problem to be investigated. If the rears stopped first, then look at the harness that runs thru a rubber tube from the roof line into the rear hatch. These wires can break with age. It's rather fiddly to fix, but can be done.

If the fronts got slow then stopped, pull the valence panel in front of the windscreen and then the wiper arm assembly. The arm pivots often rust up with age, effectively overloading the motor. It's fixable, but the replacement arm assembly is not unreasonably expensive.
Wiper motors rarely burn out, but is not impossible.

Posted on Feb 24, 2015

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1999 subaru legacy wont start after i hit a dear and why ?


If it was a front end hit it could have set off a switch that shuts down the fuel system. I'm not sure where it is on your car but the owners manual show where it's at. You can just press it and reset it. This is a safety feature.

Jun 18, 2014 | 1999 Subaru Legacy

1 Answer

I know where the sensor 2 is but where is the bank 1 for my 1999 subaru forrester code PO 141 O2 sensor heater bank1 sensor 2?


For 1999 Subaru Truck Forester AWD 2.5L MFI 4cyl the Oxygen Sensor is located under hood, center, rear engine area, mounted on catalytic converter.

zjlimited_1032.jpg

Fig. Oxygen sensor location-Forester 1998-2002 2.5L SOHC engine (click over image for zoom).

Generally, Bank 1 is front and Bank 2 is rear.

Hope helps.

Apr 14, 2011 | 1999 Subaru Forester

1 Answer

1999 Subaru Forester has developed a shake when accelerating, esp. between 20-30 mph. Wheel bearings replaced - didn't help. Tires checked, balanced, etc. - didn't help. Front end allignment - didn't help....


Auto or 5-speed?
Subarus have CV axles in front and back. And a drive shaft from the center differential of the transmission to the back differential.

Yes, it could be the drive shaft or axle. If you turn the car hard left or right do you hear any noises - usually a 'clicking' sound? This is likely a CV axle in front.

Check the fluid in the transmission (Automatic) (info is in the Owner's Manual) to make sure it's full and/or gear oil in the front differential.

If it's an Automatic transmission, the fluid may need changed - NOT FLUSHED - if it has more than 30K miles since last changed.
GL,
TD

Sep 10, 2010 | 1999 Subaru Forester

1 Answer

My 1999 Forester Subaru wheel bearings are bad both rear wheels not to mention the front I just had repaired at Firestone for 600.00 Is it worth the extra money to take the car to Subaru, a 300....


Are you sure that they bearings are really bad, bad tires can also give you a growl noise from the bearings if they are different or worn badly. It should not mater where you take it to have them done, just that they use good quality parts and replace them properly. Hope this helps and have a good day.

Jun 08, 2010 | 1999 Subaru Forester

1 Answer

Flashing check engine light 1999 Subaru


Any time your check engine light is flashing this indicates an engine misfire that has the potential to damage your catalytic conveter. A diagnostic trouble code has been stored in the vehicles onboard computer that will confirm the engine misfire. Continued driving may ruin your very expensive catalytic converter located in your front exhaust pipe.
Good luck, I hope this answers your question.

Mar 27, 2010 | 1999 Subaru Legacy

1 Answer

Water in front blinker 99 subaru outback


After removing housing there are 2 clips top and bottom that release the lens. Make sure and use sealant when reinstalling. Good luck and have a great day.

Jun 27, 2009 | 1999 Subaru Legacy

1 Answer

Subaru impreza


Right on the top of the mass air intake where the air cleaner attaches. It has a small host running toward the front of the engine and two screws to remove it. Try cleaning it before replaceing it.

May 26, 2009 | 1999 Subaru Impreza

1 Answer

!999 Subaru Legacy L. Left blinker blinks rapid


this sounds like a ground issue........ did u replace with new bulbs? not all bad bulbs show" burned " out filiments good luck jimmy

Oct 19, 2008 | 1999 Subaru Legacy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...